Climate Technologies TEK600 Series Manuel utilisateur

TEK600 SERIES CONTROL

Owner’s Manual

Using the

Ducted Evaporative Air Conditioning

with Your

Manual or Thermostat Control

Operating, Installation & Maintenance

Please keep this important manual in a safe place. It is the owner’s responsibility to

ensure that regular maintenance is carried out on this Evaporative Air Conditioner.

Failure to do so will void all guarantees beyond statutory and legal requirements.

www.climatetechnologies.com.au

OWNER’S MANUAL

Contents

TEK600 SERIES CONTROL Page 2

Contents

CONTENTS................................................................................................................ 2

CONGRATULATIONS ON YOUR CHOICE ........................................................................ 4

DUCTED EVAPORATIVE AIR CONDITIONER.......................................................... 5

INTRODUCTION.......................................................................................................... 6

Exhaust ............................................................................................................... 6

Bleed-off.............................................................................................................. 7

OPERATING THE CONTROLS.................................................................................. 8

PROGRAMMABLE THERMOSTAT CONTROL .................................................................. 8

Manual Operation................................................................................................ 8

Fan Only .......................................................................................................... 8

Fan & Pump..................................................................................................... 8

Turning off Unit ................................................................................................ 8

Ventilation............................................................................................................ 8

Automatic Operation............................................................................................ 8

The Timer............................................................................................................ 9

Timer ON ......................................................................................................... 9

Timer OFF........................................................................................................ 9

MANUAL CONTROL................................................................................................ 10

MANUAL OPERATION............................................................................................... 10

Operating the unit with the manual controller..................................................... 10

Ventilation.......................................................................................................... 10

UNIT MAINTENANCE.............................................................................................. 11

FILTER PADS .......................................................................................................... 11

UNIT WATER RESERVOIR......................................................................................... 11

WATER LEVEL / FLOAT VALVE.................................................................................. 11

MOTOR AND FAN..................................................................................................... 11

ELECTRICAL............................................................................................................ 11

BLEED OFF............................................................................................................. 11

PUMP..................................................................................................................... 11

WATER DISTRIBUTION ............................................................................................. 12

PROBLEM SOLVING ................................................................................................. 12

CONTROL SETUP & COMMISSIONING................................................................. 13

SAFETY.................................................................................................................. 13

BEFORE COMMENCING............................................................................................ 13

Packaging.......................................................................................................... 13

Is the control system correct?............................................................................ 13

CONTROL LOCATION ............................................................................................... 14

Manual Control.................................................................................................. 14

OWNER’S MANUAL

Contents

TEK600 SERIES CONTROL Page 3

INSTALLING THE CONTROL....................................................................................... 14

TEK 600 WIRING DIAGRAM..................................................................................... 15

MANUAL WALL CONTROL – SETUP OPTIONS............................................................. 16

Dump Valve....................................................................................................... 16

Multiple Unit Connection.................................................................................... 16

Minimum / Maximum Speed Adjustment............................................................ 16

PROGRAMMABLE THERMOSTAT CONTROL – SETUP OPTIONS .................................... 17

Options.............................................................................................................. 17

Parameter Settings Table.................................................................................. 18

Entering the Parameter Setting Mode................................................................ 19

Setting the dump delay...................................................................................... 19

Setting the Pre-cool........................................................................................... 19

Setting the Dump Interval Cycles....................................................................... 20

Setting the Pre-fill (2 + 4 hour light on and the Auto light flashing)..................... 20

Reviewing Programmed Settings....................................................................... 21

Setting the Thermostat Control Minimum / Maximum speed settings................. 22

HAND OVER......................................................................................................... 23

COMMISSIONING CHECK LIST................................................................................... 24

General.............................................................................................................. 24

Unit - Ducted Evaporative Air Conditioner.......................................................... 24

Ductwork ........................................................................................................... 24

Site.................................................................................................................... 24

Customer Hand Over......................................................................................... 24

WARRANTY............................................................................................................. 25

PRODUCT WARRANTY STATEMENT........................................................................... 25

Conditions and Exclusions................................................................................. 25

WARRANTY ON REPLACEMENTS PARTS. .................................................................. 26

PERIOD OF WARRANTY – YEARS ............................................................................. 26

PROOF OF PURCHASE............................................................................................. 26

DEALER / PRODUCT INFORMATION ........................................................................... 26

SERVICE................................................................................................................. 27

OWNER’S MANUAL

Introduction

TEK600 SERIES CONTROL Page 4

CONGRATULATIONS ON YOUR

CHOICE

We are delighted you have chosen an air conditioning product from Climate

Technologies to cool your home. It’s an air conditioner we’re very proud of. Designed

and made in Australia by Climate Technologies, a 100% Australian owned company, it

contains the latest advances in Fresh Air Conditioning technology in a stylish,

attractive cabinet.

