DVD CARE
Always handle the disc by the edges. Never touch the surface. To remove fingerprints and
dust, use a soft cloth and wipe in a straight line from the center of the disc to the outside
edge. (See page 28) Take care of the Remote Control. Keep the remote with your DVD
cases, where it is unlikely to be lost or damaged.
Keep liquids away from the DVD player, including beverages and cleaning liquids. Spilling
any liquid on the player can damage the electronics, resulting in an electrical shock or fire.
If the unit or remote control should become wet, turn off all power and let an authorized
dealer clean or service the equipment.
CAUTION: DO NOT ATTEMPT TO OPEN OR SERVICE THE UNIT OR REMOTE
CONTROL. THE INTERNAL PARTS ARE NOT USER SERVICEABLE.
Do not use any liquid or aerosol cleaners, anti-static spray, or thinner to clean the disc
surface.
Do not allow coins, cleaning cloths, paper and other objects to be pushed into the DVD
slot, these objects could connect with a voltage point inside the unit and cause an
electrical shock, or may short out causing unit failure or fire.
TEMPERATURE AND MOISTURE
When the inside of the vehicle is very cold and the player is used immediately, moisture
may form on the disc or the optical parts and proper playback may not be possible. If
moisture forms on the disc, wipe it off with a soft cloth. If moisture forms on the optical
parts of the player, allow the player to sit for about one hour with the power on. The
condensation will disappear naturally allowing for normal operation. Please consult your
nearest dealer for recommendations and service.
OPERATION PRECAUTIONS
Do not subject the unit to direct sunlight or extremely hot environments
(e.g closed windows on a hot summer day, heater vent, etc.).
Avoid using the unit under the following conditions:
After external parking on an extremely hot or cold day, Near strong magnetic fields, In an
environment with excessive humidity, dust, or vibration (e.g off-road travel, etc.)
Do not directly touch the disc surface. Never stick labels on the surface of the disc or
mark the surface with a pen. Always place a DVD disc back into its case after use.
CENDVDLFM Page 2
