3.4.Click“OK”and then click“Cancel”. Open the moveable disk again,
is an indication of successful time setting. Remove the moveable disk from the computer in the
normal way.
Note: No other operations with the motion sensor during the time setting procedure.
4. Installation and fixture：Fix the attached bracket on the proper position ofthe wall. (1.8~2.5M
above from the floor is suggested.). Connect the output terminal to the power input port of the
motion sensor, put the motion sensor onto the mounting bracket and adjust it till it gets a
proper detecting angle and recording angle.
5. Turns on and Starts：Plug the power adaptor to the outlet after detecting angle and recording
angle well adjusted. Slide the backup battery switch to right to turn on the battery, the device
will get into standby mode after a red light keep on for 30 seconds and then off.
6. Arm: Press arm key on the remote, the device has one beep and then gets into standby mode
after 8 seconds.
7. Disarm: Press disarm key on the remote, the device has two beeps and disarm the device
immediately.
8. Automatic recording: It will start a 1 minute on-site audio and video recording upon motion
trigger when standby. Ared light will keep flashing all the time when recording and will off
automatically after finish recording. Files will be saved automatically with a name including
the starting time and stopping time of recording.
9. Emergency recording: Press emergency key on the remote, the device will start recording
without sound indication. The maximum recording time is 9 minutes.A red light will keep
flashing all the time when recording and will off automatically after finish recording. Files
will be saved automatically with a name including the starting time and stopping time of
recording.
10. Recording Indication: a. A blue light will keep on for around 50 seconds after each recording
finished.
b. Every time when you disarm the armed device, a solid blue light for
a round 50 seconds means there are some new recorded file after last
arm activity. If pressing arm key, this function will be invalid automatically.
11. Playback the video files:
A. Take the SD card out from the device when standby and inset it to the computer, you can
click and playback the recorded files in the moveable disk. Then remove the SD card
from the computer in normal way and insert it to the motion sensor directly.
B.Turn off the backup battery switch of the motion sensor and connect it to the computer
with the USB cable, you can click and playback the recorded files in the moveable disk.
Note1. No any other operations while reviewing the video files.
2. Need to install supported video player , such as Storm Player, Kmplayer,Mplayer.
3. Need to set the time according to the time setting instructions every time before
you remove the alarm from the computer.
12. To add wireless accessories: Press study button on the back side of the motion alarm, after
hear a beep, trigger the wireless accessories twice consecutively, the motion alarm has 5
beeps means the wireless accessoryis successfully paired; 2 beeps means failure. If no study
operations within 20 seconds, the motion alarm beeps twice and escape from learning model.
