Choice Select CHO5003 Manuel utilisateur

Digital Outdoor Antenna

MODEL: CHO5003

Thanks for purchasing this CHO5003 Digital OutdoorAntenna.

Before installation, please read this manual carefully and retain

for further information.

INTRODUCTION

Model CHO5003 antenna is designed to be powered either with the

included power supply and power inserter, or in conjunction with a DBS

satellite receiver, in which case the satellite receiver supplies the power for

the antenna using two diplexers (not included).

CHO5003 is specially designed for digital terrestrial broadcasting reception. With

state-of-the-art low noise amplifier technology and circuitry, it will provide excellent reception.

With its compact and stylish housing, it can accompany your digital Set Top Box or Digital TV.

With its UV protected housing and waterproof sealing, the CHO5003 antenna can be

installed outdoors on a wall or window-shelter and with the pole mounting kit, on a wood or

metal pole. This antenna can be rotated 360 degrees to obtain the best reception.

Features:

•2 Powering methods

•Wall-mounted or pole-mounted installation

•UHF 470~870MHz

•VHF 47~230MHz

•Gain 20dB

•Low noise amplifier technology

•Water-proof and anti-UV housing

PACKAGE CONTENTS

1.CHO5003 main unit

2.Multi-directional base

3.Wall mounting package (4 plastic anchors, 4 screws)

4.Pole Mounting kit (2 U-type bolts, 4 wing nuts)

5.3m Coaxial Cable: F male (with weather boot) to F male

6.1m Coaxial Cable: F male to F male

7.AC Adaptor

8.Power inserter

9. Operation Manual

Multi-directional

Base Main Unit

Wall Mount Kit Pole Mount Kit Power Inserter Coaxial Cable AC Adaptor

INSTALLATION

Notice:

For the best reception, please check the following conditions

1. Place antenna as far as possible from potential sources of interference: i.e. large power

consumption devices, such as air conditioners, elevators, hair dryers and microwave ovens.

2. Install antenna as high as possible to provide a clear line of sight to the transmission tower:

With digital terrestrial reception, if there are obstructions between the antenna and

transmission tower, it can cause signal loss.

INSTALLATION POWERED BY THE SATELLITE RECEIVER USING (2) DIPLEXERS

Normal installation is similar to above diagram. Be certain that the satellite receiver is turned

off and disconnected from AC power prior to making any connections.

CONNECTION POWERED BY THE POWER SUPPLY AND POWER INSERTER

Step 1 Connect one F male end of the 1-meter Coaxial Cable to the F female end on

your TV Set, and the other F male end of the coaxial cable to the “receiver"

outlet of the power inserter. Connect the F male end (with weather boot) of the

3-meter Coaxial Cable to the F female end of the CHO5002 and the other F

male end of the coaxial cable to the “antenna” outlet of the power inserter.

NOTE: The 3-meter coaxial cable is provided for indoor use, for your

convenience. For most outdoor installations, additional length of RG-6

coaxial cable (not included) is required, depending on your individual

circumstances.

Step 2 Connect the barrel end of the AC-DCAdaptor to the DC input of Power inserter,

and plug the AC end into the AC Outlet. Please note: use only supplied AC

adaptor.

All the connections should be fixed and tight. It is recommended that you have a

water-drip loop at the end of the cable before entering the home.

Water-Drip Loop

(recommended)

INDOOR /OUTDOOR WALL MOUNTED INSTALLATION

Step 1 Mark the fixing position of the

multi-directional base with a pencil.

To install on a wooden wall:

Step 2 Use the screws provided to attach

the base onto the wall.

Step 3 Fix the main unit onto the base.

To install onto a brick wall or RC wall:

Step 2 Using 1/4" drill bit, drill to a depth of

1-3/8". Then clean the hole. (NOTE:

When using the electric drill, be sure

to wear proper protection. Be sure the

drill bit is fixed securely, or serious

injury could occur).

Step 3 Use a hammer to insert the provided

anchors into the holes made by step 2.

Step 4 Use a screw driver to insert the provided

screws through the base and into the

anchors.

Step 5 Fix the main unit onto the base.

POLE MOUNTED APPLICATION

Step 1 Place the 2 U-bolts around the pole, lining

up the threads of the bolts with the holes in

the multi-directional base.

Step 2 Place the base against the pole as shown

below, so that the bolt threads go through

the mounting holes on the base.

Step 3 Use the 4 provided wing-nuts to fasten the

U-bolts tightly against the pole.

Step 4 Fix the main unit onto the base.

When the installation is complete, use your TV or Set Top Box to check the

signal strength and quality. If the quality is not as expected, move the

antenna to get the best reception position. When you find the best position,

secure the antenna.

Table des matières

Autres manuels Choice Select Antenne

Choice Select

Choice Select CHO5007 Manuel

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur