ConnectGear CONNEkT Manuel utilisateur
Install Guide
IMPORTANT SAFETY WARNINGS
CONTACT WITH MAINS ELECTRICITY CAN CAUSE SERIOUS INJURY OR DEATH.
• Do not open the back of WiFi CONNEkT Wall Socket
as this will void your warranty.
• Do not store or install this product in areas of high humidity.
• Do not insert any foreign objects into the openings of the
WiFi CONNEkT Wall Socket.
• Do not cover or block the holes on the rear of the unit as
they serve as ventilation.
• Do not use water or substances such as paint thinners, alcohol or
strong cleaning solutions to clean the WiFi CONNEkT Wall Socket
due to risk of damage to the plastic, electrocution or fire.
• Do not use the WiFi CONNEkT Wall Socket with a power
supply different than 220-240 volts 50 Hz AC.
• To prevent fire hazard always use cable of the correct rating,
size & type for the installation.
• Suitable for indoor use only.
• If the WiFi CONNEkT Wall Socket becomes damaged isolate
all electrics and seek the advice from a qualified electrician.
INSTALLATION REGULATIONS
UNITED KINGDOM
The WiFi CONNEkT Wall Socket must be installed in accordance with the
latest edition of the IEE Wiring (BS 7671) Regulations & Building Regulations.
REPUBLIC OF IRELAND
The WiFi CONNEkT Wall Socket must be installed in accordance with the
ETCI National Rules for Electrical installations.
SAFETY APPROVALS
• EN300328
• EN301489
• EN62311
• EN50561
Connekt Gear is a brand of Group Gear Ltd
This Install Guide is for the WiFi CONNEkT Add-On Sockets.
For the full Install & Set-up Guide please visit: www.groupgear.co.uk
• EN50412
• EN55032
• EN61000-3-2
• EN61000-3-3
• BS5733
• Complies with UK Building
Regulations 2010 approved
document M, Volume 2, Section 4.
REGISTER YOUR PRODUCT
To register your product please visit: http://groupgear.co.uk/WiFiConnektReg.asp
GROUP GEAR LTD
Tel • 0121 503 0666
Website • www.groupgear.co.uk
Find us on YouTube • WiFi CONNEkT
All In One Socket Starter Kit
WIFI USB
Charging
Network
Ports
Powerline
Technology
We recommend using a qualified electrician for installation. Please ensure that these
instructions are read carefully and fully understood before commencing with installation.
NOTE
Please follow installation guide diagram for best practice.
INSTALLATION INSTRUCTIONS
1. Switch off the mains power supply in the consumer unit (fuse box).
2. If retro fit remove the existing wall socket from the wall.
3. Prepare the mounting surface area clearing away any plaster debris and
dust from the inside the mounting box.
4. If using the included spacer slide it over the back of the wall socket.
5. Following the diagram overleaf push the cables into the relevant terminal blocks.
(features dual earth terminals, either or both can be used).
6. All earth wires must be sleeved and terminated to the backbox.
7. Tighten the terminal screws firmly and securely.
8. This device must be earthed.
9. Screw the wall socket securely to the wall using the screws provided.
10. Switch the mains supply back on in the consumer unit (fuse box)
when the installation has been correctly completed.
11. Before use we recommend that a socket test is carried out using a socket tester.
Autres manuels ConnectGear Accessoires
