Cretors 1101 Manuel utilisateur

176 MITTEL DRIVE, WOOD DALE, IL 60191

Model 1101 Churro Display

Case Ma ual

100 Volt,

Si gle Phase, 50/60 Hz

120 Volt,

Si gle Phase, 60 Hz

READ and UNDERSTAND these operating and safety

instructions before operating this machine.

1101 Churro Display Case

TABLE OF CONTENTS

I. INTROD CTION ...................................................................................................3

II. SAFETY ALERT SYMBOL ....................................................................................3

III. SAFETY FIRST ........................................................................................................3

IV. P RPOSE OF MAN AL ......................................................................................4

V. NPACKING AND INSTALLATION INSTR CTIONS ................................4

VI. OPERATING INSTR CTIONS ............................................................................4

VII. SANITATION INSTR CTIONS ..........................................................................5

VIII. MAINTENANCE INSTR CTIONS ....................................................................5

REPLACEMENT PARTS LIST ………………………………………………….6

WIRING DIAGRAM …………………………………………………………….7

IV. TRO BLESHOOTING ..........................................................................................8

1101 Churro Display Case

I. INTRODUCTION

This manual contains information regarding your machine. There is nothing, however, more

important than the safety aids and warnings that are found throughout this document. The Safety

Alert Symbol is used to identify topics of primary safety concern wherever they appear.

If, after reviewing this manual, anything is unclear or technical problems are encountered, contact

the dealer from whom you purchased your machine for assistance; and, if there are any additional

questions, feel free to contact our Customer Service Department at 800-840-6166. Always have the

serial number of your machine available to assist in obtaining the correct information.

II. SAFETY ALERT SYMBOL

The symbol shown below is used to call your attention to instructions concerning your personal

safety and the safety of others. Watch this symbol. It points out important safety precautions. It

means "ATTENTION! Become Alert! Your personal safety is involved!" Read the message that

follows and be alert to the risk of personal injury or death.

III. SAFETY FIRST

The information in this manual is essential for the safe installation and maintenance of

your machine. The manual must be read and understood before installing, operating

or maintaining this equipment, or equivalent training must be provided.

"The employer shall instruct each employee in the recognition and avoidance of unsafe

conditions and the regulations applicable to his work environment to control or

eliminate any hazards or other exposure to illness or injury. “ Ref.: 29 CFR 1926.20

(b)(4)(a)(2)

It is understood that safety rules within individual companies vary. If a conflict exists

between the safety procedures contained in this manual and the rules of a using

company, the more stringent rule should take precedence.

1101 Churro Display Case

IV. PURPOSE OF MANUAL

This instruction manual is intended to familiarize owners with the

operation and safety procedures associated with your Churro Display Case.

This manual should be kept available to operating and maintenance

personnel.

V. UNPACKING AND INSTALLATION INSTRUCTIONS

A. Locatio

Choose a location for your case to maximize the ease of operation and maintenance

procedures. Check your local building and fire codes for location restrictions.

While unpacking the display case, carefully inspect it for missing parts or damage during

shipment.

B. Power Supply

Plug unit into a grounded outlet and turn on power switches to test that lights work, rack

rotates and surface heats. The display case requires a 120-volt power supply. se a

GROUNDED 120-VOLT CIRCUIT WITH A 15-AMP BREAKER or FUSE. Do not use an

extension cord.

THIS NIT IS NOT F SED. Be sure to connect it to a grounded 120-volt CIRC IT

WITH A 15-AMP BREAKER OR F SE.

VI. OPERATING INSTRUCTIONS

A. Operati g the Display Case

1. Turn off main power switch to stop rack rotation while loading and unloading

Churros. Load unit with up to five Churros per rack spear for a total of 60 Churros.

DO NOT OVER FILL.

2. Leave both switches On to display Churros and maintain lighting inside the case.

Churros must be cooked as recommended by the manufacturer prior to display.

1101 Churro Display Case

VII. SANITATION INSTRUCTIONS

A clean, attractive display case is safer. Be sure to use cleaning materials that are non-corrosive,

non-abrasive, and food safe. Clean and sanitize with materials appropriate for stainless steel and

aluminum.

Never immerse the unit in water. This appliance should not be cleaned with a water

jet.

Be certain the machine is turned off and power is unplugged before sanitizing this

machine. Failure to do so could result in injury.

A. After unit has been unplugged and allowed time to cool, remove any excess Churros

remaining in the rack arms.

