CMD Ltd, Rotherham, S65 1EN, UK
Additional information
• Ensure the screws used for installation are suited to the furniture material. Contact your furniture supplier for a recommendation if necessary.
• Installation is to be carried out in accordance with relevant Health & Safety regulations and only to be carried out by a skilled or competent person.
• Product to be used only for the intended purpose of supporting power and data cables in ofce and commercial environments.
• Do not misuse the product because doing so will invalidate the warranty.
Safety
• Clean using a dry cloth. No abrasives or solvents to be used on the product.
• Do not drop or expose to moisture.
Product care
Offer up the cable to the
rst connecting block at
either the top or bottom
of the desk.
Flex the connecting
block open and feed in
the cable as shown.
The sides of the connecting blocks can be exed outwards to allow cables to
be inserted. Be careful not to over-ex or breakage may occur.
The Cableway can accommodate 5x Ø8mm cables per channel with adequate
space around and 1x Ø16mm conduit per channel.
Cableway is designed to allow power and data cables to be segregated as
shown.
The cables shown being inserted into the connecting block. It is advised to
keep power and data cables segregated if possible.
Repeat the process until
the cable can be fed out
of the last connecting
block.
Cable management Cable/conduit capacity
Connecting block plan view
Connecting block plan view
Ø16mm conduitØ8mm cable
Power cables Data cables
