CHANNEL SAFETY SYSTEMS t: 0845 884 7000 | w: www.channelsafety.co.uk
INSTRUCTION MANUAL - Issue 1 - 02/2014 | 2
INSTRUCTIONS
Each MotionPro Floodlight utilises passive infrared technology to detect heat radiation of moving objects such as people & vehicles.
On activation the lamp will illuminate for a the chosen time period, an integral adjustable daylight sensor ensures night-only operation.
The MotionPro unit comes complete with:-
• Luminaire c/w PIR Sensor unit.
• Instruction manual. Please keep safe for future reference.
• Accessory Pack.
Tools & Parts Needed For Installation
• Suitable drill & bits.
• Terminal or Electricians screwdriver
• Large slotted/Phillips screwdriver
• Wire cutters/strippers
This product has glass front, care must be taken when installing or handling to prevent personal injury or damage to the unit. This light tting must be
installed by a competent person in accordance with the current building & IEE wiring regulations.
Ensure that the electrical supply is correctly isolated by use of the appropriate safe isolation method. This Unit is for outdoor use only and must be mounted
on suitable rigid & strong non-ammable surface. It is not designed to be used as a portable light. This product should be installed using suitably sized and
strong xings.
The surface on which it is to be installed on should be strong enough to support the weight of the light.
This product can be installed on surfaces with normal ammability (wood, plasterboard, masonry). It is not suitable to be installed on, or near highly
ammable surfaces.
Do not install on surfaces which are damp, or electrically conductive. The light should be positioned so that there is at least 500mm between the front of the
tting and any illuminated surface.
This product is designed for permanent connection to a suitably protected xed wiring installation.
Do not carry or lift the oodlight by the mains supply cable.
Only clean the light tting with a soft dry cloth, do not use chemical or abrasive cleaning materials.
The unit can get hot during use. Ensure the unit has cooled before handling. Ensure adequate ventilation space is allowed between the unit and any object
above, in front or to either side of the unit.
Suggested space is 0.5m above, 0.3m to either side & 1.0m in front. This unit should be installed by a qualied electrician.
Selecting The Location
The motion sensor has a number of detection zones, at various vertical and horizontal angles. The maximum range is 12m. The detection angle is 120°
When moving heat source crosses one of these zones it will activate the sensor. Careful positioning of the sensor will be required to ensure optimum per-
formance. The sensor is more sensitive to movement ACROSS its eld of vision than to movement directly TOWARDS. Therefore position the unit so that the
sensor looks ACROSS the likely approach path.
Avoid positioning the sensor where there are any sources of heat in the detection area(extractor fans, tumble dryer exhausts etc.). Reective surfaces (ie pools
of water or white-painted walls) and overhanging branches may cause false activation under extreme conditions.
