Community R-VTY15 Manuel

Instruction Guide

ACCESSORY YOKES

R-VTY15, R-VTY35, R-FRY35

ABOUT INSTALLATION

The wiring and installation of the loudspeakers is not discussed in this guide. Please refer to the

R.15/R.35 Installation and Operation Manual for complete information.

R-VTY15

Vari-Tilt™ yoke for R.15COAX

R-VTY35

Vari-Tilt™ yoke for

R.35COAX and R.35-3896

R-FRY35

Full rotation yoke for

R.35COAX and R.35-3896

CAUTION: Installation of R-Series loudspeakers should only be performed by trained

and qualied personnel. It is strongly recommended that a licensed and certied

professional structural engineer approve the mounting design. Severe injury and/or

loss of life may occur if this product is improperly installed.

TOOLS / MATERIALS NEEDED:

• R.15 or R.35 Loudspeaker

• Accessory Yoke

• Metric Wrench/Socket (13mm, 16mm)

• Mounting hardware appropriate for surface (installer must supply)

INSTALLATION

q Install Vari-Tilt™ wall mount plate or full rotation yoke with hardware rated for the

mounting surface. See Caution below. Fully tighten all hardware.

q For Vari-Tilt™ yokes, follow appropriate illustration (Figure 1 or 2) to secure yoke

between the pinch plate. Snug tighten pinch plate hardware.

q Attach loudspeaker to yoke per instructions in the R.15 / R.35 Loudspeaker

Installation Guide, or per Figure 3. Ensure that the rubber gasket is between the yoke

and enclosure. The hardware to attach the yoke to the loudspeaker is supplied with

the loudspeaker.

q Aim the loudspeaker to the intended audience, set the angle, and tighten all

mounting hardware.

WARNING: Be careful not to over- or under-tighten fasteners. Sufcient torque must be applied to

ensure a secure assembly. Over-tightening can lead to damaged fasteners, thus weakening the

component mounting. Either scenario can lead to risk of assembly separation leading to injury,

death, or property damage.

R-VTY15 Vari-Tilt™ Yoke

78°

63°

8x25 mm Hex Bolt

8 mm Lock Washer

8mm Flat Washer

Wall Mount Plate

Wall Mount Pinch Plate

Vari-Tilt Yoke

Attach wall mount plate to surface -

Installer must supply appropriate hardware

Range of rotation from center

Figure 1. R-VTY15 installation

R-FRY35 Full Rotation Yoke

R-VTY35 Vari-Tilt™ Yoke

Attach wall mount plate to surface -

Installer must supply appropriate hardware

10 x 35 mm Hex Bolt

10 mm Lock Washer

10 mm Flat Washer

Wall Mount Plate

Pinch Plate

Vari-Tilt Yoke

74°

47°

Range of rotation from center

Figure 2. R-VTY35 installation

Figure 3. Yoke attachment to loudspeaker (R-FRY35 shown)

8 x 32 mm SS Stud

(leave 3/4" sticking out)

2" OD

Rubber Gasket

Yoke

Enclosure

8 mm SS

Hex Nut

8 mm SS

Lock Washer

8mm SS Flat Washer

360°

R.35 loudspeaker can fully

rotate in the yoke

Mount yoke to the surface using holes aligned with large center hole as primary mounting

points - these are aligned with the center of gravity. Use other holes as secondary

reinforcement. Orient angled side to the front of the loudspeaker if the yoke is mounted

below the enclosure.

Hardware to attach all accessory yokes to the enclosure is supplied with the loudspeaker.

Note: Every effort has been made to insure that the information contained in this manual was complete and

accurate at the time of printing. However, due to ongoing technical advances, changes or modications may

have occurred that are not covered in this manual. Visit Community at http://www.communitypro.com for the

latest version of this document and the most recent product information.

Community Professional Loudspeakers

333 East Fifth Street, Chester, PA 19013-4511 USA

Phone: (610) 876-3400 • Fax: (610) 874-0190

www.communitypro.com

WARRANTY INFORMATION

TRANSFERABLE WARRANTY “(LIMITED)" VALID IN THE USA ONLY

The R-Series Loudspeaker Systems are designed and backed by Community

Professional Loudspeakers. For complete warranty information within the USA please visit

www.communitypro.com/warranty. Please call 610-876-3400 to locate your nearest Authorized

Field Service Station. For Factory Service call 610-876-3400. You must obtain a Return

Authorization (R/A) number prior to the return of your product for factory service.

WARRANTY INFORMATION FOR COUNTRIES OTHER THAN THE USA

To obtain specic warranty information and available service locations for countries other than the

United States of America, contact the authorized Community Distributor for your specic country

or region.

SHIPPING DAMAGE / CLAIMS

If the product is damaged during transit you must le a damage claim directly with the freight

company. It’s very important to contact the freight company as soon as possible after receiving

your shipment, as most freight companies have a short time limit within which they will investigate

claims. Be sure to save the carton and packing materials, as damage claims can be denied if

these materials are not retained. If evidence of physical damage exists upon arrival, be cautious

before signing the delivery acceptance receipt. Often, the ne print will waive your right to le a

claim for damage or loss after you sign it. Make sure that the number of cartons shown on the

freight documents have actually been delivered.

# 113008 6SEPT2013

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Community Intervenants

Community

Community CLOUD 4 Manuel utilisateur

Community

Community C4 Manuel utilisateur

Community

Community ENTASYS 200 Manuel utilisateur

Community

Community Distributed Design DS5 Manuel utilisateur

Community

Community Distributed Design DS5 Manuel du propriétaire

Community

Community R.15COAX Manuel utilisateur

Community

Community iBOX M12 Fiche technique

Community

Community iBOX SERIES Manuel utilisateur

Community

Community Wet II Fiche technique

Community

Community MVP28 Manuel utilisateur

Community

Community D SERIES Manuel utilisateur

Community

Community DND Series Manuel utilisateur

Community

Community DP6 Manuel utilisateur

Community

Community R.35-3896-EN Manuel utilisateur

Community

Community ENTASYS Manuel utilisateur

Community

Community Distributed Design DA6 Manuel utilisateur

Community

Community Veris Series Manuel utilisateur

Community

Community Distributed Design D4LP Manuel du propriétaire

Community

Community IVY1082 Manuel utilisateur

Community

Community MX-Y8 Manuel utilisateur

Community

Community MVP35 Manuel utilisateur

Community

Community I/05 Manuel utilisateur

Community

Community MX8 Manuel utilisateur

Community

Community Point Source 600 Guide de démarrage rapide

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur