R90 Software
Network settings
Navigate to Settings Þ System config Þ Network settings.
You can set your IP address manually («Static») or obtain it
automatically via DHCP.
To set your IP address manually, please proceed as follows:
1. Check the «Static» option.
2. Enter your IP address and subnet mask.
3. Select «Apply»
↳The device restarts automatically.
3.3.3 Project setup
Amplifier
On the «Amplifier» tab you can set the number of amplifiers and
assign an IP address to each device.
To add an amplifier and set its IP address, please proceed as
follows:
1. Select the left or right arrow next to «No. of amps» to set the
required number of amplifiers according to your project.
2. In the box «IP settings», select an amplifier.
3. Enter the assigned IP address of your amplifier into the
«IP address» field.
4. Select «Apply» to save your settings.
Note: Within the «Network settings» box, the actual IP
settings of your R90, entered within System config
Þ «Network settings», are displayed.
AmpPresets
Before presets can be set on the R90, they must first be created in
R1 or on the amplifier. For more information about creating
AmpPresets, see the amplifier manual which can be downloaded
from the related product page at www.dbaudio.com.
On the «AmpPresets» tab, you can set the number of presets,
assign a name, set predefined or individual buttons, or
backgrounds. In the information box, you can save related data,
e.g. location or zone information that belongs to the preset.
To set presets, please proceed as follows:
1. Set the total number of presets in the «No. of AmpPresets»
field.
2. Select a preset you want to define in the «Select AmpPreset»
field.
3. Add additional information for the preset, e.g. room or area
name.
4. Select a predefined button and background. If you want to
add an individual icon and background, see details below.
5. Select «Apply» to save your settings.
Set static IP address
Amplifier setup
AmpPresets setup
d&b R90 Manual 1.2 en 9
All manuals and user guides at all-guides.com