Climate Technologies is constantly researching and developing improved product

features and therefore reserves the right to change specifications without notice.

E.&O.E.

OWNER’S MANUAL

Ducted Evaporative Air Conditioner

TEK600 SERIES CONTROL Page 5

Ducted Evaporative Air Conditioner

OWNER’S MANUAL

Ducted Evaporative Air Conditioner

TEK600 SERIES CONTROL Page 6

INTRODUCTION

The Ducted Evaporative Air Conditioner is engineered to meet the rigors of our harsh

Australian environment. Operated and maintained in accordance with this manual, it

will provide you with years of quiet, cool and environmentally friendly operation.

Please take the time to read this manual.

The principal of your unit is to introduce fresh air, which is washed through the filter

pads to provided cool fresh air. The air is exhausted taking with it any heat loadings

on the home.

Exhaust

It is essential for successful operation of evaporative air-conditioning that there be

sufficient exhaust openings in the area to be ventilated. Open doors and windows will

usually provide this.

The minimum exhaust opening should be as per the table guide set out below. It is

recommended that ceiling vents or exhaust fans be used where there is any doubt

about there being sufficient exhaust area available. Ceiling exhaust fans or ceiling

vents should have a capacity equivalent to that of the air conditioner.

MODEL MINIMUM

EXHAUST AREA

Small Cabinet 0.80 m²

Medium Cabinet 1.43 m²

Large Cabinet 1.75 m²

OWNER’S MANUAL

Ducted Evaporative Air Conditioner

TEK600 SERIES CONTROL Page 7

Bleed-off

All evaporative air conditioners need some water bleed-off to prevent build-up of

mineral deposits in the system. The correct setting of the bleed rate will ultimately

govern the life of the unit.

With normal town water supply, bleed rate should be adjusted so that the discharge is

not less than approximately 10 litres per hour. Increased water hardness may require

a higher bleed rate and increased maintenance.

The method for setting the bleed rate is to adjust the patented DIALFLO unit located

externally on the unit.

It is recommended to plumb the bleed-off away from the unit to a down-pipe in

situations where the discharge may cause unsightly stains, e.g. Colorbond Roofs.

Note: To control water volume to filter pad rotate the filter dial anti-clockwise for more

water and clockwise for less water. To control bleed-off rate rotate bleed dial

clockwise for more water and anti-clockwise for less water.

Note: Always set the water volume to the filter first before setting the bleed off rate.

OWNER’S MANUAL

Controls Operation

TEK600 SERIES CONTROL Page 8

Operating the Controls

Your ducted evaporative air conditioner has been supplied with either the 4-button

Programmable Thermostat control, or the 2 button manual control

PROGRAMMABLE THERMOSTAT

CONTROL

The Programmable Thermostat controller has two modes, MANUAL or AUTOMATIC.

In addition it has a TIMER, which will operate in either mode.

Manual Operation

Fan Only

Pressing the FAN button once will turn on the

green fanlight and will start the fan only. The

variable speed dial will vary the speed of the

fan.

Fan & Pump

Pressing the COOL button once will turn on the

green cool light and will start the fan and pump.

The variable speed dial will vary the speed of

the fan.

*NOTE: When the COOL button is pressed there may be a two or three minute delay

in start up if PRE-FILL, or PRE-COOL has been selected in the set up of the

controller. This is indicated by a flashing green light next to the COOL button or

AUTO button. For more information on these features contact your nearest Climate

Technologies dealer or from place of purchase.

Turning off Unit

To switch the unit off, press the button that has the green light. This light will then go

out to indicate the unit is off.

Ventilation

On days of high humidity, your unit may operate more efficiently in ventilation mode.

To start the FAN ONLY press the fan button.

Use the dial to control the comfort level required (speed of the fan).

Automatic Operation

•To select AUTOMATIC mode press the AUTO button. The green light will be on to

indicate that the unit is in the auto mode.

•To select the desired comfort level use the dial . The dial does not control the

speed of the fan this is done automatically by the controller.

Note: The comfort level is individual to each situation and location. Some trial

and error may be required to set the dial to your desired comfort level; a

good starting point is to have the dial set at the Nine o'clock position. Once

the unit has been set, the fan speed and pump are controlled automatically.

The unit can be left and will cycle on and off to keep the area being cooled

to the set comfort level.

