Classique CLS64K Manuel utilisateur
User Manual for
your Classique
600mm Ceramic Cooktop
CLS64K
NOTE: This user manual contains important information including safety &
installation points which will enable you to get the most out of your Classique
appliance. Please keep it in a safe place so that it is readily available for future
reference.
Contents
Environmental note
1
Important safety information
2
Specifications
5
Product and aperture dimensions
5
Product specifications
5
Standard accessories
6
Electrical details
6
Ceramic hob surface layout
6
Control panel
7
Using the ceramic hob
7
Before first use
7
Control knobs
8
Switching on a cooking zone and setting a power level
8
Residual heat indicators
9
Hob guidelines
9
Cleaning and maintenance
10
Cleaning the ceramic hob top
10
After each use
11
Cleaning table
11
Using a ceramic hob scraper
11
Using a specialist ceramic hob cleaner
12
Installation
12
Positioning
12
Unpacking the appliance
Installing the appliance
Electrical connection
13
13
15
Connecting the mains supply cable
16
Replacing the mains supply cable
18
My appliance isn’t working correctly 18
Warranty card 20
1
Environmental note
o The packaging materials that we use are environmentally friendly
and can be recycled.
o Please discard
environment. all packaging material with due regard for the
2
Important safety information
Your safety is of the utmost importance to us. Please make sure
that you read this instruction booklet before attempting to install
or use the appliance. If you are unsure of any of the information
contained in this booklet, please contact the Retailer where you
purchased your unit from.
General information
o This appliance is designed for domestic household use and for the
cooking and frying of domestic foodstuffs.
o IMPORTANT: The adjacent furniture and all materials used in the
installation must be able to withstand a minimum
temperature of 85°C above the room’s
it is located in, whilst in use. ambient temperature that
o Certain types of vinyl or laminate kitchen furniture are particularly
prone to heat damage or discolouration at temperatures below the
guidelines given above.
o Any damage caused by the appliance being installed in
contravention
the owner. of this temperature limit, will be the liability of
o Your new appliance is guaranteed against electrical or mechanical defects,
subject to certain exclusions that are noted in the Conditions of
Guarantee. The foregoing does not affect your statutory rights.
o The use of this appliance for any other purpose or in any other environment
without the express agreement of the manufacturer will invalidate any
warranty or liability claim.
o You should not use this appliance to store items on or as a work surface.
o No modifications to the appliance are permitted by the manufacturer.
o You should not store or place flammable or highly flammable
liquids/materials on top of or near the appliance. Items made
from aluminium, plastic or plastic film should also be
from the appliance, as they may fuse to the surface. kept away
3
o Repairs may only be carried out by an Authorised Service Agent. Go
to www.applico.co.nz to locate a Service Agent nearest to you.
Child Safety
o We strongly recommend that babies and young children are prevented
from being near the appliance and not allowed to touch the appliance at
any time. During and after use, all surfaces will become hot.
o If it is necessary for younger family members to be in the kitchen, please
ensure that they are kept under close supervision at all times.
o Older children should only be allowed to utilise the appliance when
supervised.
General Safety
o The appliance should only be installed and connected by a suitably
qualified person.
o The appliance should only be repaired by a qualified technician in
accordance with the current regulations.
o Care should be taken to ensure that the units and work surfaces that you
build the appliance into, meet with the relevant standards.
o If you notice any scratches, splits or cracks in the ceramic glass, you should
immediately switch off the appliance and disconnect it from your mains
supply. Otherwise there is the risk of electric shock occurring.
During use
o Any film or stickers that are present on the hob surface when it is
delivered should be removed before use.
o Care should be used when utilizing the appliance, otherwise there is a
risk of burns.
o You should not allow the electrical connection cables to come into
contact with the hob surface or any cookware when it is hot.
o If fat and oil overheats, then it can ignite extremely quickly. For this reason,
when cooking with fat and oil the appliance should not be left unattended.
4
o Make sure that all of the cooking zones are switched off after use.
