When arming
the anti-theft
system, lights
and controls,
always use the
blue keyfob to
operate.
www.coastercycles.com p. 16
www.coastercycles.com p. 17
START YOUR RIDE
1. 360ºINSPECTION
Startwith a 360º visual inspection of the Coaster
ECT and its surroundings before each ride to
ensure safe and smooth operation. Check for
any obstructions in the path of the tires and
chassis. Make sure all doors are securely closed.
Check tires for proper ination (See page 27).
Inspect and manipulate the wheels to ensure
they are secure, with noe lateral movement.
3. INSTALL BATTERY
Verify the battery is secure and fully charged
before riding.
For models with secondary lighting, be sure
the auxiliary battery is charged and installed
properly.
2. ADJUST
Adjust your saddle height with the quick release
located on the seat post collar.
Standing next to the bike, start with the seat
at hip height and adjust based on preference.
Mount the Coaster ECT and verify the setup suits
your riding position. Never extend the seat post
past the minimum insertion line.
If your Coaster model (Parcel AW & Freighter AW)
comes equipped with mirrors, make adjustments
to maximize sightlines and reduce blind spots.
4. POWER
Power on the lighting and electrical system by
passing the blue Radio-Frequency Identication
(RFID) keyfob over the receiver located in the
upper right-hand corner of the rider cockpit.
Verify that all lights and displays are working.
Coaster AW Models: Always swipe the blue
keyfob before any movement or ride. The alarm
WILL sound if not rst disarmed with the keyfob.
Note: The Venture and Freighter do not need the
RFID key for start up operation.
5. RIDING MODE
Turn on the power to the Controller by pressing
the power button. Adjust controls while in a
stable position.
Use the “+” and “-” keys to select riding mode.
See page 25 for detailed instructions.
6. BRAKE & WHEEL RELEASE
Release the front parking brake by compressing
the brake lever and turning the lock clockwise.
Release the rear parking brake by compressing
the brake lever until the brake lock disengages
Ensure that the front frame lock is disengaged
using the appropriate key.
8. GET MOVING
Sit on the saddle with both hands on the
handlebars and both feet on the pedals. Change
the controller to the eAssist mode you would
like to use, and you are ready to start pedaling.
Use your signals (hands and/or lights) to pull
into the bike lane or roadway. Lastly, enjoy
your day!
Use the Troubleshooting Guide on
page 32-33 for help with starting your
Coaster ECT.
7. SHIFTING
At any time, the eShift can be used for less or
more assistance. This is helpful depending on
the load and terrain. Especially with heavier
loads, stop pedaling when you shift to lessen
torque on the drive unit.
For models with automatic shifting, preferred
cadence can be adjusted through the onboard
computer.
FINISH YOUR RIDE
1. PARKING
Find a secure place to park your Coaster ECT
out of pedestrian and vehicle traffic. When
possible, reverse park for safe maneuvering
and exiting for your next ride.
5. POWER DOWN
If you are not able to park your Coaster ECT in a
secure area, the Parcel and Freighter AW models
have a 12 volt auxiliary battery that operated
an anti-theft system. This battery should be
charged daily but could be used overnight to
keep the anti-theft armed. Always verify this
battery is charged before starting the next day.
2. BRAKING
Engage both parking brakes and frame lock:
1. Compress the front brake and turn the lock
counterclockwise.
2. Compress the rear brake and engage the
parking lever.
3. Engage the frame lock around the front wheel.
See more information on the operation of all
brakes on page 26.
4. BATTERY CHARGE
Turn o the Bosch battery and remove it from
the battery holder. In a safe and well ventilated
area, plug it into the charger. You can leave the
battery connected to the bike if you are close
to a power source. See page 22 for charging
specics.
If your Coaster model has the 12 volt auxiliary
battery, take it out of the compartment and
charge nightly.
3. CARGO LOCK
Close and lock all cargo doors with the
designated key on the keyfob keyring.
