V1.4
POE-OSP
Gigabit Ethernet PoE Pass-through Outdoor Surge
Protector
User’s Guide
FCC Certifications
This Equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received; including
interference that may cause undesired operation.
CE Mark Warning
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class A for ITE,
the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of the
Member States relating to electromagnetic compatibility.
Company has an on-going policy of upgrading its products and it may be possible that information in this document
is not up-to-date. Please check with your local distributors for the latest information. No part of this document can be
copied or reproduced in any form without written consent from the company.
Trademarks:
All trade names and trademarks are the properties of their respective companies.
Copyright © 2016, All Rights Reserved.
Unpacking Information
Thank you for purchasing our PoE series products. Before installation,
please check that your package contains the following items.
Open the shipping cartons of the unit and carefully unpack its
contents. The carton should contain the following items:
1. POE-OSP Main Unit x 1
2. 18AWG grounding cable x 1
3. Wall mounting screw set x 1
4. Quick Installation Guide x 1
5. Warranty Card x 1
Hardware Overview
Introduction
The CERIO POE-OSP is an outdoor PoE Pass-through Ethernet
Surge Protector provides superior lightening and surge protection
over Gigabit networks speeds to provide Power-over- Ethernet (PoE)
over a single Ethernet cable. It supports 10 kA Impulse Discharge
Current guarantees reliable surge protection and provides excellent
lightning protection for network PoE and non-PoE devices when
transmitting on Gigabit network. POE-OSP provides aluminum
enclosure with IP68 rating waterproof durable design are made to
withstand harsh environment deployment.
Highlight Features
Complying with IEEE 802.3 10Base-T, IEEE 802.3u 100Base-TX,
IEEE 802.3ab 1000Base-T standards.
Supports Gigabit Ethernet and provides Gigabit transfer speed
and Power over Ethernet (PoE) pass through.
Supports weather-proof durable design are made to withstand
harsh environment deployment
Load current self-protection mechanism and grounding wire
function pulse discharge current protection design
Built in grounding pad which can connect to grounding cable to
lower clamping voltage for better and more reliable protection
and supports 10 kA Impulse Discharge Current
Supports 2 protection mode : Line-to-Ground and Line-to-Line.
Protects all Eight(8) pins of the Ethernet cable
Plug and Play, no software required.
Supports wall mounting installation
Standards & Hardware Specifications
Standard
IEEE802.3u 100BASE-TX
Network Media
10BASE –T: UTP Cat. 3 or up
100BASE-TX : UTP Cat. 5 or up
1000BASE-T: UTP Cat. 5 or up
Data Transfer Rate
10/100/1000Mbps (Half-duplex)
20/200/2000Mbps (Full-duplex)
Differential mode up to 1 kA
Ethernet Connector
RJ-45 x1 for Line in
RJ-45 x1 for Line out
10KV (After grounding ability)
Environmental & Mechanical Characteristic
Two pair: 0.65A(Max) ,Four pair: 1.3A(Max)
Dimension ( W x D x H )
74 x 165 x 60mm(Including wall mounting
kit)
Case of material
Production Location
IP68 Rating Weather-proof Alumm casing
TW Only
Supports
IEC/EN 61643-21 (Safety) compatible
IEC/EN 61000-4-5 (EMC) compatible
