Culer SOLO Manuel utilisateur
www.culer.com | 1.800.320.6478 | support@culer.comRev. 1.16.17
CULER SOLOTM and DUETTM
Owner’s Manual
Thank you for choosing CULER!
Please read and save instructions prior to use.
R
Made in USA
This page is intentionally left blank.
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 1
Contents ....................................................................
User Tips.....................................................................
Safety .........................................................................
Use & Operation ........................................................
Care ...........................................................................
FAQ ............................................................................
Troubleshooting...........................................................
Warranty ....................................................................
PAGE
1
1
3
4
6
10
11
12
CULER Evaporative Cooler
AC/DC Power Adapter
Quick Step Guide
Owner’s Manual
COOL. EASY. PORTABLE.
Evaporative cooling is the reduction in temperature resulting
from evaporation. When water evaporates, it takes heat from the
immediate air, leaving that air cooler in the process – like a cool,
refreshing breeze off the ocean on a hot day.
Our personal cooling products cool the air by ash-evaporating
water, naturally reducing the temperature of the airow propelled
from the unit. No longer is there a need to cool an entire house
or area to enjoy cool air. CULER’s unique technology allows you
to direct a cool stream of air where you need it most whether
indoors, outdoors, or even on the go.
Table of Contents
Package Contents
User Tips
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 2
Tips for Optimized Personal Cooling:
• The units are designed for portable, personal cooling, unlike
xed AC that uses chemical refrigerants to reduce the ambient
temperature (temperature on the thermostat) of entire homes and
rooms
• Place the unit at least 3 feet (0.9m) from you and do not block the
cool breeze, as the maximum cooling effect is felt directly in the
stream of airow
• Do NOT use in an enclosed space (small room with closed
windows and doors), as this will increase humidity / moisture and
reduce cooling effect
• Do NOT place on or blowing directly at electronics
• The temperature change of the projected airow will vary
depending on the temperature, humidity and other variables in
your location / application
User Tips
Placement
Table
Table
Table
Table
Table
Table
Window
Entry Way
Legend: Recommended
Placement
=
3 feet (0.9m)
GOOD AREAS
• Open room with air
circulation
• On oor near entryway
• Near open window
• On a table
• Directed towards user(s)
CAUTION: DO NOT COVER UNIT WITH FABRIC
RECOMMENDED
CLEARANCE
• At least 3 feet (0.9m)
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 3
Safety
READ AND SAVE THIS MANUAL FOR FUTURE REFERENCE.
WARNING: To reduce the risk of re, electric shock, or injury:
1. Make sure that the power source complies with the electrical
requirements of the product.
2. Do not use this product with damaged or missing lter(s).
3. If the product is not working correctly, has missing parts, has been
dropped, damaged, or dropped in water, call 1.800.320.6478 or
email support@culer.com for evaluation, adjustment, or repair.
4. To protect against electrical shock, do not immerse unit, plug, or cord
in water or spray with liquids.
5. Keep the power cord away from heated surfaces.
6. Do not operate the product if the unit, power cord, or plug is
damaged in any manner.
7. Do not run the cord under any carpets, throw rugs, runners, or
similar coverings.
8. Do not route cord under furniture or appliances, and place cord away
from trafcked area where it will not be tripped over.
9. Do not insert or allow any foreign objects to enter the intake or
exhaust air openings.
10. Do not block or tamper with the atomizing nozzles, as it may reduce
or impede the product’s performance.
11. With the exception of replacing lters, the item is not intended to
be serviced in the eld. Do NOT open the housing in an attempt to
repair the system, as this may alter the performance and void the
warranty.
12. Disconnect the power cord before moving or performing any
maintenance on the product.
13. This product must be grounded. Plug into an appropriate ground fault
circuit interrupter (GFCI) protected outlet that is properly installed
and in accordance with all local codes and ordinances.
14. Do not hang or mount the product on a wall or ceiling.
15. This product should not be used in potentially dangerous conditions,
such as ammable, explosive, or chemically loaded atmospheres.
16. Do not store outside or near hazardous materials.
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 4
Use & Operation
POWER ON
1. Remove tank cap and ll water
tank with 1 gallon of any
drinkable water (tap, hose,
bottled, or distilled) to the
bottom of the ll basket.
NOTE: Do not overll tank. If you see water
in plastic basket, the tank is overlled.
2. Replace cap and tighten until
fully sealed.
NOTE: Unit will not function properly if cap
is not fully tightened.
3. Plug AC/DC power adapter
supply into the power port on
the unit. Plug the three-
pronged plug into an outlet.
4. Press the POWER button at
the top of the unit to turn on
the ash evaporative cooler.
Green light will illuminate.
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 5
NOTE: The CULER ash evaporative cooler will continue to atomize for a short
time while the unit depressurizes. Be sure to turn off product before unplugging.
POWER OFF
5. Press the FAN button to turn
on fan. Adjust air speed by
pressing button: (high, med,
low) Green light will illuminate.
6. Press the COOL button to
activate atomization. Green
light will illuminate.
7. Adjust the cooling port(s) to
the desired positions up-down
and side-to-side.
Press the POWER button to
turn off. Green light will
turn off.
Use & Operation
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 6
Care
CLEANING & STORING
No Water in System
When Storing
Clean the outside with a soft cloth
and mild soap solution.
NOTE: Do NOT store cooler (or
leave unused) with water in the
system for more than 5 days.
Clean water tank (see page 8
for additional instructions) if an
unpleasant odor is detected or
prior to long-term storage.
Prior to storing, clean the water
tank (see pg. 8), ensure water
tank is empty (see pg. 9), and
untighten cap one full turn to the
left to allow for ventilation to the
water tank. Store the cooler in a
clean and dry place.
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 7
Care
CLEANING WATER TANK
1. Completely drain water tank.
(See Empyting Water Tank on
page 9).
3. Add 1 tablespoon (half a
capful) of vinegar to the water
tank.
4. Replace cap and turn until
sealed. Run until the unit is out
of the water and vinegar
solution.
5. The cooler is clean and ready
for continued operation or long-
term storage.
2. Remove tank cap and ll water
tank with half a gallon of any
drinkable water (tap, hose,
bottled, or distilled).
www.culer.com | 1.800.320.6478 | support@culer.com
Rev. 1.16.17 8
Care
EMPTYING WATER TANK
1. Unplug the power supply.
2. Remove the water tank ll cap.
3. Carefully turn the cooler over to
allow water to drain out
4. Replace ll cap and turn until
sealed
5. Plug the cooler in and run the
COOL function until the
atomized water stops
Autres manuels pour SOLO
1
Ce manuel convient aux modèles suivants
1
Table des matières
