Coredy E750 Manuel utilisateur
USER MANUAL
V3.02
Coredy E750
Dual Band Mini WiFi Range Extender/AP/Router
Coredy E750 WiFi Range Extender Installation
Guide on Youtube
https://goo.gl/d5hWKb
Chapter 1. Introduction ..................................................
Package Contents ...........................................................
Parts & LED Indicators .................................................
Default Parameters ........................................................
Chapter 2. System & Environment Requirements ...
Chapter 3. Quick Installation ..........................................
Repeater (Range Extender) Mode.............................
Option 1: Setup by Web Browser..........................
Option 2: Setup by WPS..........................................
AP (Access Point) Mode...............................................
Router Mode....................................................................
Chapter 4. Other Settings.................................................
Wireless Settings.............................................................
Login Password Settings..............................................
Firmware Upgrade..........................................................
Save/Reload/Reset Settings........................................
Physical Reset..................................................................
Chapter 5. Troubleshooting & Support .....................
1
1
1
3
4
5
5
5
12
16
21
27
27
28
30
31
32
33
Table of Contents
Chapter 1. Introduction
Table Contents
Package Contents:
Parts & LED Indicators:
Coredy E750 Dual Band Mini WiFi Range Extender x 1
Repeater Quick Installation Guide x 1
RJ-45 Networking Cable x 1
User Manual x 1
Reset Pin x 1
①Power Switch
②WPS Button
③Mode Selector Switch
④Reset Button
⑤WAN/LAN Port
⑥LAN Port
⑦3 x WiFi Signal LED Indicator
⑧WPS LED Indicator
⑨WAN/ LAN LED Indicator
⑩LAN LED Indicator
Power LED Indicator
3 x External Antenna
11
12
Wi-Fi
WPS
WAN/LAN
LAN
POWER
WPS
Repeater
Router
AP
LAN
WAN/LAN
Reset ON OFF
7
8
9
10
11
3
5
6
1
4
2
12
Wi-Fi
WPS
WAN/LAN
LAN
POWER
LAN WAN/LAN
1
2
3
1
Table Contents
LED Indicator
WLAN Signal LED Indicator
POWER
WPS
LAN
WAN/LAN
ON: The Device is power on.
OFF: The Device is power off.
Flashing: WPS connection is established or
WPS signal of another device is expected.
ON: The Ethernet port is connected.
OFF: The Ethernet port is disconnected.
Flashing: Data is Transferring.
WiFi signal is strong
Disconnect
Weak reception signal from Router
Signal stengthis below 25%
Good reception signal from Router
Signal stength: 25% to 50%
Strong reception signal from Router
Signal stength: 50% to 100%
Mode Description
AP/Router
Repeater
ON
ON
ON
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON ON
OFF
Flashing
12 3
Power Switch: It is used for turning the Power On or Off .
WPS Button: It is used for establishing a secure connection
between the E750 and other WPS-capable devices like Router,
Access Point, Cellphone etc.
Reset Button: It is used for restoring the E750 by using Reset Pin.
Mode Selector Switch: It is used for selecting using mode
physically.
2
Default Parameters
Table Contents
WAN/LAN Port: In Router mode, it is used for connecting to your
Modem; In Access Point mode, it is used for receiving network
access from your local network.
LAN Port: For connecting your Ethernet-enabled devices for wired
network access.
URL http://ap.setup/
Default IP 192.168.10.1
Login Name admin
Password admin
2.4GHz SSID Coredy E750_2.4G
5GHz/AC SSID Coredy E750_5G
3
Chapter 2.
System & Environment Requirements
System Requirements
Environment Requirements
The power source like socket should be 110~230 volt.
The WLAN client should support the WPA encryption as
minimum standard.
The WLAN Access Point and the WLAN clients should have
DHCP function (automatic IP address assignment).
The network name (SSID) of the WLAN Router/ Access Point
should be set into “visible”.
Place the E750 in a well-ventilated position far from any heater
or heating vent.
Place the E750 in a location where it can be connected from the
various devices as well as from a power source.
Avoid from strong light (such as sunlight)
Keep at least 2 inches (5 cm) of clear space around the E750
Operating Temperature: 0~40℃(32~104 °F)
Operating Humidity: 10%~90%RH, Non-condensing
Note: To minimize wireless interference, place your Router/
Access Point/ Repeater in an open area, away from other
Bluetooth devices and radioactive devices like cordless phone,
microwave, etc.
Table Contents
Keep away from
5G
2.4G
WiFi
WPS
WAN/LAN
LAN
POWER
WPS
4
Chapter 3. Quick Installation
Table Contents
Power On
1
Switch the E750 to Repeater Mode.Plug the E750 into a
power socket next to your Target Network’s Router with the
Power Switch ON. Wait the Bar 1 of WiFi LED Indicator
flashes.
Note: Please be sure your E750 is restored to factory default
settings before getting start. Put your Target Network’s Router
in an open space area, and keep the E750 next to your Target
Network’s Router during the installation process.
Option 1, Setup by Web Browser
Repeater (Range Extender) Mode ( 2 Options)
Repeater
Router AP
Wi-Fi
WPS
WAN/LAN
LAN
POWER
WPS
Repeater
Router
AP
LAN
WAN/LAN
WiFi
WPS
WAN/LAN
LAN
1
2
3
Coredy E750 WiFi Range Extender
Installation Guide on Youtube:
https://goo.gl/d5hWKb
5
Table Contents
Connect
2
WLAN
Settings
Coredy E750_xxG
WLAN
Your Target Network
ec:26:ca:56:f0:c8 -93
14:cf:92:f:c5:10
CHOOSE A NETWORK...
WPA2 -95
Select and connect the E750 default wireless network name:
Coredy E750_xxG on your Smart Phone or other Mobile
Device such as iPad, Tablet PC.
* No password is required at the first time connecting.
Method 1. Connect by Smart Phone (Recommended)
Click the WiFi icon on the system tray, then select and
connect the E750 default wireless network name: Coredy
E750_xxG.
Make sure your computer’s Ethernet connection is disable
status.
* No password is required at the first time connecting.
Method 2. Connect by Laptop
Coredy E750_2.4G
Not connected
Connections are available
Coredy E750_5G
!
!
!
Information sent over this network
might be visible to others.
Connect automatically Connect
6
Table Contents
Login the Web Management Page
3
WiFi
WPS
WAN/LAN
LAN
POWER
WPS
LAN Port
Connect the E750 to your computer via an Ethernet cable.
* Disable the wireless network if your computer has the
WiFi function.
Method 3. Connect by Wired PC
Launch a Web browser.
Type http://ap.setup/ or 192.168.10.1 in the address field,
and press the Enter button to go to the login page.
Use admin (all lowercase) for both Username and
Password and click Submit to login.
3.1
3.2
3.3
Note: If you could not login the setup page, please restore the
E750 to factory default settings (turn to page 32 for Physical
Reset), or refer to Troubleshooting Q2 on manual for more
solution.
7
Table Contents
Username admin
admin
English
Submit
Password
Language
http://ap.setup/
Enter the Repeater Quick Setup Process
Click the Repeater button in the Wizard field.
4
Connect to the Target Router & Repeat the Network
5
Wizard
Repeater
User-PC
Select your Target Network’s SSID.
Enter exactly the same password/key as your Target Network.
Customize the E750’s wireless network names (SSIDs) or use
the default SSIDs: Coredy E750_xxG_EXT, then click Apply.
* It is recommended to use different network names/SSIDs of
the E750 from your Target Network’s SSID. And the SSID of
AC(5G) should be different from 2.4G’s.
5.1
5.2
5.3
8
Autres manuels pour E750
1
Table des matières
Autres manuels Coredy Extenseur
