6
General
Category of use:......................................AC51, AC53a
Switching Mode: .........................................Zero Cross
Input/Output Isolation Voltage:............4,000 VAC RMS
Operational Voltage Range
• 480VAC models: ................................. 24 - 530 VAC
• 600VAC models: ................................. 24 - 660 VAC
Nominal Frequency: .....................................50 - 60 Hz
Non-repetitive peak voltage
• 480VAC models: ......................................... 1200 Vp
• 600VAC models: ......................................... 1200 Vp
Zero Voltage Turn-on:.......................................... ≤20V
Activation time:............................................= 1/2 cycle
Deactivation time:........................................= 1/2 cycle
Potential drop at rated current: ................ = < 1.4 Vrms
Power factor............................................................ = 1
IP20 Protection
Inputs
VDV Input (Type “1”)
Control voltage:...........................................5 - 32 VDC
Maximum input:......< 18 mA @5 VDV to 22 mA @ 32 V
Maximum reverse voltage: ............................... 36 VDC
Activation voltage:........................................ > 4.5 VDC
Deactivation voltage:....................................... < 3 VDC
VAC Input (Type “2”)
Control voltage:.................................20 - 260 VAC/DC
Activation voltage:................................... > 15 VAC/DC
Deactivation voltage:................................. < 6 VAC/DC
Current draw:...................≤8 mAac/dc @ 260 VAC/DC
Specifications
Outputs
Specification CS3-025 CS3-040 CS3-055
Rated Current (@ 40˚C continuous service) AC51 AC53 AC51 AC53 AC51 AC53
3 X 25A 3 X 5A 3 X 40A 3 X 8A 3 X 55A 3 X 15A
Maximum Surge Current (t=20 ms) 400 A 600 A 1,150 A
Maximum I2t for fusing (blowout) 645 A2s 1,010 A2s 6,600 A2s
Critical dV/dt Off-state (minimum) 1,000 V/μs
Off-state Leakage Current (@ Rated Voltage) < 3 mA
Integrated Thermal Protection
The SSR temperature is constantly monitored. If the
maximum temperature limit (230°F/110°C) is exceed-
ed, current to the load is interrupted and the YELLOW
over-temperature condition LED illuminates.
Alarm Output Option
The Alarm Output is a Solid State Switch (isolated
contact) which controls a connected device during an
alarm event, such as a horn or light.
• Requires external 24 VAC/DC power supply
• Ratings: Imax = 150 mA
Vmax = 32 VAC/DC
Z close < 15 ȍ(impedance)
For Models with 24 VDV Input Control Signal
The alarm output function closes the isolated solid
state output switch when it detects the following fault
condition:
The control signal is active, but:
• The internal temperature limit of the SSR has been
exceeded (Alarm Option Code 1)
For Models with 20 - 260 VAC/DC Input Control Signal
The alarm output function closes the isolated solid
state output switch when it detects any of the following
fault conditions:
The control signal is active, but:
• The internal temperature limit of the SSR has been
exceeded (Alarm Option Code 1)
• There is no current on the load (zero current or inter-
rupted load) (Alarm Option Code 2)
• There is no line voltage power supply (Alarm Option
Code 2)
Environment Conditions
Operating Temperature Range: ............... -20˚C to 80˚C
Max. Relative Humidity: ............................50% @ 40˚C
Max. Installation Altitude: .........2000m above sea level
Pollution Level: ............................................................2
Storage Temperature:............................ -20˚C to +85˚C
Junction Temperature:......................................... 125˚C
This device conforms to ECC 2004/108/CE and
2006/95/CE and subsequent modifications includ-
ing with reference to product standard EN 60947-4-3
(Low-voltage switchgear and control gear – AC contac-
tors and semiconductor motor starters).
The product is designed for type A environments. Use
of the product in type B environments may cause un-
desired electromagnetic noise. In this case, the user
should take appropriate steps for improvement.
Thermal Devices, Inc. Mount Air
, Mar
land USA www.thermaldevices.com
Thermal Devices, Inc. Mount Air
, Mar
land USA www.thermaldevices.com
