Code Blue CB 1 Series Manuel de service

800.205.7186 ●www.codeblue.com

Public Address System

PAS

Installation | Configuration | Operation | Troubleshooting

Document No: GU-153-B Revised: 3/2015

Administrator Guide

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 2 of 31 GU-153-G

WARNING

Only qualified personnel should install this unit. The installation should

conform to all local codes. In some countries, a certified electrician may

be required.

CAUTION

No caution is necessary for this product.

NOTICE TO USERS

software described herein, in whole or part, shall not be reproduced,

translated or reduced to any machine-readable form without prior written

approval from Code Blue Corporation.

Code Blue Corporation provides no warranty with regard to this guide.

The software or other information contained herein and hereby expressly

disclaims any implied warranties of merchantability or fitness for any

particular purpose with regard to this guide, the software or such other

information. In no event shall Code Blue Corporation be liable for any

incidental, consequential or special damages, whether based on tort,

contract or otherwise, arising out of or in connection with this guide, the

software or other information contained herein or the use thereof.

Code Blue Corporation reserves the right to make any modifications to

this guide or the information contained herein at any time without notice.

The software described herein may also be governed by the terms of a

separate user license agreement.

Code Blue®is a registered trademark of Code Blue Corporation.

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 3 of 31 GU-153-G

Table of Contents

Section Page

1 Introduction................................................................................................... 4

2 Before You Start ........................................................................................... 6

3 How to Update Connectors.......................................................................... 8

4 Installation & System Setup....................................................................... 10

5 Software Configuration.............................................................................. 20

6 Architectural Overview............................................................................... 22

7 Wiring Diagrams......................................................................................... 23

8 Troubleshooting ......................................................................................... 28

9 Spare Parts.................................................................................................. 30

10 Download Information ............................................................................ 31

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 4 of 31 GU-153-G

1Introduction

Thank you for choosing the Public Address option for your Code Blue application. Public

Address is a centralized amplifier-based system designed to provide voice paging and

broadcast alarm tones during emergencies. The system can transmit alarm tones and voice

messages in a reliable and safe manner from a central location to all or selected areas of the

facility via loudspeakers. The entire operational area can be divided into one or more zones,

which can be accessed independently either for announcements or alarm broadcasting.

Loudspeakers are installed in these zones. There are no limitations to the number of zones in a

system or number of loudspeakers in each zone. The system is designed to offer clear

reproduction of sound and intelligibility, even in high noise areas.

1.1 Overview

This manual contains all of the Code Blue PAS information needed on the CB 1 series with

Public Address, CB 5-s with Public Address, WM-180 Public Address System, CB 2-e with

Public Address and 360PAS retrofit top. This manual contains a general overview of the Code

Blue PAS options and its application, installation and wiring.

CB 1-s w/ PAS CB 5-s w/ PAS WM 180CB 2-e w/ Public Address 360PAS Retrofit Top

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 5 of 31 GU-153-G

1.2 PAS Options:

1.2.1 CB 1 Series with Public Address Units Outdoor

Large diameter towers; analog or IP

An excellent choice when instant mass notification of a geographic area is essential. The

unique six-speaker design delivers optimal audio source dispersion utilizing state-of-the-

art amplifiers and horn array.

1.2.2 CB 5-s with Public Address Units Outdoor

Small diameter towers

Exclusively designed as an emergency communication system to deliver maximum

audio clarity and range to ensure notifications are accurately broadcast to your intended

audience.

1.2.3 CB 2-e with Public Address Units Indoor & Outdoor

Wall or pole mount; analog or IP

An excellent choice for parking decks, dorm entrances, hallways and public transit

centers where instant mass notification of a geographic area is essential.

1.2.4 360 PAS Retrofit Tops Outdoor

PAS top kit for existing standard CB 1 series towers in the field to provide public address

capabilities.

The unique six-speaker design delivers optimal audio source dispersion utilizing state-of-

the-art amplifiers and horn array.

1.2.5 WM-180 Wall Mount PAS unit Indoor & Outdoor

Wall or pole mount option remotely adds public address capabilities to new or existing

CB units.

By adding an analog or IP controller board, you enable the WM-180 to be directly man-

aged by Code Blue’s Blue Alert® MNS (Mass Notification System) software, granting the

user messaging options. The controller also monitors the amplifier and speaker for

various failures, which are reported to the appropriate maintenance personnel, and

allows the user to call a single WM-180 unit for a targeted message.

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 6 of 31 GU-153-G

2Before You Start

2.1 NFPA 72 Chapter 24

This regulation covers the application, installation, location, performance, inspection, testing and

maintenance of fire alarm systems, supervising station alarm systems, public emergency alarm

reporting systems, fire warning equipment and emergency communications systems (ECS), and

their components.

