READ FIRST
To use this device in safety, he/she should follow industry standards and safety senses
whenever working on, or near the weld machine.
In some case, failure to follow the warning instructions can lead to damage. In other cases
failure to follow these instructions can lead to injury, or death of personnel.
Some examples of safe practices are listed below. These examples are not to be considered a
comprehensive listing of safety practices. Always use safety senses when working with any
type of machinery.
DANGER
1. Turn electrical power OFF, if it is necessary to open the door of the controller
when joint or remove a communication cable. Opening the door without turning
power off can lead to injury by an electric shock, or death of personnel.
Always use safety senses even if the he/she is able to work on without open the door.
2. Wiring the communication cable with catching under the machine etc. can lead
to damage and short. And remove the communication cable with taking the
connector with his/her fingers, whenever remove the cable. Do not stretch a
wires. Stretching the wires can lead to wires damage and short.
And short or damage of the wires may occur a fire or an electric shock.
WARNING
1. Cables should not be run to be damaged by other machinery. Catching foot on cable can
leads to an injury of personnel.
2. In using or storing, this device should be protected from direct sunshine, much dust, water
and high humidity.
3. This device is not put on high or unstable place. Falling down of the device can lead to a
damage and an injury.
4. Operator never operate this device. And maintenance person do not allow operator to
operate this device.
CAUTION
1. Communication cable is jointed to the controller perfectly and correctly.
2. Do not analyze, alter and repair this device.
3. If cleaning this device with thinner or benzine etc., device case may deform or fade.
