Corby Buckingham Manuel utilisateur
CO9010 V15_300823
USE & CARE MANUAL
KETTLE
This manual is for the following models:
Buckingham Lancaster Kensington 0.6L Canterbury 1L Canterbury
KTL0003 KTL0004 LWK-139S KTL0007 KTL0008
www.corbyofwindsor.com
www.firedupcorporation.com/manual
02
SECTION 01
These instructions must be read before use
These instructions are for your safety. Please read
through them thoroughly before use and retain for
future reference. Failure to follow them could cause
injury and/or property damage.
These instructions are also available on our website.
CONTENTS
SECTION 01
Important 03
Cautions 04-05
Introduction 06
SECTION 02
Identification 07
Before use 07
SECTION 03
Use 08
Care 08-09
Specification 10
Contacts 12
03
SECTION 01
IMPORTANT!
This appliance can be used by children aged from 8
years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe
way and if they understand the hazards involved.
Cleaning and user maintenance shall not be made by
children unless they are older than 8 and supervised.
Keep the appliance and its cord out of reach of
children aged less than 8 years.
Children shall not play with the appliance.
Do not attempt to make repairs to the appliance. If the
supply cord becomes damaged, it must be replaced
by the manufacturer, its service agent or a similarly
qualified person in order to avoid any hazards.
When cleaning, or storing away, always pull out the
plug from the socket outlet. Never yank the cord to
disconnect from the outlet, instead grasp the plug and
pull to disconnect. Always allow the appliance to cool
completely before storing away.
SAVE THESE INSTRUCTIONS
CAUTIONS
DO’S
• Check the appliance and the supply cord for
damage regularly.
• Check your mains supply is the same as that indicated
on the product before connecting.
• Ensure that the appliance is used on a firm, flat
surface.
• Always close the lid securely, otherwise the kettle may
not switch off automatically and may eject boiling
water.
• Ensure the kettle is switched off before removing it
from the power base.
• Always remove the kettle from the power base before
filling or pouring.
• Take care when carrying the kettle before and after
boiling water.
• Always pour slowly and do not over tilt the kettle to
avoid splashing.
• Only use the kettle with the base provided.
04
SECTION 01
IMPORTANT SAFETY INSTRUCTIONS
05
SECTION 01
DON’TS
• Never leave the appliance unattended whilst in use.
• The appliance must never be immersed in water or
any other liquid.
• Never under fill the kettle and never use
without water.
• Never overfill the kettle as boiling water may be
ejected.
• WARNING - Never open the lid while the water is
heating.
• Never move the kettle whilst it is in use.
• Never allow the supply cord to touch hot surfaces.
• Never use the appliance if the supply cord or plug is
damaged or if the appliance has been damaged in
any manner.
• Never use this kettle with any power base other than
the one provided.
• Do not touch hot surfaces i.e. body or lid. Use handles
or knobs.
• Do not use the kettle for any other purpose than for
heating water.
• Never use the appliance in a bathroom or near any
source of water.
• Never use the appliance outdoors.
• Do not over-extend the lid.
IDENTIFICATION
INTRODUCTION
Thank you for choosing this appliance. The appliance is
designed to meet the most stringent quality, performance,
and safety requirements. This guide aims to improve your
understanding and appreciation of your new appliance by
providing simple and informative use and care instructions.
This appliance is intended to be used in household and
similar applications such as staff kitchen areas in shops,
offices and other working environments and by clients in
hotels, motels and other residential type environments.
06
SECTION 02
Buckingham / Lancaster
KTL0003 / KTL0004
NOTE: This manual covers multiple products, images are for illustrative purposes only.
Body
Spout
Handle
Switch
Lid
Base
Power indication light
Filter
07
SECTION 02
Kensington
LWK-139S
Body
Spout
Handle
Switch/
Power indication light
Lid
Base
BEFORE USE
1. Remove ALL packaging.
2. Ensure the supply voltage is the same as that indicated on the product.
3. Fill the kettle with water to the MAX capacity and allow to boil. Discard the
water afterwards and rinse with cold water.
Body
Spout
Handle
Switch/
Power indication light
Lid
Open button
Base
0.6L Canterbury / 1L Canterbury
KTL0007 / KTL0008
08
SECTION 02
USE
POSITIONING
1. Keep the kettle, the power base, and the supply cord away from hotplates,
hobs or burners.
