Introduction
Before starting the assembly process of your new 34% Extra 300S ARF, Please read through the assembly
manual carefully, and inspect all parts and hardware for imperfections or damage.
The competition series Extra 300S is a highly aerobatic airplane designed and sold by world-renowned
aerobatic RC pilot Chip Hyde who is a multiple USA National, World and TOC champion. This plane is fully
capable of both precision aerobatics and extreme 3-D aerobatics.
The Extra features rapid assembly due to plug-on wings and plug-on stabs that not only make it quick, but
easy and accurate to construct. The wings and stabilizers slide onto pre-fitted tubes and are aligned by pre-installed
anti-rotation pins. There is a minimal amount of gluing and drilling required to complete the assembly. This greatly
reduces the time to assemble and get you to the flying field.
The Extra can be disassembled and broken down into two wing panels, two stabilizer halves and a fuselage
to facilitate transportation in almost any size of vehicle. The larger the vehicle, the less you will need to remove!
Assembly at the field is greatly simplified with easy access to the inner fuse wing retention and. One ball-
wrench, a flat blade screw driver, a couple of minutes of assembly and a tank of 2-cycle gas will get you into the air.
The plane is designed for gas motors in the 100-cc category. The recommended motor is the DA 100 that is
shown in the assembly instructions. The final choice of power plant is left up to the builder.
A computer radio is recommended for the Extra. This is primarily so the Pilot can take advantage of the full
capabilities of this plane.
Intended use
This plane should not be regarded as a toy. This is an advanced aerobatic plane and is recommended for pilots who
are well beyond the trainer-stage and are comfortable with flying at least an aerobatic sport plane.
Warranty
It is important to notify Chip Hyde Products of any damage or problems with the
model immediately. If you wish to return this aircraft for any reason a 15% restock fee will
be charged to the customer. In addition the customer is responsible for all return shipping
cost and all prior shipping cost will not be refunded. Parts will be exchanged/replaced once
the original item is returned at the owner’s expense.
If you have any problems, contact CHP at (520)-458-1414
CHP cannot insure the skill of the modeler and can not direct the builder during the
construction or use of this aircraft, therefore, will not be accountable for any property
damage, bodily injury or death caused by this aircraft.
The purchaser/operator accepts all responsibility of any and
all structural or mechanical failures.
4
