SPECIFICATION Model No. CRT-531
Date 2010-2-1
Card Dispenser Ver. 3.0
Page 8/13
4.4 Extend CRT Command
Command +
Parameter
Return Comment
“FC”+ Position <06H> Card stop on the spec f ed pos t on ，
，1，2，3，4，5，6} parameter:
0x30,0x34,0x33,0x32,0x31,0x36,0x37｝
“CS”+ Position <06H> Set up Baud rate.(0-5,
indicate 1200BPS-38400BPS)
“IN”+ Parameter <06H> Setting of card inserted from
dispenser mouth:
Parameter
=0x30 Prohibit cards in
=0x31 Allow cards into error card bin
=0x32 Allow cards into card
read/write position (I.e. card stop
location 2)
“SI” SI +Parameter(similar
to RF command returned)
Check the setting status of card
inserted from the dispenser mouth
Note ： （ 1） “4”s the pos t on for card pre-d spense, program w ll execute “pre-d spense”
automat cally(Except press “Reset” keystoke on the d spenser by hand); Execute “FC+4”, no any
react on for th s command, and th s w ll cause unpred ctable damage, so please don’t use th s
command n a hurry.
(2)The operat on of check ng status for “SI” nsert ng card from d spenser mouth s s m lar to
“RF” and “AP”. The parameter of command returned w th 1byte s same as the “IN”parameter.
(3) “IN” s a operat on command for EEPRON. The sett ng status w ll not be affected even f
t s power on or reset, that means the last sett ng s st ll val d when power on. And It s defaulted
that the card s captured to the error card b n when ex-work.
4.5 Specification of photoelectricity sensor and card stop location
4.3.1 Definition of graph
Card Stop Locat on
photoelectr c ty sensor photoelectr c ty sensor preserved
4.5.2 Sketch map of card stop location and photoelectricity sensor
