Conrad-Johnson MF200 Manuel utilisateur

Congratulations on your purchase of the Conrad-Johnson MF200 am-

plifier.Youhaveacquiredoneofthefinerpiecesofmusicalreproduction

equipment available today. The MF200 is the result of over a decade of

research by conrad-johnson design into the application of solid-state

devices to the reproduction of recorded music. Both design and materi-

als have been carefully selected to yield years of unvarying excellence.

Each unit has been painstakingly hand-assembled and exhaustively

tested.

Please take a few minutes to read this manual so that you will better

understand the featues and capabilities of your MF200.

MF200 Owner’s Manual 1

LIMITED WARRANTY FOR THE Conrad-Johnson MF200

1. conrad-johnson design, inc.warrants to the original owner that the

MF200 will be free from defects in material and workmanship for a

period of three years from the date of original purchase.

2. During the warranty period, conrad-johnson will repair defective

unitswithoutchargeforlabororpartssubjecttothefollowingconditions:

a)The unit must not have been altered or damaged through

misuse, abuse, negligence, accident or improper operation.

b)The purchaser must provide evidence of purchase at the time

service is requested.

c) All repairs must be undertaken at the factory or other service

center designated by conrad-johnson design, inc. Units submitted

for warranty repairs must be shipped in the factory packing carton

to conrad-johnson design or its designated service center, freight

and insurance prepaid by the owner, and will be returned to the

owner, freight and insurance prepaid by conrad-johnson design.

Replacement cartons are available from the factory for a nominal

charge.

d) Normal wear and maintenance are not covered by this warranty.

3. Where permitted by law, conrad-johnson design’s liability shall be

limited to that set forth in this warranty. No other warranty of any kind,

expressed or implied, is made by conrad- johnson design, inc., and all

implied warranties, including merchantability and fitness for a particular

"purpose", which exceed the obligations and time limits set forth herein

are hereby disclaimed. conrad-johnson design, inc. shall not be liable

for incidental or consequential damages. Some states do not allow the

exclusion or limitations on how long an implied warranty lasts, so the

above limitation or exclusion may not apply to you.

4. This warranty gives you specific legal rights, and you may also have

other rights which vary from state to state. Questions about warranty

service should be addressed to:

Service Department

conrad-johnson design, inc.

2800 R Dorr Avenue

Fairfax, VA 22031

MF200 Owner’s Manual 2

REGISTERING THE WARRANTY

Please return the enclosed card to the factory within 30 days of pur-

chase to register the warranty. Proper registration of the warranty is

important! It will enable us to inform you of any alterations in the design

of a given model and of any new products we offer which are likely to be

of interest to you.

MF200 Owner’s Manual 3

INSTALLATION

Because the MF200 amplifier dissipates considerable heat it is essen-

tial that proper attention be paid to ventilation. The unit should be

mounted horizontally on a flat hard surface so that the heat sinks are

unobstructed. At least four inches of clearance should be provided

abovetheunit, and at least two inches on the sides. Thecabinetorshelf

should be open at both front and back. For more restricted installations,

cooling fans are recommended.

The front panel of the MF200 will fit in a standard 19" equipment rack

and is designed to carry the weight of the unit so that it may be rack

mounted. Again, it is important that adequate clearance be provided

above so that ventilation is not impeded. About six inches of the front of

the rack should be left open above the unit.

To minimize hum pickup, keep the unit well away from the preamplifier

and turntable and route power cords away from input cables.

THE MF200 IS TO BE OPERATED ONLY ON AC LINE VOLTAGE OF

108 TO 125 VOLTS.

The MF200 is optionally available wired for 100 volt, 120V, 220V or 240

volt, 50/60 Hz current.

CONNECTION

INPUT: Connect the preamplifier to your MF200 amplifier at the RCA

type connections located on the amplifier heat sinks.

