CLA-VAL VC-22D Manuel utilisateur
Model VC-22D
Electronic Valve Controller
For full manual, go to:
www.cla-val.com/electronic-products
Click on the following links:
1. Valve Controllers
2. VC-22D
3. Technical Manual
4. VC-22D IOM Manual
Loosen 6 screws
1Swing blue faceplate open
2
4Aach power cables to V+/V- terminals. For input/output wiring, see full manual.
12-24 VDC (V+)
0 VDC (V-)
QuickStart
Swing blue faceplate closed
5
Tighten 6 screws
6
POWER SUPPLY GREATER THAN 32 VDC WILL
DAMAGE DEVICE AND VOID WARRANTY.
USE POWER SUPPLY BETWEEN 12-24 VDC ONLY.
CAUTION
Power On Device
3Run power cable through gland.
Model VC-22D
Electronic Valve Controller
QuickStart
Load Standard ValvApp
Press le navigaon arrow to load standard ValvApp.
1Highlight North America and press OK buon.
2
Highlight desired ValvApp and press OK buon.
3Say yes to load library, and OK to restart unit.
4
If using standard ValvApp, say yes to wizard.
If using custom ValvApp from USB, say no.
5
Accessing Config Menus
See input valuesLong le
See outputs values
Long Right
Set control parametersLong Up
Set interacve variablesShort Down
“Short” = push and release quickly, “Long” = push and hold for 2 seconds
Table des matières
Autres manuels CLA-VAL Contrôleurs
CLA-VAL
CLA-VAL CDS7-DO Manuel d'instructions
CLA-VAL
CLA-VAL D35 Manuel utilisateur
CLA-VAL
CLA-VAL 130VC-2 Manuel du propriétaire
CLA-VAL
CLA-VAL CRL-60 Manuel d'instructions
CLA-VAL
CLA-VAL CPC Manuel du propriétaire
CLA-VAL
CLA-VAL VC-22D Manuel utilisateur
CLA-VAL
CLA-VAL 34 Series Manuel du propriétaire
CLA-VAL
CLA-VAL CRD-34 Manuel utilisateur
CLA-VAL
CLA-VAL e-Drive-34 Manuel utilisateur
CLA-VAL
CLA-VAL 90G-21 Manuel d'instructions
