Troubleshooting
The product’s remaining battery level is insufficient.
(The remaining battery level indicator doesn’t flash or
only one white LED flashes when you press the power
button.)
Recharge the product.
The power button is not pressed.
Press the power button again.
The product may take time to start charging for a
certain smartphone model.
Wait for a while.
Charging is
interrupted
The charging cable is not inserted firmly.
Make sure that the charging cable is inserted firmly.
The device is not being charged in a fixed state.
Charge the device in a fixed state.
The charging cable is not an accessory item.
Use the charging cable supplied with your smartphone
or device.
●If any of these remedies do not provide successful charging,
try the following checks and contact the Email address
indicated in this manual.
①Is the device chargeable using another cable you have?
(Try using the genuine cable supplied with each device as much as possible
.)
②Is anothe r device chargeable?
Connecting
the cable
causes
charging to
start, although
I have not
pressed the
power button
This product remains on for about 2 minutes after the
power button is pressed. Therefore, if you have pressed
the power button to check the remaining battery level
before connecting the cable for example, the product may
start charging your device when you connect the cable.
(Similar phenomenon also occurs immediately after
charging this product.)
* In addition to the above phenomena, if you suspect that the product is
faulty, contact the Email address indicated in this manual. Our customer
support will be pleased to help you.
FCC Information
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by our company may cause
interference and void the user’s authority to operate the equipment.
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian ICES-003.
End of Life
If this product becomes very short time charging, even if this
product is fully charged, this product has reached the end of its
service life.
Purchase a new product (service life varies depending on use).
How to Charge This Product
Please refer to Fig. 3.
1Connect the micro-USB plug of the charging cable
(accessory) tothe“micro-USB input port” of this product.
Intended Use
Intended User
Users for mobile devices for intended use of this device.
Children must be supervised by a responsible adult for safety.
Condition for Use
Operating temperature : 14℉ - 104℉ (-10℃ to 40℃)
Part Names
①Remaining battery level indicators
②Power button
③LED button
④Micro-USB input port
⑤USB 2.1A output port
⑥USB 1A output port
●Accessories
• USB to micro-USB charging cable (for charging the product)
* To charge non-micro-USB devices, use a commercial USB cable with the type of
USB connector supported by each device.
* There are also types of devices that cannot be charged using this product.
• Carrying pouch
• Instruction Manual
Safety Precautions
Explanation of safety signal word
Warning indicates a hazardous situation that, if
not avoided, could result in death or serious injury.
Caution indicates a potentially hazardous
situation which, if not avoided, may result in
minor or moderate injury.
General Precautions
●Read all instructions prior to using this product.
●Keep this instruction for use for future use.
●Design and specifications are subject to change without notice.
●Dry location use only.
●Do not use at potentially explosive atmosphere.
WARNING
●Do not disassemble this product or attempt to re-purpose or modify it in any
manner.
●Do not short circuit this product. To avoid short -circuiting, keep this
product away from all metal objects (e.g. coins, hair-pins, keys, etc.).
●
If you feel any abnormality, such as excessive heat, during the use of this
product, add immediately stop of use. Contact with the e-mail address.
●
Do not drop, place heavy weight on, or allow strong impact this product.
●
While in use, do not cover this product with materials such as blankets.
●Do not expose this product in high temperature environment, including
intense sunlight.
●Keep away from high temperature or high humidity.
●Keep this product dry at all times.
●The contact surface of this product must always be kept clean.
Note
●The product may become hot when charging. This is normal. Use caution
when handling.
Disposal of This Product
Never dispose of this product in the garbage.
Dispose of batteries according to your local environmental laws
and regulations.
Frequently Asked Questions (Q & A)
Q. Does this product conform to voltage such as AC 230 V?
A. This product is designed to be charged via USB and cannot
be charged directly from a wall socket.
Q. Can I carry this product on the airplane?
A.