OUTPUT: Five way binding posts are provided for connection of your

loudspeakers, with correct spacing to accept a standard "double ba-

nana" plug. They will also accept spade lugs, bare wire, or pin connec-

tors.

The two channels should be connected in correct "relative phase".This

means that when the same signal is applied to both channels, the right

and left channels speaker diaphragms should move synchronously - in

and out together. Terminals on the speakers are usually coded - one

MF200 Owner’s Manual 4

designated "C", "earth", "ground", "-" or black, the other designated "+"

or red.

"In phase" connection of the speakers can normally be achieved by

taking care to connect the wire from the red (+) amplifier terminal

marked on each channel to the red or "+" coded terminal on each

speaker.

Correct relative phase connection of the speakers can be readily ascer-

tained by ear. With the preamplifier mode switched into the MONO

position, play a record of a solo vocalist. With the speakers in phase the

voice should be clearly focused between the two speakers. With the

speakers connected out of phase, the voice will be diffuse, with no

identifiablesource.Relativephase may be reversed by switching the "+"

and "-" leads at one speaker only.

MF200 Owner’s Manual 5

GETTING THE MOST FROM YOUR

Conrad-Johnson MF200

The MF200 is a highly sophisticated music reproduction instrument, but

it cannot transform an inferior stereo system. Only the very best loud-

speaker systems will be capable of fully revealing the capabilities of this

precision instrument. On the other hand, the MF200 is highly revealing

of faults in the signal source.

Proper set-up is important in any high-fidelity system, but with state-of-

the-art components it is essential. Before attempting to evaluate the

MF200, be sure that each component in your system has been set up

carefully according to manufacturer recommendations. Adjustment of

the cartridge vertical tracking angle can be especially critical with mod-

ern stylus configurations.

Given a system of high quality components, there remain a number of

important details which must be attended to.

ABSOLUTE PHASE

Musical notes are heard through the ear’s response to waves of alter-

nating rise and fall of air pressure. Musical transients are exclusively

positive: that is, the initial effect is a rise in pressure. The ear is capable

of distinguishing these positive transients from the musically unnatural

alternative of a negative transient (an initial fall in air pressure). In your

stereo system, these transients are created by your loudspeakers. If the

speakers respond to musical transients by first moving out, they are

creating a rise in pressure, and the system is said to be "phase correct".

If they respond by moving in, they create a fall in pressure and the

system is said to be "phase inverting". Each component in the stereo

systemiseitherphasecorrectorphaseinverting(includingthecartridge

and speakers-these are normally phase correct). It is of no conse-

quence if an individual component is phase inverting, as long as the

system as a whole is phase correct. This will be the case as long as the

number of phase inversions is even (or zero).

THE MF200 IS PHASE CORRECT. If your system has an odd number

of inversions, then you must add one phase inversion. This is conven-

MF200 Owner’s Manual 6

iently done by reversing the positive and negative connections on either

your cartridge or your speakers (be sure to reverse both channels).

If you are not sure about the phase of every component in your system,

you can establish correct absolute phase by careful listening. When the

system is in correct phase, transients will be noticeably cleaner and

more sharply defined. The effect is especially apparent on plucked

string sounds. A final warning - not all records are phase correct

(including some "audiophile" recordings), so listen to several before

concluding your investigation of absolute phase.

THE IMPORTANCE OF WIRES

Interconnect and speaker wires are an important element in your stereo

system. Interconnects are available which will permit a reference quality

system to blossom and fulfill its promise of musical reality. Others will

stranglethesytemtothepointwhereit becomesnobetterthanaverage.

To complicate matters, our experience suggests that the choice of

interconnects will be system dependent-those that are ranked first on a

given system may be a poor choice for a different system. Consult your

conrad-johnson dealer for recommendations for your specific system.

QUESTIONS: If you have any questions about the installation or func-

tion of your MF200 do not hesitate to call Customer Service at (703)

698- 8581.

