Citronic PL2000 Manuel utilisateur

PL2000

1U STEREO POWER AMPLIFIER

Order ref: 172.114UK

User Manual

Version 1.1

Caution: Please read this manual carefully before operating

Damage caused by misuse is not covered by the warranty

172.114UK User Manual

Introduction

Thank you for choosing the Citronic PL2000 class-D power amplifier as part of your sound reinforcement

system. These high output amplifiers are designed to offer high quality, dependable service for mobile and

installed systems. Please read this manual fully and follow the instructions to achieve the best results with your

new purchase and to avoid damage through misuse.

Warning

To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.

If liquids are spilled on the casing, stop using immediately, allow unit to dry out and have checked by qualified

personnel before further use. Avoid impact, extreme pressure or heavy vibration to the case

No user serviceable parts inside –Do not open the case –refer all servicing to qualified service personnel.

Safety

•Check for correct mains voltage and condition of IEC lead before connecting to power outlet

•Ensure speaker leads are good condition with no short connections or damaged plugs

•Check impedance of speaker loads do not exceed the minimum stated load for the amplifier

•Do not allow any foreign objects to enter the case or through the ventilation grilles

Placement

•Keep out of direct sunlight and away from heat sources, damp or dusty environments

•When rack-mounting, ensure adequate support for the base of the amplifier and firm fixings for the front

•Ensure adequate air-flow and do not cover cooling vents at the front and rear of the amplifier

•Ensure adequate access to controls and connections

Cleaning

•Use a soft cloth with a neutral detergent to clean the casing as required

•Use a vacuum cleaner to clear ventilation grilles of any dust or debris build-ups

•Do not use strong solvents for cleaning the unit

Front Panel

1. Power on/off switch

2. Cooling vent

3. Channel A gain control

4. LED indicators

5. Channel B gain control

Rear Panel

6. Channel B input

7. Channel A input

8. Channel B SPK output

9. Channel A SPK output

10. Cooling fan vents

11. IEC mains power inlet & fuse

172.114UK User Manual

Setup

Connect the supplied power lead to the rear IEC inlet of the PL-series amplifier (11) and plug the other end into

a mains power socket, ensuring the correct voltage at the outlet.

Ensure that the cooling vents at front and rear (10) are not covered or obstructed in any way with adequate

space for airflow through the unit.

Operation

With CH A and CH B volume controls (3, 5) turned fully down (anti-clockwise), switch on the power (1) and the

LED POWER indicator will light (4)

Playing the input signal into CH A and CH B inputs (6, 7), gradually increase the CH A and CH B volume

controls. The amplified signal should be heard through the speakers and the SIG indicators (4) should respond

to the audio output. Increase the volume controls to the required level.

Alongside the SIG indicators are CLIP indicators, which should only light very briefly on the loudest transients or

spikes in the audio. If the CLIP LEDs light for more than a fraction of a second at a time, the volume controls

should be turned down or input signal will need to be reduced.

Before powering down, turn down the volume controls to avoid loud pops or noises through the speakers.

Specifications

Power supply

230Vac 50Hz (IEC)

Fuse

T15AL 250V

Power RMS @ 8Ω

2 x 540W

Power RMS @ 4Ω

2 x 1000W

Input connections

Combo jack/XLR balanced (L+R)

Output connections

SPK (L+R) pin 1+/1-

Frequency response

20Hz - 20kHz (±0.5dB)

THD +N

<0.05%

Damping factor

300

S/N ratio (A weighted) : line

100dB

Slew rate

20V/us

Input impedance

10k Ohms unbalanced, 20k Ohms balanced

Output circuit architecture

Class D

Protection

Temperature, short circuit, DC, overload

Indicators

Power, signal, clip

Controls

L+R level, power on/off

Dimensions

482 x 180 x 44mm

Weight

4.0kg

Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or

Electronic equipment and should not be disposed with other household or commercial waste

at the end of its useful life. The goods must be disposed of according to your local council guidelines.

AVSL Group Ltd. Unit 2-4 Bridgewater Park, Taylor Rd. Manchester. M41 7JQ

AVSL (EUROPE) Ltd, Unit 3D North Point House, North Point Business Park, New Mallow Road, Cork, Ireland.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Citronic Amplificateur

Citronic

Citronic CX-8088 170.353 Manuel utilisateur

Citronic

Citronic D Series Manuel utilisateur

Citronic

Citronic PLX SERIES Manuel utilisateur

Citronic

Citronic CX-1608 Manuel utilisateur

Citronic

Citronic Powerlite PL3200 Manuel utilisateur

Citronic

Citronic P44800 Manuel utilisateur

Citronic

Citronic H Series Manuel utilisateur

Citronic

Citronic PPX Series Manuel utilisateur

Citronic

Citronic Pro Ultima Series Manuel utilisateur

Citronic

Citronic D1000 Manuel utilisateur

Citronic

Citronic CX-8086 Manuel utilisateur

Citronic

Citronic PL Series Manuel utilisateur

Citronic

Citronic PPX900 Manuel utilisateur

Citronic

Citronic 171.231 – MA800 Manuel utilisateur

Citronic

Citronic PL720 Manuel utilisateur

Citronic

Citronic AEL Series Manuel utilisateur

Citronic

Citronic 172.248UK Manuel utilisateur

Citronic

Citronic Ultima PRO-3200 Manuel utilisateur

Citronic

Citronic PLX2000 Manuel utilisateur

Citronic

Citronic QP1600 Manuel utilisateur

Citronic

Citronic SP200 Manuel utilisateur

Manuels Amplificateur populaires d'autres marques

ASTRO

ASTRO HVO V40 P Manuel utilisateur

Marantz

Marantz SUPERSCOPE BLA-545 Instructions de montage

NAD

NAD CI980 Manuel utilisateur

Technics

Technics SE-CH770 Manuel utilisateur

Harman Kardon

Harman Kardon HK6300 Manuel utilisateur

NAD

NAD T975 Manuel utilisateur

McIntosh

McIntosh MA6850 Manuel utilisateur

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuel utilisateur

Viatron

Viatron Autrix Manuel utilisateur

GME

GME GA9800 Manuel utilisateur

Atlas

Atlas CP700 Manuel utilisateur

Roland

Roland KC-1000 Manuel utilisateur

Pyle

Pyle PFMRA350BW Manuel utilisateur

Advantage

Advantage S-250 Manuel utilisateur

IRT Electronics

IRT Electronics DVA-3007 Manuel utilisateur

Dimavery

Dimavery BA-100 Series Manuel utilisateur

Sony

Sony XM-S400D Manuel utilisateur

Schertler

Schertler ROY X Manuel utilisateur