7.Exit Installation Test Mode. Momentarily press the
Utility button again, or wait 5 minutes for the mode to
time out.
8.The sensor attempts to join a ZigBee network for
up to 30 seconds. If it is able to join, the Network LED
turns on solid for 10 seconds. If it is unable to join, it
automatically retries every 15 minutes until it succeeds
in joining a network. Note, the sensor will not be able
to join a network until a Wireless Area Controller (WAC)
is commissioned. See LED Operation and Joining the
ZigBee Network.
LED Operation
* A network join can be retriggered manually at any time
using one of the following methods:
•Reset to factory defaults: This causes the device to
leave any network to which it is currently joined.
Following the reset, the device attempts to join a
network. Press and hold the Utility button for
5 seconds. Release the button when the Network
LED begins to flash rapidly.
•Activate device: Press and hold the Utility button
for 2 seconds. If the device is already joined to a
network, the Network LED flashes twice. If the
device is not joined to a network, the Network
LED flashes rapidly and the device will attempt to
join a network.
For more information about configuring the lighting
control network, see the instructions and on-line help
provided with the CSM application.
Joining the Zigbee Network
After successfully completing the Installation Test the
occupancy sensor is ready to communicate with the
Daintree Wireless Area Controller (WAC) and the Daintree
CSM web-based lighting management user interface.
For more information about configuring the lighting
control network, see the instructions and on-line help
provided with the CSM application.
Wireless Occupancy Sensor, Wall
Mount (WOS2-WM)
Green LED: Network
Indicator Description
Rapid flash (12times
per second) for up to 30
seconds
Device is trying to join ZigBee network. If it
fails to join, it will retry after 15 minutes.*
Solid for 10 seconds Device successfully joined a ZigBee
network.
Flashes once Utility button was pressed to initiate
Installation Test Mode.
Flashes twice Utility button was pressed for 2 seconds
and the device is currently joined to a
network.
On for 2 seconds every
30 seconds The batteries are low; replace the
batteries. Also, see alert on CSM.
Red LED: Installation Test
Mode, Motion Description
While unit is in
Installation Test Mode,
Flashes
The red LED flashes each time sensor
detects occupancy. Test mode times out
after 5 minutes.
Off
Normal operation: either not detecting
occupancy, or detected occupancy and
in Off Delay. LED turns on with initial
occupancy.
Daylight Hold-Off
Compartment
Cover (press
arrows then
slide down
to open)
Swivel
Mount
Collar
Wireless Occupancy Sensor, Model: WOS2-WM
Power Supply: Battery ER14505 AA 3.6V (2)
FCC ID:NRH-ZB-Z100B
IC: 8984A-Z100B
ICES/NMB-003CLASS B
FORINDOOR USE ONLY
20120412
IEEE Address: 00137A000000-0000
2