Check this with airline. Also refer to IATA home page:
http://www.iata.org/whatwedo/cargo/dgr/Pages/
lithium-batteries.aspx
Product Specifications
Model No.: CHE-058 cheero INGRESS POWER CUBE 12000mAh
Dimensions (mm): 156.5(L) x 72(W) x 19(H)
(inch): 6.2 (L) x 2.8 (W) x 0.7 (H)
Weight: 275 g /9.7 oz (excluding accessories)
Input: DC 5 V/1.6 A max
Output 1: DC 5 V/1 A max, Output 2: DC 5 V/2.1 A max
Internal battery: DC 3.7 V 12000mAh (44.4wh) (Lithium polymer battery)
UN PLIII and S38.3.
Charging time with 2A USB AC adaptor (not attached) : Around 10 hours
Intended charging / discharging cycle: 500 times
Protective functions: • Automatic shutdown at overcharge (voltage / current)
•Overdischarge (voltage / current)
•Short circuit
•Overheating
•
Automatic shutdown at completion of device charge
*Not supported depending on the model.
WARNING
CAUTION
Declaration of Conformity
This product complies with the EMC Directive 2004/109/EC,
the LVD Directive 2006/95/EC, Erp Directive 2009/125/EC
and ROHS Directive 2011/65/EU.
2Connect the USB plug of the charging cable (accessory)
to 2A USB-AC adaptor (not attached) and then,connect
the adaptor to a wall socket.
The product starts charging itself, with the remaining battery level
indicator flashing. Charging is complete when the white flashing
lights stop flashing and are all lit.
3When charging is complete, disconnect the charging
cable from the product.
•Charging time: around 10 hours (with 2A adaptor, not attached)
(For the initial charging, the product may take a longer time.)
• Please avoid charging another device while charging theproduct.
• The internal battery will discharge by itself and deteriorate in capacity
if not
used for a long time. Please charge the product once in
every three months.
●Battery level indication during charging the unit
How to Charge Your Device
1Connect this product with your device by attached USB
to micro-USB charging cable or by your device set cable.
2Press the power button on this product.
The product starts charging the connected electronic device.
•LED lights on the emblem keep flashing while charging your devices.
3When charging is complete, disconnect the charging cable.
The product will automatically power off after a while when the
charging is completed.
• Depending on the electronic device to be charged, the product may
take about 1 minute to start charging after you press the power button.
To Check the Remaining Battery Level
Press the power button and check the remaining battery
level indicator.
You can know the remaining battery level by 4 LED cell indicators
as shown in the table below.
• When none of the indicators are on, the battery has no remaining
charge. Follow the steps to charge the product.
●Battery level indication after pressing the button
*
*
If one LED is blinking, the remaining battery level becomes very low and this
product needs to be recharged.
How to Play with Flashing Lights
This product is equipped with LED flashing lights, imitating INGRESS scenery.
While charging some device with use of this product, each of white, green, and
blue lights on the emblem turn on and off repeatedly.Press the LED button on
the side once, and the lights will turn green; press it once again, and the lights
will turn blue.The lights will turn back to the original way of flashing by pressing
the LED button once more.
If you want to flash additional background LED lights too, long-press the LED
button and hold it down for a few seconds. Background LED lights turn off the
same way by long-pressing the LED button and holding it down for another few
seconds.
All of LED lights will turn off automatically in 2 minutes after disconnecting the
device or when the charging is completed. LED lights turn on by pressing the
power button, too, and turn off automatically in about 2 minutes if no device is
connected to charging.To turn off the lights completely, long-press the power
button, and hold it down for a few seconds.
0% 1 - 5% 6 - 25% 26 - 50% 51 - 75% 76 - 100%
0 - 25% 26 - 50% 51 - 75% 76 - 99% 100%
To turn LED lights on again within 2 minutes after turning them off, press the LED button
instead of the power button.
English
Charging for supported devices such as Fig. 1.
* In addition, some portable game machines and MP3 players are supported.
There are also types of devices that cannot be charged using this product.
My
smartphone
cannot be
charged