2. Place the kettle and its base towards the back of the working surface.
3. Do not allow the mains lead to hang over the edge of the table or work
surface, or anywhere it may be accidentally caught or tripped over.
FILLING
1. Remove the kettle from the power base and fill with water between the MIN
& MAX markings.
IMPORTANT: Do not over-extend the lid.
2. DO NOT OVERFILL OR UNDER-FILL THE KETTLE. If the kettle is overfilled, boiling
water may be ejected. If under-filled, the kettle may run dry while operating.
3. Place the kettle on the base and ensure the lid is firmly closed.
OPERATING THE KETTLE
1. Making sure the kettle switch is in the 'off' position, plug the power base into
the wall socket.
2. After filling the kettle and carefully positioning it on the base (without spilling),
press the kettle switch up. A light should come on to indicate the kettle is ON.
3. When the kettle has completed boiling the water the kettle switch will return
to its original position and the light should go out (indicating the kettle is OFF).
4. To stop the kettle early during use, simply push the kettle switch back into its
original position.
SAFETY DEVICES
1. The kettle is fitted with an ON/OFF switch which automatically switches off
once the water has boiled. Do not hold the ON/OFF switch in the ON `
position.
2. If the kettle is switched ON with too little water, or no water, it is protected
against damage by a safety cut-out which will switch off the power.
If the cut-out operates, disconnect the kettle from the mains supply and
leave to cool down before refilling with cold water.
CARE
Misuse such as overfilling the kettle, allowing excessive scale build-up, and boiling with
water below the MIN mark will reduce the life of the element and product.
CLEANING
1. Turn off and unplug the kettle and power base.
2. To clean make sure the kettle is empty and, before continuing, ensure the
kettle has completely cooled.
3. Using a soft, damp cloth and detergent (if necessary) wipe down the kettle.
4. Make sure all connectors, sockets and switches are kept dry.
5. DO NOT IMMERSE ANY PART OF THE PRODUCT IN WATER OR ANY OTHER
LIQUID.
6. Do not use harsh or abrasive cleaners as these can damage the product
surfaces.
09
SECTION 03
SCALE & DE-SCALING
1. To minimize scale build-up, empty the kettle after every use and do not
leave unused water in the kettle over long periods of time.
2. Regularly de-scale the kettle using a proprietary brand of de-scaler. Follow
the de-scaler instructions thoroughly.
3. After de-scaling, clean the kettle and boil with MAX capacity (empty the
boiled water and rinse with cold water).
THE FILTER
1. The filter is designed to stop scale particles entering drinks after water has
been boiled in the kettle. It is paramount that the filter is kept
clean.
2. Clean the filter whenever there are noticeable deposits left on it.
3. When cleaning the filter, do not touch the filter mesh and ensure your
hands are clean and free of soap or chemicals.
4. Rinse the kettle out to remove any other scale particles.
5. WARNING: Do not use the kettle without the filter as pouring
may become dangerous.
PLUG REPLACEMENT
(for product fitted with BS plug)
This appliance is supplied with a BS1363 3-pin plug fitted with a 13 Amp fuse.
Should the fuse require replacement, it must be replaced with a fuse rated at 13
Amp and approved to BS1362.
In the event the mains plug has to be removed/replaced for any reason, please
note:
The wires in the supply cord on this appliance are coloured in accordance with
the following code:
THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings identifying the terminals in
your plug proceed as follows.
• The green and yellow earth wire must be connected to the terminal in the
plug which is marked with the letter E or with the earth symbol
• The blue wire must be connected to the terminal marked N
• The brown wire must be connected to the terminal marked L
IMPORTANT - any cut off plug should be disposed of safely to prevent
hazard. There is a danger of electric shock if a cut off plug is inserted into a
socket outlet.
E
N
L
Earth
Neutral
Live
Green and Yellow -
Blue -
Brown -
Earth
(GREEN/YELLOW)
Neutral
(BLUE)
Live
(BROWN)
Fuse
(13 Amp)
Cord
Clamp
N
10
SECTION 03
Ce manuel convient aux modèles suivants
9
Table des matières
Autres manuels Corby Bouilloire
