ePARK
8Installation guide
A Important Safety Instructions
Read carefully all the instructions before starting in order to
ensure properly installation of the Charge Point.
The Charge Point is designed for installation in indoor and outdoor areas. For each of the different
conditions of installation, the unit must be installed safely and ensure adequate protection.
• Charge Point must not be installed in areas where
there is potential risk of explosions.
• Do not perform any repair o manipulation of
the unit while it is energized.
• Do not install the Charge Point where falling
objects may damage the equipment.
• Only trained and qualified personnel should
have access to low-voltage electrical parts
inside the unit.
• The surface where the Charge Point is placed must
withstand the mechanical forces.
• Check the installation annually by qualified
technician.
• This unit is no shall be used for anything other
purpose than electric vehicle charging modes as
are expected in IEC 61851.
• Remove from service any item that has
a fault that could be dangerous for users
(broken plugs, caps that don’t close...).
• Do not modify this unit. If modified, CIRCUTOR will
reject all responsibility and the warranty will be
void.
• Use only CIRCUTOR supplied spare parts.
• Comply strictly with electrical safety regulations
according to your country.
• Do not use this product if the enclosure or
the EV connector is broken, cracked, open, or
shows any other indication of damage.
• Do not use any adapter, except those approved by
the EV manufacturer.
Refer to 6.- TECHNICAL DATA section for more information about environmental installation
conditions.
2Before the installation
