S1500
High efficiency wide input voltage
PFC programmable Power supply
90V~265VAC input
10V~30VDC output
60Amps 1500W max.
www.chargery.com page 3 total 8
◼10-30V DC charger, balance charger for RC mode
◼E-bike, E-scooter battery charger.
Operation
1. Connect S1500 to AC 110 / 220V outlet by the special heavy power cable, if use other brand cable,
please note the wire AWG must be AWG14 at least.
2. 2 seconds later, default output voltage (12V) and maximal output current can be displayed, actual
power and internal temperature is also displayed, but S1500 is at idle mode(power off) to save
power consumption, as the following picture 1. Confirm the voltage and current is suitable for your
charger and other load, then press START/ENTER button turn on S1500, the LCD will display actual
output voltage, current, output power and internal temperature as the following picture 2.
If the voltage is NOT suitable for your charger or other load, press INC or DEC button setup the
voltage. It is easy to adjust as same as a potential meter and need not confirm the change, because
the voltage will be updated with your operation. Finish the voltage setup, the device can remember
the new value till next change.
You can also change the voltage at any time whether power
on or power off status.
If need change the maximal current or other items, please
operate according to the following steps.
3. Press STOP/SET button for 2 seconds enter into Program Setup
menu, The LCD displays the following information in sequence
and you can change the value. When you want to alter a parameter
value, press the Start/Enter button to the value blink then change the value with the DEC or INC