•Around the edge of the dial there is a marking, for more cooling turn the dial

clockwise to where the marking increases in size. If the room temperature is too

cold turn the dial anti-clockwise for less cooling (a warmer comfort setting).

OWNER’S MANUAL

Controls Operation

TEK600 SERIES CONTROL Page 9

The Timer

The timer function operates either in Automatic or Manual modes and is designed to

switch the unit ON or OFF in a pre-set period (two, four or eight hours).

Note: Once the time function has activated or deactived the unit, it will remain in this

mode until another selection has been made at the wall control.

Timer ON

•To switch the unit ON in a pre-set time, firstly select FAN, COOL, or AUTO. Adjust

the dial to your selected position. Press the same button again to turn the unit

back to the off mode.

•Select the desired time to switch the unit back on in two, four, or eight hours by

pressing the TIMER button until your selected time appears which is indicated by

the green light.

•The option that has been selected will begin to flash rapidly. This is indicating to

the user that the mode selected will start in the selected time.

•If the owner wants to start the unit instead of waiting for the timer, press the button

that the green light is flashing once then press the same button once more to start

the unit. This can be indicated by the green light coming on near the button

selected.

*NOTE: Repeated TIMER button presses selects the desired time and also disables

the timer. The green lights near the two, four, or eight-hour time selections must be

illuminated else the timer is in the disabled mode.

Timer OFF

•The timer off mode will switch off the unit in the selected two, four, or eight hours.

•While the unit is running press the TIMER button to select the two, four, or eight-

hour time option.

•Once the time mode has been selected the unit will turn off in the selected time

period and remain in the off mode until pressing one of the function buttons (FAN,

COOL, OR AUTO) to restart it.

*NOTE: Repeated TIMER button presses selects the desired time and also disables

the timer. The green lights near the two, four, or eight-hour time selections must be

illuminated else the timer is in the disabled mode.

OWNER’S MANUAL

Controls Operation

TEK600 SERIES CONTROL Page 10

Manual Control

MANUAL OPERATION

This controller is a manually operated wall switch.

•Pressing the FAN button once will turn on the

green fanlight and start the fan. Use the

variable speed dial to adjust the speed

of the fan.

•To turn the fan mode off press the FAN button

once, the green fan light will turn off indicating

that the fan has been turned off.

•Pressing the COOL button once will turn on the

green cool light and start the pump.

•To turn the cool mode off press the COOL button once, the green cool light will

turn off indicating that the pump has been turned off.

Operating the unit with the manual controller.

•When operating the unit, press the COOL button once to start the pump, which will

wet the filter pads ready for cooling the home. After two minutes press the FAN

button once to start the fan, and use the variable speed dial to adjust the

speed of the fan.

Ventilation.

On days of high humidity, your unit may operate more efficiently in ventilation mode.

To start the FAN ONLY, press the fan button .

Use the dial to control the comfort you level required (speed of the fan).

Autres manuels pour TEK600 Series

Table des matières

Autres manuels Climate Technologies Climatiseur

Climate Technologies

Climate Technologies Add-on Refrigerated Air Conditioning Manuel utilisateur

Climate Technologies

Climate Technologies PNE2002 Series Manuel utilisateur

Climate Technologies

Climate Technologies Bonaire Cool Change Series Manuel utilisateur

Manuels Climatiseur populaires d'autres marques

Spheros

Spheros CC 355 Manuel utilisateur

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manuel utilisateur

Panasonic

Panasonic CS-E12HKEW Manuel utilisateur

nedis

nedis ACMB1WT7 Manuel utilisateur

Samsung

Samsung AR KV Series Mode d’emploi

Daikin

Daikin FCFV50A Manuel utilisateur

Fujitsu

Fujitsu Inverter ASBA30JFC Manuel utilisateur

Toshiba

Toshiba RAS-M10SMUV-E Manuel utilisateur

Daikin

Daikin FXLQ20MAVE Manuel utilisateur

Hitachi

Hitachi RAS-E24CAK Manuel utilisateur

CIAT

CIAT Magister 2 Series Mode d’emploi

Bestron

Bestron AAC6000 Manuel utilisateur

Hisense

Hisense 7K Manuel technique

Frigidaire

Frigidaire FFRE0533S1E0 Manuel utilisateur

Samsung

Samsung AS09HM3N Manuel utilisateur

Frigidaire

Frigidaire CRA073PU11 Manuel du propriétaire

Soleus Air

Soleus Air GB-PAC-08E4 Manuel utilisateur

McQuay

McQuay MCK020A Manuel utilisateur