Coemar Reflection LEDko FullSpectrum 6 Manuel utilisateur
TM
FullSpectrum 6
USER MANUAL
. All rights reserved.
Information subject to change without notice. Coemar and all affiliated companies disclaim liability
for any injury, damage, direct or indirect loss, consequential or economic loss or any other loss
occasioned by the use of, inability to use or reliance on the information contained in this document.
The Coemar logo, the Coemar name and all other trade-marks in this document pertaining to
services or products by Coemar or its affiliates and subsidiaries are trademarks or licensed by
Coemar or its affiliates or subsidiaries.
No part of this document may be used for distribution, reproduction, transmission, transcription,
storage in a data retrieval system, or translated into any language in any form by any means without
the prior written permission of Coemar ®. If you are downloading files from our web pages for
your personal use, make sure to check for updated versions. Coemar ® cannot take any liability
whatsoever for downloaded files, as technical data are subject to change without notice.
Congratulations on having purchased a product. You have assured yourself of a fixture of
the highest quality, both in componentry and in the technology used. We renew our invitation to
you to complete the service information on the previous page, to expedite any request for service
information or spares (in case of problems encountered either during, or subsequent to, instal-
lation). This information will assist in providing prompt and accurate advice from your
service centre. Following the instructions and procedures outlined in this manual will ensure the
maximum efficiency of this product for years to come.
.......................................................................................Pag. 5
1.1Packaging....................................................................................................................................Pag.5
Transportation ...........................................................................................................Pag. 5
....................................................................................................... Pag. 5
Safety informations ................................................................................................... Pag. 5
Warranty conditions ................................................................................................. Pag. 6
EC norms ................................................................................................................... Pag. 6
...................................................................................................Pag. 7
Technical characteristics ...........................................................................................Pag. 7
Dimensions................................................................................................................ Pag. 7
Unit’s main components ............................................................................................Pag. 8
Back panel description .............................................................................................Pag. 9
.....................................................................................................................Pag. 10
Optical Installation ....................................................................................................Pag. 11
Mechanical installation ........................................................................................... Pag. 11
Safety chain .............................................................................................................Pag. 11
Adjusting unit’s tilt ....................................................................................................Pag. 11
...................................................................................................................Pag. 12
5.1 Operating voltage and frequency ........................................................................... Pag. 12
Connection to mains power ....................................................................................Pag. 12
..........................................................................................Pag. 14
6.1 Control signal connection by XLR5 plugs .............................................................. Pag. 14
..............................................................................................Pag. 15
7.1 DMX address of the unit .......................................................................................... Pag. 15
....................................................................................................................Pag. 16
DMX modes ...............................................................................................................Pag. 16
DMX Chart 32 channels ...........................................................................................Pag. 17
............................................................................................... Pag. 20
9.1 Quick guide to menu............................................................................................... Pag. 20
Rapid count ............................................................................................................. Pag. 20
Display Setup Menu ................................................................................................ Pag. 21
Main Function Menu ............................................................................................... Pag. 23
9.5 Measures Menu ...................................................................................................... Pag. 26
..................................................................... Pag. 28
Special functions of the fixture............................................................................ Pag. 28
Error messages..................................................................................................... Pag. 28
..................................................................................... Pag. 28
............................................................................................................... Pag. 29
Firmware update .................................................................................................... Pag. 29
Periodic cleaning .................................................................................................. Pag. 29
Periodic controls ................................................................................................... Pag. 29
.................................................................................... Pag. 29
5
1.
1.1
Open the packaging and make sure that no part of the equipment has suffered any damage dur-
ing the transportation. In case of damage to the fixture, contact your currier and your supplier
immediately by telephone, fax or e-mail, and inform them you will formally notify them in writing
through registered letter.
Ensure the packaging contains:
The should be transported in either its original packaging or
in an appropriate flight case.
1. Never locate the fixture on any flammable surface.
Minimum distance from flammable materials: 0,5 m.
Minimum distance from the closet illuminable surface: 0,5 m.
Connect the projector to mains power protected by a thermal magnetic circuit
breaker.
1. Presence of high voltage inside of the fixture. Insulate the projector from mains
supply before opening or performing any function which involves touching the
inside of the fixture, including LED replacement.
For the connection to the mains, adhere strictly to the guidelines outlined in this
manual.
6
1. The projector must always be installed with bolts, clamps, or other fixing devices
which are suitably rated to support the weight of the projector.
