Conrad 841086 Manuel utilisateur
Car Alarm System „GKA100“
Item No. 841086
Version 02/14
OPERATING INSTRUCTIONS
2
Table of Contents
Page
1. Introduction ...................................................................................................................... 4
2. Intended Use.................................................................................................................... 5
3. Scope of Delivery ............................................................................................................ 5
4. Explanation of Symbols ................................................................................................... 6
5. Safety Information ............................................................................................................ 6
6. General Notes on Rechargeable Batteries .................................................................... 8
7. Product Description ......................................................................................................... 9
8. Connections and LEDs.................................................................................................. 10
8.1 Casing Overview ................................................................................................. 11
8.2 Description of the Connections .......................................................................... 13
8.3 Notes on the Installation ..................................................................................... 17
8.4 Notes on the Electrical Connection .................................................................... 19
9. Commissioning - First Steps ......................................................................................... 20
9.1 Operating Voltage ............................................................................................... 20
9.2 Changing the PIN Code to „1513“ ...................................................................... 20
9.3 SIM Card Insertion .............................................................................................. 21
10. General Descriptions ..................................................................................................... 22
10.1 Product Status and Mode ................................................................................... 22
10.2 Wireless Remote Control ....................................................................................24
10.2.1 Product Control with the Wireless Remote Control ............................. 24
10.2.2 Wireless Remote Control Battery Change ........................................... 25
10.2.3 Coupling of a Remote Control to the Device ........................................ 25
11. Configuration via Text Message ....................................................................................26
11.1 Introduction to the Command Format ................................................................ 26
11.2 Special Commands ............................................................................................. 29
12. Functional Descriptions ................................................................................................. 30
12.1 General Configuration Commands .................................................................... 30
12.1.1 Setting Time and Date (TIME, DATE) ................................................... 30
12.1.2 Administration of Phone Book (TEL, TEL1,…) ..................................... 31
12.1.3 Changing the Device Name (Name) ..................................................... 33
3
Page
12.1.4 Changing the PIN Code (PIN) ............................................................... 34
12.1.5 Changing the Calling Sound and Volume Settings (AUDIO) ............... 34
12.2 In- and Outputs ................................................................................................... 36
12.2.1 Relay Outputs (OUT1, OUT2) ............................................................... 36
12.2.2 Switching Inputs (IN1, IN2).................................................................... 38
12.2.3 Operating Voltage Monitoring (VOLTAGE) ........................................... 40
12.2.4 Vibration Alarm (SHOCK) ...................................................................... 41
12.3 Additional Functions ........................................................................................... 42
12.3.1 Time Limitation Alarm (HOLDALARM) ................................................. 42
12.3.2 Wireless Remote Control and its Function (RFBUTTON) ................... 44
12.3.3 Reaction at Call (INCALL) ..................................................................... 46
12.4 Position Determination........................................................................................ 48
12.4.1 GSM Cell Location (CELL) .................................................................... 48
12.4.2 General GPS Localisation (GPS) ......................................................... 49
12.4.3 Submission of a Web Link with GPS Position (GPSMAP) .................. 50
12.4.4 Automatic Submission (GPS, GPSMAP, Special Function) ................ 51
12.4.5 Energy Savings Mode (GPSSAVE) ...................................................... 52
12.4.6 Programming the „GPSZONE“ .............................................................. 53
12.5 System Functions................................................................................................ 56
12.5.1 Time between Two Alarm Messages (IDLEALARM) ............................ 56
12.5.2 Voltage Hysteresis (HYSVOLT) ............................................................ 58
12.5.3 Resetting to Basic Setting (RESET SETUP) ........................................ 59
13. Restoring Default Settings ............................................................................................ 59
14. Disposal ......................................................................................................................... 60
14.1 Product ................................................................................................................ 60
14.2 Batteries and Rechargeable Batteries ............................................................... 60
15. Maintenance .................................................................................................................. 60
16. Declaration of Conformity (DOC) .................................................................................. 61
17. Fuse Replacement ........................................................................................................ 61
18. Technical Data ............................................................................................................... 62
4
1. Introduction
Dear Customer,
Thank you for purchasing this product.
This product complies with the statutory national and European requirements. To maintain this
status and to ensure safe operation, you as the user must observe these operating instructions!
Read the complete operating instructions before taking the product into
operation; observe all operating notes and safety information.
All company names and product names are trademarks of their respective owners. All rights
reserved.
If there are any technical questions, contact:
Germany: Tel. no.: +49 9604 / 40 88 80
Fax. no.: +49 9604 / 40 88 48
E-mail: [email protected]
Mon. to Thur. 8.00am to 4.30pm, Fri. 8.00am to 2.00pm
Please note:
These operating instructions describe the function and operation at the time of print
(see date on the top right of the title page).
Changes that serve product improvement can be performed at any time. The most
current operating instructions are offered on our websites in the download area for
the respective product on our websites in a timely manner.
5
2. Intended Use
The product serves to monitor an object. For this, sensors like vibration, switching inputs (up
to 32 V/DC) and the GPS signal are available. The product must only be installed in the driver
space, splash-water protection is required.