Cleaning
o Cleaning of the hob should be carried out on a regular basis.
o IMPORTANT: Before attempting to clean the appliance, it should be
disconnected from the mains and cool.
o Great care should be taken whilst using this appliance and when following
the cleaning procedure.
o You should not use a steam jet or any other high pressure cleaning
equipment to clean the appliance.
Installation
This appliance must be correctly installed by a suitably
qualified person, strictly in accordance with the
manufacturer’s instructions. Please see the specific section
of this booklet that refers to installation.
o We decline any responsibility for injury or damage, to person or
property, as a result of improper use or installation of this
appliance.
Declaration of conformity
This appliance complies with the following European Directives:
-73/23/EEC dated 19/02/1973 Low Voltage Directive.
-89/336/EEC dated 03/05/1989 EMC Directive inclusive of
Amending Directive 92/31/EEC.
-93/68/EEC dated 22/07/1993 CE Marking Directive.
-89/109/EEC dated 25/01/1992 Materials that can touch food.
o The manufacturer declares that the hob is built using certified materials and
requires the appliance to be installed in accordance with the standards
currently in force. This appliance must be used by a trained person for
domestic purposes only.
To avoid damaging your appliance
o The ceramic glass can be damaged by objects falling onto it.
o The ceramic glass edge can be damaged by knocks from cookware.
5
o Cast iron and cast aluminium cookware with damaged bases may
scratch the ceramic surface if they are dragged across it.
o Pans should be lifted on and off the hob surface and not dragged.
o Cooking zones should not be switched on without cookware placed on
it. Also the cookware should not be empty.
Specifications
Product dimensions:
Depth: 520 mm
Width: 590 mm
Height: 55 mm
Aperture dimensions:
Depth: 490 mm
Width: 560 mm
Product specifications:
o 2 x 1.80 kW radiant zones
o 2 x 1.20 kW radiant zones
o Side control operation
o 4 x Individual residual heat indicators
o Frameless
6
Standard accessory
o Ceramic hob scraper
Electrical details
Rated Voltage: 230 Vac 50 Hz
Supply Connection: 30 A (double pole switched fused outlet with
3mm contact gap)
Max Rated Inputs: 6.00 kW
Mains Supply Lead: 3 core x 4 mm² (not supplied)
For future reference please record the following information which can be found
on the rating plate and the date of purchase which can be found on your sales
invoice. The rating plate of your hob is located on the underneath of the
appliance. Therefore it is a good idea to record this information before you install
your appliance.
Model Number …………………………….
Serial Number …………………………….
Date of Purchase ……………………………
Ceramic hob surface layout
A
=
1.80 kW radiant zones
B
=
1.20 kW radiant zones
C
=
Control panel
7
Control panel
Using the ceramic hob
Before first use
IMPORTANT: You should clean the ceramic hob surface (see
“Cleaning and maintenance” section).
o You should switch on one cooking zone at a time, for 5 minutes at the
maximum setting. This will help to eliminate any new smell that exists
and evaporate any humidity that has formed on the heating elements
during transit.
o Do not burn off more than one zone at once.
o You must place a saucepan filled half full with cold water on each
zone as you burn it off.
8
Control knobs
o All operations are performed by means of the 4 control knobs that can
be found on the right hand side of the hob top.
o The control knob should be turned anti-clockwise or clockwise to select a
heating level. The dots around the outside of each control knob
indicate the power level that you have set the zone to.
o A marking to the top left of each control knob, indicates which cooking zone
that it controls.
oThe control panel and knobs should only be cleaned with mild detergent
and a soft cloth to prevent any damage to the serigraphy which will not be
covered by warranty.
Switching on a cooking zone and setting a power level
o Turn the control knob of the cooking zone that you wish to cook on. The
control knob can be turned anti-clockwise or clockwise.
o The smaller dots indicate the coolest cooking zone settings and the
larger dots indicate the hottest cooking zone settings.
o When you have finished cooking, make sure that you turn the control knob
to the OFF position.
Table des matières
Autres manuels Classique plaque de cuisson
