Commander W56P Manuel utilisateur
Quick Installation Guide
Please read carefully before use.
Commander
Essentials Cordless
W56P
Packaging Contents
The following items are included in your W56P package:
W56H Handset Base for
W52P/W56P
USB Charger
Cradle
Two Power
Adapters
Belt Clip Ethernet Cable Rechargeable
Battery
Quick Reference
Guide and Quick
Installation Guide
Note: Commander Essentials Cordless W56P IP DECT phone consists of one Base for W52P/W56P
and one W56H Handset.
Base for W52P
W56P
Assembling the Base Station & DECT Phone
1. Connect the network and power for the base station in one of the following
ways, as shown below:
a. AC Power Option b. PoE (Power over Ethernet) Option
Note: If inline power (PoE) is provided, you do not need to connect the power adapter. Make sure the
switch is PoE-compliant. If using the power adapter, the base station should be used with an
original power adapter only. The use of a third-party power adapter may cause the damage
to the base station.
IEEE 802.3af
compliant
PoE Switch
2. Insert the battery into the handset, as shown below:
Note: The handset in this package is already registered to the base station. Should you have any
requirement to re-register the W56H handset with the base, please see the W56H Quick
Installation Guide from the resource centre.
5. Attach the Belt Clip, as shown below if required:
Note: The handset should be used with an original power adapter only. The use of a
third-party power adapter may cause the damage to the handset. The charging status of
the handset is indicated in the top right-hand corner of the LCD screen.
3. Connect the charger cradle and charge the handset, as shown below:
Level 10, 452 Flinders St Melbourne VIC 3000
ABN 85 136 950 082
After the IP phone is connected to the network and supplied with power, it automatically
begins with the initialisation process.
Please allow up to 10-15 minutes for the phone to connect to Commander’s servers to
collect their configuration and any required updates to both the base station and handset/s.
The phone may reboot two or three times during this process or after factory default setting
is made. Do NOT interrupt this process. The display may indicate the current status of the
operation with ‘
initialising
’ and ‘
configuration updating
’. After startup, the phone is ready for use.
If you require assistance, please call the Commander
Phone team on 1300 638 208, or email us at commanderphone@commander.com.
Table des matières
Autres manuels Commander Téléphone sans fil
