Cromptons Spinna Winna Manuel utilisateur
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 1 of 31
•3 PLAYER WITH COIN SHELVES, CHANGER AND NON
CHANGER, MK4 AND MK5 COIN ENTRY SYSTEMS.
•2 PLAYER TICKET PAYOUT WITH COIN SHELVES AND
SLIDING SKILL COIN ENTRY.
4 Wilton Road, Haine Business Park,
Ramsgate, Kent CT12 5HG, United Kingdom
Tel: +44 (0)1843 593335 Fax: +44 (0)1843 588043
www.cromptons.com
E-mail: [email protected]
CROMPTONS
LEISURE INTERNATIONAL LTD
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 2 of 31
Page
1. Introduction…………………………………………………………………. 3
1.1. About warnings, Cautions and Notes………………………………….. 3
1.2. Safety Precautions……………………………………………………… 3
1.3. Standard Abbreviations………………………………………..……….. 4
1.4. How to Contact Cromptons Leisure International Ltd…………………. 4
2. Product Overview…………………………………………………………… 5
2.1. Main Features………………………………………………………….. 5
2.2. Description…………………………………………………………….. 5
3. A Step by Step Guide to Setting up your Spinna Winna……………….… 6
4. Troubleshooting……………………………………………………………... 11
5. Maintenance Tasks………………………………………………………….. 14
5.1. Recommended Daily Routine Maintenance……………………………… 14
5.2. Tilt Mechanism Adjustment……………………………………………… 14
5.3. Removing the Top Sign………………………………………………...… 17
5.4. Replacing a Playfield Florescent Lamp………………………………….. 18
5.5. Replacing a Top Sign Florescent Lamp…………………………………. 19
5.6. Replacing a Playfield Halogen Lamp……………………………………. 20
5.7. Replacing a Halogen Fuse or Mains Supply Fuse………………………. 21
5.8. Replacing a Playfield Drive Motor……………………………………… 22
5.9. Accessing/Removing a CDS Unit……………………………………….. 23
5.10. Accessing a sliding coin flipper unit……………………………… 24
5.11. Refilling tickets…………………………………………………… 25
5.12. Changing the Coin of Play………………………………………….26
6. System Settings, Warnings and Messages………………………………… 27
7. Schematic Wiring Diagrams……………………………………………….. 28
7.1. 3 player, non-feature with changer………………………………………. 28
7.2. 2 player, ticket payout with sliding skill coin entry……………………… 29
© 2003 Cromptons Leisure International Ltd
All Rights Reserved
No part of this publication may be reproduced in any form without the written permission
of Cromptons Leisure Machines Ltd.
Every effort has been made to ensure that the information contained in this manual is
accurate. Cromptons Leisure International Ltd reserves the right to make alterations
without prior notice.
TABLE OF CONTENTS
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 3 of 31
1. INTRODUCTION
This manual is intended to act as a guide to the successful operation of the machine. The
list of contents shows the layout of the manual. Should repair be necessary, an illustrated
parts list names all parts that are normally considered replaceable. The following
conventions are used throughout the manual and it is essential that they are followed for
safety reasons.
WARNING:
•Refers to essential safety precautions which must be taken to avoid a potential
hazard to health.
CAUTION:
•Refers to precautions which must be taken to avoid damage to equipment.
1.1 About Warnings, Cautions and notes.
1.2 Safety Precautions
WARNING:
•Maintenance and repair operations should only be carried out by suitably skilled
and instructed persons.
•Switch off and disconnect the electrical power supply before opening doors/panels
or working on the machine, to avoid electrical shock or mechanical injury.
•To prevent electrical shock, a secure, earthed electrical plug must be installed.
•Use only the specified electrical fuses, as shown in the parts list. Replacement
fuses must match those to be replaced in both fuse type and rating. Where
applicable, the fuse cover must be in place before the machine is switched on.
•To maintain the safety of the machine use only Cromptons or Cromptons-
approved parts. The use of other parts or non-approved modifications to the
machine could be hazardous.
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 4 of 31
CAUTION:
•Many electrical plugs are keyed to fit only one way. Note orientation before
removal.
•When touching any PCB’s or their component parts, take full anti-static
precautions.
•Wait for at least one minute after switching the machine off before switching back
on to enable the capacitors to fully discharge. Failure to do so may result in the
stoppage of the flipper motor.
1.3 Standard abbreviations.
In addition to normal SI units, the following abbreviations are used as standard:
Assy………. Assembly LH………. Left Hand
Coin………. Coin or Token (metal or Plastic) PCB………. Printed Circuit Board
EMC………. Electro Magnetic Compatibility PSU………. Power Supply Unit
LED………. Light Emitting Diode RH………. Right Hand
1.4 How to contact Cromptons Leisure International Ltd.
By Telephone:
•0044 (0)1843 593335 – For Spares and Service.
•0044 (0)1843 593335 – For Sales.
By Fax:
•0044 (0)1843 588043 – For Spares and Service.
•0044 (0)1843 588043 – For Sales.
By Email:
•[email protected] – For Spares
•[email protected] – For Service
•[email protected] – For Sales.
See us on the Web at:
•www.cromptons.com
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 5 of 31
2. PRODUCT OVERVIEW
2.1 Main Features
2.2 Description
A new generation of paddle pusher machines incorporating both paddles and pusher boxes
in one integrated play section.
Players flip up to two coins at a time towards the rear of the cabinet and the three, coin
stacked shelves. These shelves give the player the opportunity to knock off further coins
and give a boost to their winnings.
Available with or without coin validators to the CDS system (version 4 and 5
respectively). Each CDS system is fitted with ‘Flippa Winna’ motors and their ‘motor
saver kit, both featuring ‘rapid fire’ abilities. Alternatively a sliding skill coin entry can be
fitted.
Removable top sign
Hinged playfield doors
with gas strut support
Playfield
CDS coin entry
Cashbox
Payout door
Hinged CDS
access door
Florescent and halogen
playfield lighting
Intelligent tilt system on
payout
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 6 of 31
3. A STEP BY STEP GUIDE TO SETTING UP YOUR SPINNA WINNA
1Locate the access door keys attached to
the outside of the machine as shown. The
keys marked “11” open the glass playfield,
the coin entry and the payout doors. The
keys marked “12” open the cashbox doors.
2Remove the protective cover from the
payout hoppers on all sections if fitted.
UNPACKING
3The mains power cord and playfield
halogen lamps can be found in the R.H.S.
section (section 1) cashbox.
4Site the machine on a level surface away
from extremes of temperature or high
humidity.
INSTALLATION
5Adjust the two stabilizing feet by
turning the shaft using a spanner until the
foot rests on the floor taking the weight
from the front castors.
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 7 of 31
8If your machine is NOT fitted with a
validated coin entry (CDS Mk4) go to step
9 otherwise on each section, open the
hinged CDS doors and remove the CDS
cover to gain access to the validators (refer
to section 5.9 on page 23) and prime each
validator with a coin of play.
For more details on the CDS unit see the
separate manual supplied.
PRIMING THE VALIDATORS (IF FITTED)
7Fit halogen lamps x2 per section. Push-
fit the bulbs into the socket on each
window support bracket as shown
Halogen lamps are supplied unfitted for
safety reasons and can be found in the RHS
section cashbox. Use only the specified
type IE. 24v-20w
INSTALLING THE HALOGEN LAMPS
WARNING
6Ensuring that the mains electrical supply
is earthed and complies with the
specification on the supply voltage label,
Connect the machine to a supply voltage
ELECTRICAL CONNECTION
Take care when handling supply voltage
parts as miss-handling could lead to
electrical shock.
WARNING
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 8 of 31
11If your machine is NOT fitted with a
ticket dispenser go to step 12 otherwise on
each section, open the payout door, fill the
ticket box and prime the ticket dispenser
(refer to section 5.10 on page 24).
TICKET BOX
PAYOUT DOOR
TICKET DISPENSER
FILLING TICKET PAYOUT (IF FITTED)
10Locate the main on/off switch
mounted on the power supply box behind
the payout door of the R.H.S. section
(section 1) and turn the machine on. The
top sign and playfield lamps should light,
the paddles and pusher boxes should move.
SWITCHING ON
9If your machine is NOT fitted with
changers go to step 10 otherwise on each
section, open the payout door and fill the
payout hopper with approx. 500 coins. The
red “change available” light on the changer
panel should light up when the machine is
on.
FILLING THE CHANGERS (IF FITTED)
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 9 of 31
14If your machine is NOT fitted with
shelves at the rear of the playfield go to
step 14 otherwise on each section, open the
glass door and use approx 500 coins to
prime the shelves taking care to spread the
coins on each of the three tiers.
PRIMING THE REAR SHELVES (IF FITTED)
13Prime the triple riser on the front edge
of each playfield by sliding coins into each
of the recesses filling the full length.
Note. Not fitted to all machines.
PRIMING THE FRONT RISER
12An information display is located on
the electronics panel fitted on the LH
bulkhead of section 1 behind the payout
door.
Check this display to ensure that the
machine is operating correctly. The display
should read “CROMPTONS SPINNA
WINNA OK”.
If the machine is not operating correctly
refer to the “TROUBLESHOOTING”
section on page 11.
IS EVERYTHING OK?
Spinna Winna Operators Manual Part No. 990xxx Issue 1
Page 10 of 31
YOUR MACHINE IS NOW SET UP READY FOR USE
17To adjust the sound volume, locate the
switchboard mounted on the electronics
panel on the LHS of section 1 behind the
payout door. Pressing the switches
repeatedly adjusts the volume in
increments
SWITCH 1 TURNS THE SOUND DOWN
SWITCH 2 TURNS THE SOUND UP
ADJUSTING THE VOLUME
16This machine is designed to be used
with merchandise on the playfield but we
would strongly recommend that any
merchandise placed on the playfield is kept
clear of the lose holes on either side.
Obstructions in this area could affect the
earning potential of the machine.
Note. Merchandise should not be used on
ticket payout machines
USING MERCHANDISE
15With the glass doors open and the
machine turned on, spread approx 600
coins evenly over each playfield area and
pusher box. To settle the machine ready for
play it is recommended you feed
approximately 1000 coins through the coin
entries on each section.
PUSHER BOX
FLOATING THE PLAYFIELD
Table des matières
Autres manuels Cromptons Jeu
Manuels Jeu populaires d'autres marques
Fundex Games
Fundex Games Timber Tumble Manuel utilisateur
Go! Gater
Go! Gater 1-1-16453-TP02 Manuel utilisateur
Smoby
Smoby BBF Challenger Manuel utilisateur
Hathaway
Hathaway BG2019SK Manuel utilisateur
Roberto Sport
Roberto Sport INGLESE Manuel utilisateur
Beleduc
Beleduc XXL Witches' Kitchen Manuel utilisateur
Koala Technologies
Koala Technologies KoalaWare Spider Eater Manuel utilisateur
Tomy
Tomy The Magic Oven Manuel utilisateur
Sega
Sega GAME SHOW Manuel utilisateur
Tiger Electronics
Tiger Electronics Last Out 7-584-0 Manuel utilisateur
Fisher-Price
Fisher-Price RollOverRover Manuel utilisateur
Mattel
Mattel World Championship Football Manuel utilisateur