MF200 Owner’s Manual 7

SPECIFICATIONS:

Power: 200 watts per channel RMS both channels driven into 8 ohms

from 20Hz to 20KHz at no more than 1% total harmonic distortion or

intermodulation distortion.

Sensitivity: 2.2V to rated power.

Phase: Phase correct (non-inverting)

Frequency response: 20Hz to 20KHz +0, -.25dB

Hum and noise: 98dB below full power output.

Input impedance: 100K ohms.

Dimensions: 15.63D x 19W x 8.75H inches.

Weight: 59 lbs.

Fuses:Thereare5userreplaceablefusesinthe MF200.Thefourfuses

abovetheoutputjacksarepowersupplyfuses,type3AG5ampfast-blo.

Theaclinefuse is a type 3AG 10 amp slo-blo(7ampslow blow for 220V

or 240V amplifiers). NEVER REPLACE A FUSE WITH A VALUE OR

TYPE DIFFERENT FROM THAT ORIGINALLY SUPPLIED BY THE

FACTORY.Intheevent ofafuseblowingrepeatedly,contactyourdealer

or the conrad-johnson service department.

MF200 Owner’s Manual 8

SERVICE

In the event your conrad-johnson MF200 stereo amplifier requires

service, repack it with the original packing material and ship via United

Parcel Service (UPS) to:

conrad-johnson design, inc.

Service Department

2800R Dorr Avenue

Fairfax, VA 22031

Be sure to enclose a note explaining the problem you are having in as

much detail as possible. If the problem is intermittent, please indicate. If

you do not have the original packing material, replacements are avail-

able from conrad-johnson design at a nominal charge. If the unit is

under warranty, be sure to enclose a copy of your receipt as proof of

purchase.

MF200 Owner’s Manual 9

Table des matières

Autres manuels Conrad-Johnson Amplificateur

Conrad-Johnson

Conrad-Johnson LP70S Manuel utilisateur

Conrad-Johnson

Conrad-Johnson PV-3 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson 16LS Manuel utilisateur

Conrad-Johnson

Conrad-Johnson MF2275 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson MV100 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson MV45 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ET7 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ART 108A Manuel utilisateur

Conrad-Johnson

Conrad-Johnson LP260M Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ART 27A Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ACT2 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson CA150 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson MF80 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ART 300 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson PV11 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson LP140M Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ART 150 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson Premier Four Manuel utilisateur

Conrad-Johnson

Conrad-Johnson LP66S Manuel utilisateur

Conrad-Johnson

Conrad-Johnson MET1 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson Premier 18LS Manuel utilisateur

Conrad-Johnson

Conrad-Johnson Sonographe SA250 Manuel utilisateur

Conrad-Johnson

Conrad-Johnson LP125sa Manuel utilisateur

Conrad-Johnson

Conrad-Johnson ET5 Manuel utilisateur

Manuels Amplificateur populaires d'autres marques

ASTRO

ASTRO HVO V40 P Manuel utilisateur

Marantz

Marantz SUPERSCOPE BLA-545 Instructions de montage

NAD

NAD CI980 Manuel utilisateur

Technics

Technics SE-CH770 Manuel utilisateur

Harman Kardon

Harman Kardon HK6300 Manuel utilisateur

NAD

NAD T975 Manuel utilisateur

McIntosh

McIntosh MA6850 Manuel utilisateur

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuel utilisateur

Viatron

Viatron Autrix Manuel utilisateur

GME

GME GA9800 Manuel utilisateur

Atlas

Atlas CP700 Manuel utilisateur

Roland

Roland KC-1000 Manuel utilisateur

Pyle

Pyle PFMRA350BW Manuel utilisateur

Advantage

Advantage S-250 Manuel utilisateur

IRT Electronics

IRT Electronics DVA-3007 Manuel utilisateur

Dimavery

Dimavery BA-100 Series Manuel utilisateur

Sony

Sony XM-S400D Manuel utilisateur

Schertler

Schertler ROY X Manuel utilisateur