B. To remove rack assembly, loosen the thumb screw located near the top that holds the rack

onto the gear motor shaft (Item 12). Wipe down racks regularly.

NOTE: Be sure the thumb screw lines up with the hole on the shaft during

reattachment this ensure that the rack will not fall off if the thumb screw loosens

during use.

Remi der: Always completely reassemble the display case before operating it.

VIII. MAINTENANCE INSTRUCTIONS

Only qualified personnel should perform diagnostic checks, and, if necessary,

corresponding adjustments and repairs. Maintenance of this device may present an

electrical shock hazard and can cause serious injury or death.

Perform work only on de-energized circuits. Failure to do so may lead to electrical

shock, resulting in personal injury or death.

Periodically check all electrical connections and power cord for signs of wear. Check all

screws and rivets for tightness. Use the wiri g i structio s to aid i troubleshooti g.

THIS NIT IS NOT F SED. Be sure to connect it to a grounded 120-volt CIRC IT

WITH A 15-AMP BREAKER OR F SE.

To remove rack assembly, loosen the thumb screw located near the top that holds the rack

onto the gear motor shaft. NOTE: Be sure the thumb screws line up with the hole on the

shaft during reattachment. This ensures that the rack will not fall off if the thumb screw

loosens during use.

DO NOT remove the grounding prong from the machine’s power cord. This will void

the warranty and could result in electrical shock, injury or even death.

1101 Churro Display Case

IX. TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE ACTION

Will not heat. Loose connection to the heater. 1. Remove bottom cover and check for

loose connection.

2. If no loose connections, check for

continuity in element. If no

continuity, replace element.

Light will not work. Bulb burned out. 1. Plug in machine and/or turn on

switch.

2. Turn off machine and/or turn off

switch.

3. Replace bulb with recommended

replacement bulb.

This manual is filled with timesaving and money-saving information regarding your machine.

There is nothing, however, more important than the safety aids and warnings found throughout

this document. If you have any questions, feel free to contact our Customer Service Department at

800-840-6166. Additional copies of this manual can be obtained from Customer Service.

We make every effort to ship approved orders on the requested ship date. If a delay in shipment is

necessary, you will be notified. Pallet quantities vary by product. Please inquire when placing

order. Most of our products are shippable by PS.

We recommend that you do not sign the delivery receipt until after inspecting the product(s).

Claims can be filed if a shortage is observed, but only when it has been noted on the delivery

receipt. nless it is our error, we will charge a 20% restocking charge on product(s) returned.

CRETORS

176 MITTEL DRIVE

WOOD DALE, IL 60191

PHONE (847)616-6900 , FAX (847) 616-6970

WEB SITE: http://www.cretors.com Email: postmaster@cretors.com

Cretors joi s the i formatio age! Check out our

li ks http://www.twitter.com

http://www.facebook.com/pages/Chicago-IL/C-Cretors-Co/90143449620

Table des matières

Autres manuels Cretors Vitrine

Cretors

Cretors TW Manuel utilisateur

Cretors

Cretors Nacho Alto Manuel utilisateur

Cretors

Cretors 1100 Manuel utilisateur

Manuels Vitrine populaires d'autres marques

Hatco

Hatco FLAV-R-SAVOR FSCD Series Manuel utilisateur

Bonnet Neve

Bonnet Neve SKYLIGHT Manuel utilisateur

True

True TCGD-50 Manuel utilisateur

Tecnodom

Tecnodom EVO SELF Mode d'emploi

Delfield

Delfield F15SC48N Manuel utilisateur

saro

saro FIONA Manuel utilisateur

Hendi

Hendi 233962 Manuel utilisateur

Hoshizaki

Hoshizaki HNC-120BE-L-BLH Manuel utilisateur

Nordcap

Nordcap GENIUS 2 H145-L70 Manuel utilisateur

Omcan

Omcan RS-CN-0140-D Manuel utilisateur

Tecnodom

Tecnodom M Series Mode d'emploi

freor

freor MERCURY Manuel utilisateur

Costan

Costan WHALE 2000 G LG300 Manuel utilisateur

Costan

Costan IMPALA Manuel utilisateur

True Manufacturing Company

True Manufacturing Company TCGD-50 Manuel utilisateur

Bartscher

Bartscher 100L Manuel utilisateur

Steelcase

Steelcase Opus Manuel utilisateur

Hatco

Hatco Glo-Ray GRHD-2P Guide d'application