Channel Master 3022 Manuel utilisateur

WARNING: INSTALLATION OF THIS PRODUCT NEAR

POWER LINES IS DANGEROUS. FOR YOUR SAFETY,

READ THE ENCLOSED “DANGER” BOOKLET BEFORE

BEGINNINGYOUR INSTALLATION.

"DIGITAL READY"

UHFTV ANTENNAS

INSTALLATION

INSTRUCTIONS

MODEL

3022

MODEL

3023

MODEL 3023

MODEL 4248

MODEL 3022

MODEL 4308

TOOLS YOU WILL FIND HANDY

• Large and small blade screwdrivers • Wire Cutters

• Adjustable Wrench • Pliers

WHERE TO MOUNT YOUR ANTENNA

Your antenna can be mounted on either the chimney, the roof, or on an outside wall or in an attic. Choose the method

that best suits your particular location.

TRANSMISSION LINE

75 Ohm Coaxial Cable has a longer life-span than 300 ohm twinlead cable and is unaffected by contact with metal or

moisture.To install coaxial cable, begin by connecting the antenna end of the cable to an “antenna balun” (supplied with

antenna). Attach the input wires of the balun to the antenna terminals. Next, run the coaxial cable through a standout

mounted on the mast. This will prevent the weight of the line from pulling on the antenna connections. From this point,

the rest of the coax may be taped to the mast.

LIGHTNING PROTECTION

The mast and transmission line should be grounded for lightning protection. Run a #8 (or larger), aluminum or copper

wire from a bolt on the mast or its base, down to a 4’ - 8’ground rod driven at least four feet into the earth. Keep the line

at a respectable distance from your transmission wire to prevent signal interference.A Coaxial Grounding Block (Channel

Master Model 3274) should be connected to the antenna transmission wire at the point where it enters the house.

AIMING YOUR ANTENNA TOWARD THE TRANSMITTING STATION

Once the antenna installation is completed, turn yourTV set on and have an assistant observe the reception.On the roof,

loosen the U-bolt nuts and turn the antenna until you get the best reception. Once this is accomplished, tighten U-bolt

nuts securely.

NOTE: If broadcast stations are in different directions, you will need an antenna rotator.This will allow you to rotate the

antenna and pinpoint individual stations from inside your home. (For more information on rotators, see the complete line

of Channel Master Automatic and Programmable antenna rotators.)

Find the installation you plan to make on the following pages – READ THE INSTRUCTIONS FOR ASSEMBLING THE

ANTENNA AND THE INSTALLATION BEFOREYOU START THE ACTUAL WORK!

Your Channel Master retailer has all the mounts and accessories you’ll need for your installation.

TIPS ON INSTALLATION

"S" Clamp

TV Set

Balun

From Antenna

VCR

Set

Coaxial Cable Input

TV Set

VCR

1. Open elements on Antenna (Fig. 1).

a. Model 3023 - Assemble crossarms (Fig. 4).

2. With crossarm on underside, fasten terminals to bottom pair of tap-offs (Fig. 2).

3. Mount Antenna to mast (see Fig. 3) making sure that the crossarm is on the underside.

ANTENNA ASSEMBLY INSTRUCTIONS

NOTE: This instruction sheet covers all models 3022 and 3023.

Antenna Crossarm

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Wing Nut

Screw

VHF FeedThru

P/N 51200 Printed in U.S.A. 12/99 3022, 3023, 4248, 4308

IMPORTANT SAFEGUARDS

•Remember, when working on a roof, use two adults.

•Never walk on a composition roof in cold weather.

•Wear sneakers or crepe soles, and use a safety rope.

•Always watch for power lines.

ATTIC INSTALLATION:

Using a roof mount, attach a short piece of mast to a conven-

ient roof rafter. Attach and aim the antenna in the same man-

ner as outlined for outdoor installations. NOTE: Antennas

should not be installed in an attic if the roof or walls are metal

or are lined with foil backed insulation.

ROOF MOUNT: Used on peaked or flat type roofs.

Suggested Height Limit: 10-feet above roof top.

Using a roof mount, connect the mast with guy ring and guy

wires attached, to the mount. Use three or four guy wires,

equally spaced around the mast, and anchor the guy wires to

the roof or eaves with eyebolts. The guy ring should be

clamped approximately 1-foot below the antenna. Use roofing

compound around the base of the mount, screws and eyebolts

to seal against moisture. After the installation has been com-

pleted, mount the extra WARNING LABEL supplied with the

antenna hardware to the mast at EYE LEVEL!

CHIMNEY MOUNTING:

Suggested Height Limitation: 10 feet above rooftop.

First, check your chimney thoroughly for stability to make

sure that it is strong enough to support the antenna during

severe winds. Do not use a chimney that has loose bricks or

mortar. Install the upper bracket just below the top course of

bricks and the lower bracket at least 2¹⁄₂ feet below the top

bracket. (For

maximum strength, space the brackets as far apart as possi-

ble.) After the installation has been completed, mount the

extra WARNING LABEL supplied with the antenna hardware

to the mast at EYE LEVEL!

WALL MOUNT:

Suggested Height Limitation: 10 feet above rooftop.

If the roof overhang is not excessive, the side of the house

can be used for mounting. If a wall mounted installation is

done from the ground up, use a ground mount with a “spike”

at the ground. Position the wall brackets over a stud if possi-

ble; one above the other and space a minimum of three feet

apart. For metal siding, mark mounting holes, then drill pilot

holes through the siding for mounting screws. If you use a 2-

piece mast, assemble the pieces as shown, making sure that

they are

properly locked together. Split between masts should be

between the two wall brackets.After the installation has been

completed, mount the extra WARNING LABEL supplied with

the antenna hardware to the mast at EYE LEVEL!

TRIPOD MOUNT: Use on peaked or flat roofs.

Suggested Height Limit: 10 feet above roof top.

The tripod mount can be mounted to any style roof by adjusting

the bracket on the center leg. Insert the mast into the tripod

mount and place the mount with legs over the roof rafters.Make

sure the mast is vertical. Remove the protective covering from

one side of the three pitch pads and place under the base of

each tripod leg with the tacky side towards the roof. Secure the

tripo mount to the roof using lag screws. After the installation

has been completed, mount the extra WARNING LABEL sup-

plied with the antenna hardware to the mast at EYE LEVEL!

ANTENNA REMOVAL:

Removal of your antenna should be exactly in reverse of the

installation instructions.For your own safety, please follow the

instructions for installing the antenna starting with the last

step first.This is the only way to safely remove your antenna.

WARNING: INSTALLATION OF THIS PRODUCT NEAR POWER LINES IS DANGEROUS.

FOR YOUR SAFETY, READ THE ENCLOSED “DANGER” BOOKLET BEFORE BEGINNING YOUR INSTALLATION.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Channel Master Antenne

Channel Master

Channel Master 3010 Manuel utilisateur

Channel Master

Channel Master 2016 Manuel utilisateur

Channel Master

Channel Master CM-0747 Manuel utilisateur

Channel Master

Channel Master CM-4040 Manuel utilisateur

Channel Master

Channel Master CM-3016 Manuel utilisateur

Channel Master

Channel Master 3018 Manuel utilisateur

Channel Master

Channel Master CM-4040 Manuel utilisateur

Channel Master

Channel Master STEALTHtenna Manuel utilisateur

Channel Master

Channel Master 6392 Manuel utilisateur

Channel Master

Channel Master 4228A Manuel utilisateur

Channel Master

Channel Master CM-9521A Manuel utilisateur

Channel Master

Channel Master 1.2m Rx/Tx ANTENNA SYSTEM Manuel utilisateur

Channel Master

Channel Master ULTRA-HI CROSSFIRE CM-3671 Manuel utilisateur

Channel Master

Channel Master SMARTenna 3000A Manuel utilisateur

Channel Master

Channel Master CM-3000HD Manuel utilisateur

Channel Master

Channel Master STEALTHtenna 3010 Manuel

Channel Master

Channel Master 6920 Manuel utilisateur

Channel Master

Channel Master CM-3016 Manuel utilisateur

Channel Master

Channel Master CM-3000A Manuel utilisateur

Channel Master

Channel Master CM-5016 Manuel utilisateur

Channel Master

Channel Master 4220MHD Manuel utilisateur

Channel Master

Channel Master FLATenna Manuel utilisateur

Channel Master

Channel Master CM-4220HD Manuel utilisateur

Channel Master

Channel Master 2016 Manuel utilisateur

Manuels Antenne populaires d'autres marques

Alfa Network

Alfa Network APA-L01 Manuel utilisateur

Naval

Naval PR-422CA Manuel utilisateur

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manuel utilisateur

TERK Technologies

TERK Technologies TV44 Manuel utilisateur

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manuel utilisateur

HP J8999A Manuel utilisateur

MobilSat

MobilSat MSP-S Manuel utilisateur

Steren

Steren ANT-UHF 13 Manuel utilisateur

Novatel

Novatel 600-G Manuel d'utilisation

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manuel utilisateur

TRENDnet

TRENDnet TEW-AO12O Manuel utilisateur

Radio Shack

Radio Shack 15-1837 Manuel utilisateur

CommScope

CommScope CMAX-OMFX-43M-I53 Manuel utilisateur

Ramsey Electronics

Ramsey Electronics DAP25 Manuel utilisateur

COBHAM

COBHAM SAILOR 800 VSAT Manuel d'utilisation et d'entretien

Trango Systems

Trango Systems AD900-9 Manuel utilisateur

Steren

Steren ANT-100 Manuel utilisateur

Proxim

Proxim 5054-PA-23 Manuel utilisateur