Customer Operating Instructions
The Coonara Grange Classic Gas log space Heater has been designed for a simple and efficient
operation to provide you with a higher heat output than most other heaters in the market. The
optional heat transfer kit means that your heater will provide you with a fully controlled
modulated supply of heat, from a pleasant and steady warmth to the strongest heat output, to
reach almost any corner of your home.
PRE OPERATIONS CHECKS
Prior to operating the heater, ensure that the flue terminal is not obstructed. Furthermore, make
sure there are no combustible objects leaning against, resting on, or within the immediate vicinity
of the unit. Check that the heater main power and gas supply are connected and switched on.
OPERATIN THE HEATER
The heaters are operated by the room thermostat
1 - To ignite your heater press Power Button on the thermostat and the heater will automatically
start the ignition sequence. After approximately 30 seconds of self-checking the heater will
ignite.
2 - The heater will always start in the low heat setting and the heater will warm up for at least
2 minutes before automatically going to the higher flame setting.
3 - The fan will not start until the heater has reached the minimum operating temperature. In the
High heat setting the fan speed will be locked in high and can not be set to medium or low
speed, unless your change the heat setting to medium or low.
Note: n the Maximum heat setting the fan speed will be locked in high and can not be set to
medium or low speed unless you change the heat to a lower setting.
TURNIN THE APPLIANCE OFF
Press power button on thermostat once. The room fan will continue to operate for a short period
while the heater cools down.
Please note:
1 - This appliance cannot be operated without the fan running.
2 - Due to the performance and efficiency of the heater, steam may be noticed coming from the
flue terminal on cool days.
3 - As this appliance has a luminous effect some slight carbon deposition may occur.
4 - During first time firing of this appliance, an odour may be noticed for a short period of time
while the paint cures. It is advisable to leave the windows open during the first few hours of
the very first operation only.
