Dancover GH82121 Manuel utilisateur

13-05-2015

for

Polytunnel greenhouse

4x10x2,4m

Manual

Safety Advice

Attention

In some countries approval is needed to set up a marquee/tent larger than 75 m2. It is

your responsibility to comply with local rules and regulations and to ensure that the

marquee/tent is assembled correctly.

In case of bad weather conditions, it is your responsibility to ensure the marquee/tent is

safely secured and that the marquee/tent does not cause damage to others.

close to the tent.

The marquee/tent must be safely secured. We recommend you secure your marquee/tent

with straps and pegs as soon as it is assembled.

Make sure to check if the marquee/tent is covered by your home contents

insurance.

Marquees/tents must be evacuated under extreme weather conditions.

In the event of snow always remove snow from the roof of the marquee/tent regularly to

prevent snow from building on the roof as heavy snow can cause the marquee/tent to

collapse.

In the event of rain there is a risk of rain puddles building up on top of the roof of the

marquee/tent. Heavy rain puddles can cause the roof to collapse. It is your responsibility

to ensure rain puddles do not build up. As a precaution, make sure the roof of the

marquee/tent is stretched out properly and adequately over the side frames of the

marquee/tent and remove rain water regularly.

Do not unpack or repack your marquee/tent in freezing temperatures. In case of

temperatures below zero always unpack and repack your marquee/tent indoors to avoid

the risk of cracking parts.

The marquee/tent must be totally dry before you repack and store it to avoid mildew.

Warranty Information

Please visit dancovershop.com for information on warranty.

Please always check our website for the latest safety advice and manuall.

This structure is not tested for snow and wind loads. We always recommend that you

remove snow from the roof.

Part No Length: [cm]

2131

2A 131

3121

4126

5180

680

7120

8114

8A 114

9172

10 90

11 170

16 125

17 122

21 13

22 8

Name of the part

Number [pcs.]

Front one-side bow

Side reversible bow

One-side side bow R

One-side side bow L

Front horizontal connector with coupler

Horizontal connector

Top reversible bow

Front horizontal connector

Post

Corner reinforcement

Bows connector

Vertical connector (door frame)

Door vertical cross bar

Door horizontal cross bar

Top horizontal reinforcement

Top horizontal reinforcement with coupler

Reversible clamp

Middle connector

Door reinforcement

Clamp fi25

Horizontal connector (rolling device)

Corner connector

Horizontal rolling connector (rolling device)

Horizontal connector ø22 middle L= 13

Horizontal connector ø22 end L= 8

Bolt M6x40 + nut

265

Bolt M6x60 + nut

Crank

Hook(holdfast) 6x40 + nut x 2 pcs

Nut M8

Cover is assembled with the help of plastic clips. When

assembling the cover, please cut out the shape of the front

and back wall and rectandular shape for the doors and

attach them to the corresponding construction parts. The

rest of the cover is already precut. The main part should be

placed along the whole tunnel from the top of the front wall

to the top of the end wall. The pieces of cover for the

curtain should be attached to the horizontal connector.

Assembly

Tunnel construction consists of tubular parts, hot-dip galvanised in and out,

postfabricated, which prevents them from corrosion. Assemble tubes according to

the drawing, cut the cover according to the drawing (only the front and the back

wall and doors; the rest is precut), put it on the tunnels construction stretching it

and pin it to the tubular part with the clips. Construction can be easily transported

to another place or reassembled.

Assembly manual – TUNNEL 4,0 x 2,4 x …m

1. All construction parts of the construction correspond to the

specification.

Distance between bows is 1,25m. Depending on the number of bows the length of

the tunnels increases 1,25m with each bow. Please find below the drawing with

tunnel dimensions.

2 Assembly of the front and back wall with door

This is how the front/back wall should be assembled. The door frame and the door

is assembled with the help of reversible clamps (nr 13 in specification).

3 Cover/moscitoe net assembly.

COVER

Cover stretched from the top of the tunnel

must be attached to the cover holding strip.

The rest of the cover must be attached to the

rolling mechanism with clips

Moscitoe net is

attached to the tube

behind the cover

holding strip with (the

help of) clips

Both cover and the

other end of moscitoe

net must be attached

here. The rest of the

cover must be dug

into the ground

Cover which must be dug into

the ground

“Cover, hobby tunnel 4,0x2,4xL (m)”

10,5m 4,5m

2,25m

Cover

he “Main part of the tunnel” piece is extra long on both sides. The extra cover must be dug into the

round to secure the polytunnel greenhouse.

onnect the cover to the frame with the easy clip-on connector system.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Dancover Kit de serre

Dancover

Dancover Polytunnel Greenhouse 3x8m Manuel utilisateur

Dancover

Dancover GH152190 Manuel utilisateur

Dancover

Dancover TITAN Peak 240 5,0 Manuel utilisateur

Dancover

Dancover GH82020 Manuel utilisateur

Dancover

Dancover TITAN Peak 240 4,2 Manuel utilisateur

Dancover

Dancover STRONG 3x4 m Manuel utilisateur

Dancover

Dancover TITAN Classic Manuel utilisateur

Dancover

Dancover ARROW GH120025 Manuel utilisateur

Dancover

Dancover GH152100 Manuel utilisateur

Dancover

Dancover Mini Greenhouse GH152170 Manuel utilisateur

Dancover

Dancover GH152200 Manuel utilisateur

Dancover

Dancover TITAN Arch 280 Manuel utilisateur

Dancover

Dancover Polytunnel Greenhouse 3x6m Manuel utilisateur

Dancover

Dancover TITAN Arch 130 Manuel utilisateur

Dancover

Dancover GH152015 Manuel utilisateur

Dancover

Dancover GH117000 Manuel utilisateur

Dancover

Dancover GH152080 Manuel utilisateur

Dancover

Dancover Louver Wall Manuel utilisateur

Dancover

Dancover TITAN Dome 320 Manuel utilisateur

Dancover

Dancover LOTOS Manuel utilisateur

Dancover

Dancover TITAN Arch 90 Manuel utilisateur

Dancover

Dancover TITAN Classic 480 Series Manuel utilisateur

Dancover

Dancover GH21100 Manuel utilisateur

Dancover

Dancover HGSA1010 Manuel utilisateur

Manuels Kit de serre populaires d'autres marques

ACD PRESTIGE

ACD PRESTIGE MR3 H Manuel utilisateur

Vitavia

Vitavia VA0040-TRP Manuel utilisateur

VegTrug

VegTrug Nursery Manuel utilisateur

Riverstone Networks

Riverstone Networks Monticello 041315V Manuel utilisateur

STC

STC Easy Grow 6x12 Greenhouse Manuel utilisateur

CLIMA POD

CLIMA POD Spirit V7 Series Manuel utilisateur

Vitavia

Vitavia GAIA JUMBO Manuel utilisateur

Palram

Palram Harmony 6'x4' Manuel utilisateur

ClearSpan

ClearSpan Storage Master 104598 Manuel utilisateur

Sproutwell

Sproutwell GRANGE - 5 Manuel utilisateur

ACD

ACD Piccolo 03 Manuel utilisateur

Growhouse

Growhouse Lean To 6 x 8 Manuel utilisateur

Riverstone Networks

Riverstone Networks Grower's 181010V Manuel utilisateur

GrowSpan

GrowSpan 500 Series Manuel utilisateur

Robinsons

Robinsons 5ft Wide LEAN-TO Manuel utilisateur

Botanica

Botanica E Manuel utilisateur

PNI

PNI SP6000 Manuel utilisateur

Hortus

Hortus 211-203 Manuel de programmation