2.2 UFC-4-021-1

This provides technical criteria for systems that implement mass notification in compliance with

the Department of Defense’s antiterrorism requirements. Implement national design standards

and recommendations for mass notification systems, as provided in NFPA 72, including Annex

2.3 Precautions

Code Blue recommends professional services before the order and installation of all PAS

products.

For survey information, please email customerservi[email protected].

2.3.1 PAS Site Survey call for scheduling and pricing

Ambient Noise Survey: Measures the sound energy flowing into, or outward from, a

specified area.

System Design Survey –Involves the placement, wiring and installation of PAS

equipment.

Complete Survey –Includes ambient noise and system design of PAS equipment.

2.4 In Case of Breakdown

Code Blue Technical Support

Email: [email protected]m

Toll free: 800-205-7186, Opt. 3

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 7 of 31 GU-153-G

2.5 In Case of Abnormal Operation

If the unit emits smoke or an unusual smell, water or other foreign materials enter the enclosure,

or the unit is dropped or the enclosure is damaged, power off immediately and contact Code

Blue Customer Service.

Email: customerservi[email protected]

Toll free: 800-205-7186, Opt. 2

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 8 of 31 GU-153-G

3How to Update Connectors

As of 2020, many Code Blue products come with Wago connectors. These connectors provide

ease of use and a much stronger connection. Below are the steps needed to change to the new

connectors.

Example:

Cut off both wires.

Strip all wires and twist tight.

Wago socket

connectors to

add to your

wires.

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 9 of 31 GU-153-G

Place small screwdriver into square hole and push down. Insert cut

wire into round hole and remove screwdriver. Repeat on the rest

of the connectors.

Once all connectors have been switched, you are ready to apply

power.

Please contact technicalsupport@codeblue.com if you need further assistance.

Public Address System

Administrator Guide

Code Blue ●259 Hedcor Street ●Holland, MI ●4923 USA ●800.205.7186 ●www.codeblue.com Rev 12/2018 page 10 of 31 GU-153-G

4Installation & System Setup

This section covers the following units:

CB 1 Series with Public Address, including the 360° PAS Retrofit Kit

CB 5-s with Public Address

CB 2-e with Public Address

WM-180°

4.1 CB 1 Series with Public Address, including 360° PAS

Retrofit Kit

The following models are covered in the installation instructions for CB 1 Series with Public

Address or the 360° PAS Retrofit Kit:

CB 1-e

CB 1-s

CB 1-d

4.1.1 Tools Required

Ladder –to reach the top of the unit.

Security bit –to secure the PAS top to the adapter ring.

6mm Allen wrench –to secure the PAS adapter ring to the top of the unit.

3/8”socket set - to mount the mounting plate containing the new toroid transformer.

4.1.2 Before You Begin

4.1.2.1 Remove 120V AC power from the unit.

4.1.3 Install Adapter Ring

4.1.3.1 Remove the existing dome top assembly. Disconnect the red/black and

yellow/yellow wiring harnesses connected to the beacon/strobe mounted in the dome top

assembly.

4.1.3.2 Place the adapter ring on top of the bollard and tighten the three Allen set

screws to hold in place (see Figure 2 on Page 12).

Autres manuels pour CB 1 Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Code Blue Système de sécurité

Code Blue

Code Blue CB 1-s w Manuel de service

Manuels Système de sécurité populaires d'autres marques

Inner Range

Inner Range Concept 2000 Manuel utilisateur

Climax

Climax Mobile Lite R32 Instructions de montage

CADDX

CADDX NX-6 Manuel utilisateur

FBII

FBII XL-31 Series Manuel utilisateur

Johnson Controls

Johnson Controls PENN Connected PC10 Manuel utilisateur

Aeotec

Aeotec Siren Gen5 Manuel utilisateur

Blaupunkt

Blaupunkt SA 2700 Manuel utilisateur

IDEAL

IDEAL Accenta Manuel du propriétaire

AJAX

AJAX DoubleButton Manuel utilisateur

Swann

Swann SW-P-MC2 Manuel utilisateur

Ecolink

Ecolink Siren+Chime Manuel utilisateur

Digital Monitoring Products

Digital Monitoring Products XR150 Manuel utilisateur

EDM

EDM Solution 6+6 Wireless-AE Manuel utilisateur

Highway Safety Group

Highway Safety Group EA401 Manuel utilisateur

Siren

Siren LED GSM Manuel utilisateur

Detection Systems

Detection Systems 7090i Instructions de montage

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manuel utilisateur

Siemens

Siemens FDM273 Manuel utilisateur