Clarion Ungo Pro Security K10 Manuel utilisateur
Model K10
➤
OOwwnneerr’’ssGGuuiiddee
limited lifetime consumer warranty
This Ungo Pro Security system is warranted against defects in material and workmanship.
The main unit is covered by this limited lifetime warranty. This Limited Lifetime
Warranty applies to Ungo Pro Security systems that have been installed by an authorized
Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to
the original vehicle in which it was installed into. This warranty is not transferable to any
subsequent owner(s) of the product(s).
WWaarrrraannttyyPPrrooggrraamm::
Main Unit Limited Lifetime
Remote Controls One year from date of purchase
Siren One year from date of purchase
Shock Sensor One year from date of purchase
LED One year from date of purchase
Override Switch One year from date of purchase
The Warranty does not cover batteries or products deemed damaged through alterations
or installation. It also does not cover products mishandled, misused, neglected, abused,
water damaged, or with removed/altered serial numbers.
PROOF OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE OF
THIS PRODUCT.
This warranty does not cover the costs incurred for removal or reinstallation of the main
unit and/or any damage to the vehicle or the vehicle's electrical system.
The sole responsibility of Clarion Corporation of America ("Clarion") under this
Warranty shall be limited to the repair or replacement of the product, at the sole
discretion of Clarion.
If it becomes necessary to send the product or any defective part to Clarion, the product
must be shipped in its original carton or equivalent carton, fully insured, with shipping
charges prepaid. Clarion will not assume any responsibility for any loss or damage
incurred in shipping.
ALL IMPLIED WARRANTIES EXCEPT TO THE EXTENT PROHIBITED BY
APPLICABLE LAW SHALL HAVE NO GREATER DURATION THAN THE
WARRANTY PERIOD SET FORTH ABOVE. UNDER NO CIRCUMSTANCES
SHALL CLARION CORPORATION BE LIABLE FOR ANY LOSS OR DAMAGE,
DIRECT OR CONSEQUENTIAL, ARISING OUT OF THE USE OR INABILITY
i
ii
TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW
LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLU-
SIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY
TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY
ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE.
Should you have any difficulties with the performance of this product during warranty,
please call: 1-800-GO-CLARION or visit your local Ungo Pro Security dealer. You may
also contact the National Service Manager at the following address below for additional
service help you may need.
Clarion Corporation of America
Attn: National Service Manager
661 W. Redondo Beach Blvd.
Gardena, Ca 90247
1
table of contents
limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i
standard remote configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
what is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
system maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3
fcc/id notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
remote functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
standard configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
using your system . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
locking/arming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
unlocking/disarming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
disabling the system without a remote . . . . . . . . . . . . . . . . . . . . . . . . . . .8
silent arm/disarm . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
override mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
panic mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
individual recognition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
power-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10
programming options . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11
glossary of terms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
security & convenience expansions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12
2
standard remote configuration
controls the Arm function.
controls the Disarm function.
controls Silent Arm/Disarm and an Auxiliary Output.
controls the Panic function.
and pressed together control an Auxiliary Output.
3
what is included
zThe control module
zSuperhet receiver
zA pair of four-button remotes
zThe blue status LED indicator light
zA push-button override switch
zStarter Kill Relay
important information
Congratulations on the purchase of your alarm/keyless entry system.
Due to the complexity of this system, it must be installed by an autho-
rized dealer only. Installation of this product by anyone other than an
authorized dealer voids the warranty.
By carefully reading this Owner's Guide prior to using your system, you
will maximize the use of this system and its features.
system maintenance
The system requires no specific maintenance. Your remote is powered
by a small, lightweight 3-volt lithium battery that will last approximately
one year under normal use. When the battery begins to weaken, oper-
ating range will be reduced and the LED on the remote will dim.
4
fcc/id notice
This device complies with Part 15 of FCC rules. Operation is subject to
the following conditions: (1) This device may not cause harmful inter-
ference, and (2) This device must accept any interference received,
including interference that may cause undesirable operation.
Changes or modifications not expressly approved by the party respon-
sible for compliance could void the user's authority to operate this
device.
remote functions
The receiver uses a computer-based learn routine to learn the remote
buttons. This makes it possible to assign any specific remote button, or
combination of buttons, to any receiver function. The remote initially
comes programmed with the Standard Configuration, but may also be
customized by an authorized dealer. The remote buttons indicated in all
of the instructions in this manual correspond to a Standard
Configuration remote.
standard configuration
Button
The locking/arming function is controlled by pressing this button for
one second.
5
Button
The unlocking/disarming function is controlled by pressing this button
for one second.
Button
Silent Arm/Disarm and an optional auxiliary function are controlled by
this button. (An optional auxiliary function, such as trunk release, can
be controlled by pressing this button for 1.5 seconds.)
The auxiliary output controls __________________________.
Button
The panic feature is controlled by pressing this button for one second.
and Buttons
An optional auxiliary convenience or expansion function that you have added
to your system can be activated by pressing these buttons simultaneously.
The auxiliary output controls _________________________.
6
using your system
locking/arming
Pressing for one second arms the system by activating the starter
kill and locking the doors (if connected). The horn will honk (if con-
nected) and the parking lights will flash once to confirm arming of the
system. While the system is armed, the status LED will flash once per
second. The Starter Kill (if installed) will also prevent the vehicle’s starter
from cranking.
The system can also be programmed to arm the optional Starter Kill
automatically (called Passive Mode). If the system has been pro-
grammed for Passive Mode, the Starter Kill will automatically activate
30 seconds after the ignition has been turned off. After the ignition has
been turned off, the status LED will flash rapidly to indicate that the sys-
tem is in Passive Mode.
If Passive Mode has been programmed on, then it is also possible to pro-
gram the system for Passive Locking. With Passive Locking, the vehicle
doors lock automatically at the same time that the Starter Kill is acti-
vated. If Passive Locking is programmed on, care must be taken to pre-
vent the keys from being locked in the vehicle.
nnoottee::For Passive Mode to be effective, the Starter Kill relay
must be installed.
nnoottee::Manually locking the vehicle does not arm the system;
it will only lock the doors.
7
unlocking/disarming
Pressing for one second disarms the system and unlocks the doors
(if connected). The horn will honk twice (if connected) and the parking
lights will flash twice to confirm disarming of the system. The optional
Starter Kill will be deactivated. The status LED will turn off, unless the
system is programmed for Passive Mode. In Passive Mode, the status
LED will flash rapidly when the system is disarmed. This indicates that
the system will re-engage the starter kill and re-lock the doors (if Passive
Locking has been programmed) in 30 seconds unless the ignition is
turned on.
nnoottee::If the system has been armed with the remote, you must
use the remote or the Override switch to disarm the system
and deactivate the starter kill. Manually unlocking the vehi-
cle does not disarm the system; it will only unlock the doors.
Table des matières
Autres manuels Clarion Démarreur à distance