Always use a secondary safety fixing device with chain or steel wire of a suitable
rating to sustain the weight of the unit in case of failure of the principal fixing
point.
The external surfaces of the unit, at various points, may reach 60°C. Never han-
dle the unit until at least 10 minutes have elapsed since the LED was turned off.
Never install the fixture in an enclosed area lacking sufficient air flow; the ambi-
ent temperature must not exceed 40°C.
5. The projector contains electronic and electrical components which must under
no circumstances be in contact with water, oil or any other liquid. Failure to do
so will compromise the proper functioning of the projector.
1. The standard version of the fixture is classified ordinary apparatus; its protection
grade against penetration by external agents,solid or liquid, is .
1. The fixture is under warranty for 24 months from the purchase date against factory defections.
Damage ought to unskillfulness, inappropriate use, or lack of suggested maintenance are
excluded from the warranty.
Warranty expires when the projector is opened by unauthorized personnel.
Warranty doesn’t include the replacement of the fixture.
5. Serial number and model of the fixture are necessary to retrieve informations and assistance
from the dealer.
1. The fixture satisfies the essential requirements of the directive 2004/108/EC, 2006/95/EC,
2011/65/EC, 2002/96/EC & 2003/108/EC.
The level of technology of requires the use of
specialised personnel for all service applications; refer all work to your authorised
service centre.
A good earth connection is essential for the proper functioning of the projector.
Never connect the fixture if there is no earth connection.
5. Mains cables must not come into contact with other cables.
6. Do not operate the projector with wet hands or in an area where water is present.
7. The fixture must never be located in an exposed position, or in areas of extreme
humidity.
7
459 mm
18 in
819 mm
32,2 in
378 mm
14,9 in
297 mm
11 in
459 mm
18 in
378 mm
14,9 in
Cosϕ
400 W
Red, Green, Blu, White, Lime, Amber color mixing
IP20
ABody case
BFront lens
Locking handle
Yoke
EBase handle
FDisplay panel
A
B
E
F
9
*Display panel
*Power panel
may be floor mounted or it can be hunged from an appropriate
structure in any position. The unit is provided with four rubber feet mounted on its base, allowing
it to be placed on a flat surface.
For installations on a reticular structure, we recommend to use specific “A” hooks, suitable for
supporting the weight.
Always ensure that your support structure
and fixing (bolts, clamps, etc…) are rated
to support the weight of the fixture.
A
Autres manuels pour Reflection LEDko FullSpectrum 6
1
Table des matières
Autres manuels Coemar Équipement d'éclairage
Coemar
Coemar Infinity Spot S Manuel utilisateur
Coemar
Coemar par lite LED IP Manuel utilisateur
Coemar
Coemar ColourCyc 250LX Manuel utilisateur
Coemar
Coemar Reflection LedkoP Manuel utilisateur
Coemar
Coemar Panorama Cyc 1800 Architectural Manuel utilisateur
Coemar
Coemar Par Lite Led Manuel utilisateur
Coemar
Coemar SunLite LED Series Manuel utilisateur
Coemar
Coemar Infinity Wash M Manuel utilisateur
Coemar
Coemar LineaLed Stick Manuel utilisateur
Coemar
Coemar LEDko DIM T Manuel utilisateur
Coemar
Coemar CF 1200 Spot Manuel utilisateur
Coemar
Coemar LEDko EXT Manuel utilisateur
Coemar
Coemar LEDko EXT Manuel utilisateur
Coemar
Coemar Panorama Power MK2 Manuel utilisateur
Coemar
Coemar ReLite Led Kit VariWhite 250 Manuel utilisateur
Coemar
Coemar i spot S Manuel utilisateur
Coemar
Coemar CF 1200 Hard Edge Manuel utilisateur
Coemar
Coemar Reflection FullSpectrum Manuel utilisateur
Coemar
Coemar MiniLEDko Series Manuel utilisateur
Coemar
Coemar ProSpot LX Manuel utilisateur
Manuels Équipement d'éclairage populaires d'autres marques
Qazqa
Qazqa Suplux SL 3 Black 103062 Manuel utilisateur
Commercial Electric
Commercial Electric 54568141 Manuel utilisateur
CREE LIGHTING
CREE LIGHTING 304 Series Manuel utilisateur
Goobay
Goobay 49867 Manuel utilisateur
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Manuel utilisateur
Alkalite
Alkalite Krypton KT-81 Manuel utilisateur
