Section one
Principal components
(Figs 1)
The first component in the system is the lid knob (1) and is
connected to the lid (2). The upper housing (3) sits on top of
the lower housing (7). The cartridges (4) fit into the holes in
the upper housing (3) and are held in place by the wing nuts
(6) and washers (5). The tap is connected to the lower housing
(7) and is fastened with tap nut (9) and washers (11). The final
component is the non-slip rubber ring (10).
An optional cartridge (fig.2) for fluoride removal can be used in
place of the wing nuts to fasten the top cartridges (4).
Section Two
Assembly Details
1. Remove the filter housings and ceramic candles from
the packaging and check each item against the sketch
shown. This will enable you to assemble the filter with the
minimum of effort. (Please Note: the number of candles
supplied will depend on the filter model purchased. For
instance Filter Model GS2 is supplied with 2 candles and a
GS4 is supplied with 4 candles.
2. Since cleanliness is important ensuretthat contamination
of the filter components does not occur during assembly of the
Water Filter.
Fit KNOB (1) onto the LID (2) and insert SCREW (12)
through the hole in the LID (2) screw on the KNOB (1) by hand
only.
3. Push the sealing WASHER (5) over the threaded section
of the CANDLE (4) MOUNT.
4.Place the CANDLE/S (4) into the holes in the UPPER
SECTION (3). Secure the CANDLE/S into the UPPER SECTION
(3) by screwing the CANDLE WING NUT (6) onto the threaded
candle mount from underneath the upper section.
warning
Push one WASHER (11) over the thread of the TAP (8) and
secure the TAP into the hole provided in the BOTTOM
SECTION (7) with the other WASHER (11) and the NUT (9).
5. Place the UPPER SECTION (complete with candles and LID)
onto the BOTTOM SECTION (7). Fit the NON SLIP/ANTI-CONDENSATION RUBBER RING
(10) on to the lower section.
Ensure the TAP (8) IS IN THE “OFF” position and fill the UPPER SECTION (3) with water.
The water from the upper section will now filter through the ceramic candles into the bottom
section giving you clean drinking water.
Discard the first batch of purified water this will have flushed the cartridges.
ItDoesThe ob.com Ltd, Carlton House, Aylmer Road, London, E11 3AD
E&OE