Two switching relays for 30 V/DC, 2 A can be switched remote-controlledly by consumers or
automatically. Switching the consumer must not influence the safety and operational readiness
of the vehicle.
An external microphone and a speaker permit phone calls. Interior monitoring must be
according to the statutory provisions.
Any other use than described before is not intended and may cause loss of warranty/
guarantee.
The customer is responsible for application of the product in accordance with the law. Conrad
Electronic does not assume any responsibility/liability exceeding application of the product as
described here.
No part of this product must be modified or converted.
Read these operating instructions thoroughly and carefully, they contain a lot of important
information for assembly, commissioning and operation. Observe all safety information in
these operating instructions!
3. Scope of Delivery
• Car alarm system
• Remote Control
• Microphone
• Speakers
• Light diode
• Mains cable
• Various connection wires
• Operating instructions
6
4. Explanation of Symbols
An exclamation mark in a triangle indicates important notes in these operating
instructions that must be strictly observed.
The „hand“ symbol indicates special information and advice on operation.
5. Safety Information
The guarantee/warranty will expire if damage is incurred resulting from non-
compliance with the operating instructions! We do not assume any liability
for consequential damage!
We do not assume any liability for damage to property or personal injury
caused by improper use or the failure to observe the safety instructions! In
such cases the guarantee/warranty will expire!
• For safety and licensing reasons (CE), unauthorised conversion and/or
modification of the system is not permitted.
• The system only serves to trigger alarms but does not relieve the user from his
diligence obligation.
• Setting when the relay switches and what effects this has is subject to the area
of responsibility of the customer. The manufacturer does not assume any liability
for damage that occurs in this case.
• The GPS functions only serve to monitor property. The customer is personally
responsible for compliance with the statutory requirements for further monitoring.
• During installation and operation, observe the applicable approval provisions
and the road traffic ordinance (Straßenverkehrsordnung).
• Ensure proper commissioning of the system. Observe the operating instructions
for it.
• Avoid strong mechanical strain on the system components.
• Do not expose the device to any high temperatures, dripping or splashing water,
strong vibrations or heavy mechanical stress.
• Consult an expert when in doubt as to the operation, the safety or the connection
of the system.
7
• Do not leave the packaging material lying around carelessly since such materials
can become dangerous toys in the hands of children.
• Keep the device out of reach of children. It is not a toy.
• Also observe the additional safety information in the individual chapters of these
instructions.
• If you are not sure about the correct connection or if questions arise which are not
covered by the operating instructions, please do not hesitate to contact us or
another specialist.
8
6. General Notes on Rechargeable Batteries
• Keep the rechargeable battery out of reach of children.
• Leaking or damaged batteries/rechargeable batteries can cause chemical burns to skin
when touched without the use of adequate protective gloves.
• The rechargeable battery must never be short-circuited or thrown into fire. There is a risk of
fire and explosion!
• Never open or disassemble the rechargeable battery!
• If the rechargeable battery heats up strongly when charging, interrupt the charging process!
• Never charge the battery unobserved.
• For reasons of safety, only charge the rechargeable battery on a heat-resistant surface.
• If the rechargeable battery shows any deformation, holes or other obvious defects, no longer
use the rechargeable battery and do not try to charge it.
• Dispose of the rechargeable battery environmentally compatibly.
9
7. Product Description
The car alarm system can be used to monitor a vehicle. The primary task is not in frightening
the thief away via the speaker but via live transmission of an alarm message to up to 6 phone
numbers by text message.
If the sensors and external electronics (connected to the switching inputs) recognise any
impermissible interaction, various actions like alarm via text message or switching consumers
may be triggered.
The customer may at any time perform other actions by sending text message from his mobile
phone, e.g. determine the current GPS position (coordination or web link), request the status,
switch the relay, check the switching inputs or perform a „silent call“ to hear what is currently
taking place inside the vehicle.
The microphone or speaker can be used to accept calls and call pre-set phone numbers.
Many transverse functions (switching relays when deactivating the alarm, the call causes an
answering text message with the current GPS position, etc) can be used by the customer to
configure the product as desired.
The GPS receiver is used to determine and monitor GPS zones (Area, GeoFence), i.e. places
where the product may be present.
The USB-interface, which is not mandatory for operation or configuration can be used by the
customer for firmware updates to receive further functions.
The product is secured against manipulation with an internal battery.
10
8. Connections and LEDs
The product is explained step by step in the following chapters.
To ensure that the device is set up correctly, make sure to read these operating
instructions, including the safety instructions, completely and attentively before
use.
Assemblyandelectricalconnectionof thesystemmust beperformedby aspecialist.
Table des matières
Manuels Alarme de voiture populaires d'autres marques
Federal Signal Corporation
Federal Signal Corporation Pathfinder Siren Series Manuel
Falcon
Falcon Predator XL3 Guide de l'utilisateur
Audiovox
Audiovox Auto Security XR91 Mode d'emploi
Clifford
Clifford Sabre II Manuel utilisateur
CrimeStopper
CrimeStopper CS-8717 Guide de démarrage rapide
Ultra Start
Ultra Start 450 SERIES Manuel utilisateur
