CLEAR DESIGN BOOST PRO BP-1 Manuel utilisateur
BP-1
BOOST PRO
FACING WORKSTATION
Includes Add-Ons: A1 | A2 | A3 | A4
General Installation Guide
Watch Entire
Install Video
TABLE OF CONTENTS
EDITION CODE
BP-1 :: Power Setup.................................................................1
BP-1 :: Facing Workstation ................................................ 13
ADD-ONS
A1 :: Return Surface............................................................. 25
A2 :: Adjustable Panel Brackets...................................... 33
A3 :: Beam-Mounted Divider Clippers ......................... 37
A4 :: Steel End Panel ........................................................... 41
1
POWER FOR
48" WORKSTATION
OVERVIEW
BOOST Pro Workstation
Quantities are for a single facing workstation.
Parts may vary depending on project, but install
steps will remain the same.
Scan to
Watch Section
2
POWER FOR 48" WORKSTATION
BOX CODE QTY DESCRIPTION
BPROTPB
1Module Mounting Plate (Short)
2Power Module Bracket
1Power Beam
4Machine Screw
4Machine Screw
1Power Beam Plate
PRODB 1Double Power Block
PROR 4Duplex Receptacle
PROJ 1Jumper
PARTS LIST
3
POWER FOR 48" WORKSTATION
Scan to
Watch Step
1 | ATTACH DUPLEX RECEPTACLES TO DOUBLE
POWER BLOCK
With duplex receptacle tab on top, slide receptacle towards outside of
double power block securing within block section. Duplex receptacle tab
will snap and lock into place. Repeat for all sides.
2 | ATTACH POWER ASSEMBLY TO MODULE
MOUNTING PLATE
Place power module on top of module-mounting plate. Slide first power
module bracket over power module. Secure with 2 screws. Repeat for
other bracket.
Note: Do not over torque screws.
Scan to
Watch Step
4
POWER FOR 48" WORKSTATION
Scan to
Watch Step
3 | CONNECT JUMPER TO POWER ASSEMBLY
Determine where the bigger jog is located on mounting plate and connect
thicker end of jumper to any one of the double power block prongs.
Greater Jog Lesser Jog
4 | ASSEMBLE POWER BEAM
Remove both magnetic strips and place to side. Slide inner beam inside
of outer beam and adjust accordingly.
Inner Beam
Outer Beam
Scan to
Watch Step
5
POWER FOR 48" WORKSTATION
5 | INSERT ASSEMBLED POWER INTO POWER BEAM
Insert and guide jumper through opposite end of beam. Pull jumper out
from other side. Connect mounting plate to power beam using 4 screws.
Place both magnetic strips back on power beam.
Module Mounting Plate
Infeed Source
Scan to
Watch Step
6
END OF POWER FOR 48" WORKSTATION SECTION
Scan to
Watch Step
OPTIONAL | POWER BEAM PLATE
Only install if data is not being used. Disregard otherwise.
7
POWER FOR
54"–72" WORKSTATIONS
OVERVIEW
BOOST Pro Workstation
Quantities are for a single facing workstation.
Parts may vary depending on project, but install
steps will remain the same.
Scan to
Watch Section
Autres manuels pour BOOST PRO BP-1
1
Table des matières
Autres manuels CLEAR DESIGN Ordinateur de bureau
