Cypress CVX-OPTW Manuel utilisateur

CVX-OPTW_MAN_081216

CVX-OPTW

Wiegand Splitter

Operations Manual

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Part 15 COMPLIANCE

Physical

2.313” x 1.625” x 0.625” -

Temp

Storage(-55˚C to + 150˚C)

Operating(-40˚C to +80˚C)

Humidity

95% (non-condensing)

Power

Input

+5VDC @100mA

Output

Data I/O

Interface

Reader 0- 30VDC

LED - 0 - 30VDC

Analog 0 - 5 VDC

Electrical and Mechanical Speciﬁcations

Cypress Computer Systems, Inc. ⌖Lapeer, MI 48446 ⌖www.cypressintegration.com

The CVX-OPTW is designed to provide isolation between different Wiegand signal

sources.

The CVX-OPTW allows multiple readers and panels to be connected together.

The CVX-OPTW also allows systems with different voltage levels to be electrically

connected together.

The CVX-OPTW may be cascaded to connect additional readers or panels to be

connected.

J1 Connector

•Gnd - Input Ground

•Data 0 In - Wiegand Data Input 5- 24 VDC

•Data 1 In - Wiegand Data Input 5 - 24 VDC

J2 Connector

•5 vdc - Input - regulated 5 vdc @ 30ma

•Pullup +5V - Connection to pullup resistor 1k @ 5VDC

•Data 0 OUT - Open collector Wiegand data output

•Pullup +5V - Connection to pullup resistor 1k @ 5VDC

•Data 1 OUT - Open collector Wiegand data output

•Gnd - Output ground

Notes:

1. Input Ground and Output Ground are electrically isolated.

2. +5VDC (Regulated) is required to operate converter.

Data 1 IN

Ground

Data 0 IN

Data 1 OUT

Data 0 OUT

Pullup +5V

+5 VDC

Ground

Pullup +5V

If voltage levels other than 5 volts are required at the output, then do not connect the

internal pullup resistors. The outputs are now open collectors and will work with voltages

from 5 to 24 VDC. Depending on the system, you may need pullup resistors to the higher

voltage.

Previous versions of the CVX-OPTW had internal pullup resistors connected to the output

ports. These pullup resistors were wired to the +5VDC supply. This newer version provides

the option of connecting the pullup resistors in order to allow connection as a true open

collector output.

With the pullup resistors connected as indicated in the above diagram, the new OPTW is

equivalent to the previous version.

Data 1 IN

Ground

Data 0 IN

Data 1 OUT

Data 0 OUT

+5 VDC

Ground

Data 1 OUT

Data 0 OUT

+5 VDC

Ground

Data 1 IN

Ground

Data 0 IN

CVX-OPTW

Quick Start Guide

1 Reader connected to 2 panels

2 readers connected to 1 panel

Access

Panel 1

Card

Reader

Card

Reader

Access

Panel 1

Access

Panel 2

Card

Reader

GND

D 0

D 1

GND

D 0

D 1

GND

D 0

D 1

5VDC ONLY

V+ GND

Access

Panel 1

Access

Panel 3

Access

Panel 4

Access

Panel 2

Card

Reader

5VDC ONLY

(typical)

1 Reader connected to multiple panels

GND

D 0

D 1

GND

D 0

D 1

GND

D 0

D 1

GND

D 0

D 1

Table des matières

Autres manuels Cypress Convertisseur de média

Cypress

Cypress CP-268S Manuel utilisateur

Cypress

Cypress HTCP-298HW Manuel utilisateur

Cypress

Cypress CSC-1600HD Manuel utilisateur

Cypress

Cypress CVSD-3A Manuel utilisateur

Cypress

Cypress CDL-125 Manuel utilisateur

Cypress

Cypress DCT-9 Manuel utilisateur

Cypress

Cypress DataBender CVX-1300 Manuel utilisateur

Cypress

Cypress CP-264 Manuel utilisateur

Cypress

Cypress S6J3110 Series Mode d'emploi

Cypress

Cypress CLUX-SDI2VS Manuel utilisateur

Cypress

Cypress CM-398DI Manuel utilisateur

Cypress

Cypress CM-1392M Manuel utilisateur

Cypress

Cypress CM-398DI Manuel utilisateur

Cypress

Cypress CP-295NN Manuel utilisateur

Cypress

Cypress CP-260D Manuel utilisateur

Cypress

Cypress CSLUX-300I Manuel utilisateur

Cypress

Cypress CP-1262HE Manuel utilisateur

Cypress

Cypress CV-401D Manuel utilisateur

Cypress

Cypress CP-280H Manuel utilisateur

Cypress

Cypress CCR-2SRGB Manuel utilisateur

Cypress

Cypress CM-398H Manuel utilisateur

Cypress

Cypress ADC-660 Manuel utilisateur

Cypress

Cypress CDM-660 Manuel utilisateur

Cypress

Cypress CHQV-2H Manuel utilisateur

Manuels Convertisseur de média populaires d'autres marques

SoundTraxx

SoundTraxx Blunami BLU-2200 Manuel utilisateur

SPROLINK

SPROLINK VA1 Manuel utilisateur

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manuel utilisateur

Nikon

Nikon AF-S TC-20E III Manuel utilisateur

Axis

Axis AXIS Q7406 Manuel utilisateur

Omega

Omega TAC80B-J Manuel utilisateur

Zoom

Zoom Thunderbolt TAC-2R Manuel utilisateur

OST

OST iConverter 10/100M Manuel utilisateur

Vertiv

Vertiv Netsure Manuel utilisateur

birddog

birddog MINI Manuel utilisateur

Roland

Roland GI-10 Manuel utilisateur

Wallenstein

Wallenstein WX310 Manuel utilisateur

Pace

Pace MSS 200-1 Manuel utilisateur

Solar Converters

Solar Converters EQ 12/24-50 Manuel utilisateur

CYP

CYP EL-7400V Manuel utilisateur

TIE

TIE MIDI 1i1o Manuel utilisateur

DCS

DCS Vivaldi Upsampler Manuel utilisateur

Westermo

Westermo MCW-211 SERIES Manuel utilisateur