CELL C TEXTER Manuel utilisateur
YOUR
CELL C TEXTER
USER GUIDE
KEY FUNCTIONS
Torch
Send key
Headset jack
Left soft key
Charger interface
Phonebook key
Earpiece
4-Way Navigation
keys and Center key
End/Power key
Messages key
QWERTY keyboard
Right soft key
FUNCTION DESCRIPTION
Left soft key Performs the function indicated at the left
bottom of the screen.
Righsoft key Performs the function indicated at the right
bottom of the screen.
Center key Press to confirm actions and make selections.
1
STATUS BAR ICONS
INDICATOR WHAT IT MEANS
Signal strength
GPRS
Silent
General
Outdoor
Meeting
New SMS
New MMS
Calling or in call
Roaming
Battery status
Alarm clock set
BATTERY
The lithium ion battery of the cellphone can be
immediately used after unpacking.
INSTALLING THE BATTERY
1. Pull the battery cover from the notch on the bottom and
remove the cover.
2. Insert the battery by aligning the gold-colored contacts
with the contacts in the battery slot.
3
3. Push down the upper section of the battery until it clicks
into place.
4. Replace the battery cover and close it gently until you hear
a click.
Remove the battery cover Push down the battery
Replace the battery cover
REMOVING THE BATTERY
1. Make sure that your cellphone is switched off.
2. Remove the battery cover.
3. Pull the battery up and remove it from the cellphone.
Remove the battery cover Pull up the battery
4
CHARGING THE BATTERY
Your cellphone is powered by a rechargeable battery. For
maximum battery performance, it is recommended that you
first use up the battery power and then charge it completely.
A new battery’s full performance is achieved only after three
complete charge and discharge cycles.
1. Connect your travel adapter to the left side of your
cellphone as shown in the diagram.
2. Connect the other end of the travel adapter to the mains
socket.
3. When the battery is being charged, the display will show the
animation of a battery being filled up.
4. When the battery is fully charged, disconnect the charger.
INSERTING THE SIM CARD
Insert the SIM card as follows:
1. Make sure that the cellphone is switched off and the
charger is disconnected from the cellphone.
2. Turn the cellphone over and remove the battery cover.
3. Remove the battery if it is already installed.
5
4. Hold your SIM card with the cut corner oriented as shown
and then slide it into the card holder with the metal
contacts facing downward.
5. Replace the battery first.
6. Replace the battery cover.
Insert the SIM card
SIM card (Subscriber Identity Module) is a micro-chip that
holds your personal information such as names and phone
numbers. Your cellphone won’t work without it. If you
already have contacts on your SIM card, they can be
transferred in most cases.
INSERTING THE MEMORY CARD
You can use memory card to expand the storage of the
cellphone. You can store or copy files such as photos, music,
and so on.
Do not take out the card or switch off the cellphone while
transmitting or storing data, which may cause data loss or
damage to the cellphone or the card.
6
Insert the memory card as follows:
Open the battery cover and remove the battery. Insert the
card with the metal contacts facing downward until it clicks
to the right position.
Insert the Memory card
SWITCHING YOUR CELLPHONE ON/OFF
Make sure that your SIM card is in your cellphone and that the
battery is charged.
Hold End/Power key to power on/off the cellphone. The
cellphone will automatically search for the network when the
cellphone is turned on.
WRITING TEXT
•Input method
Your cellphone provides the following input methods:
abc, Abc, ABC,123.The current input mode is displayed
in the top left corner of the screen. You can press
Options→Input method to select the input mode.
7
•Alphabetic Mode
♦Press A ~ Z to enter desired characters.
♦Press to switch between uppercase and lowercase.
♦Press to enter space.
♦Press to delete characters.
•Numeric Mode
In numeric mode, use the numeric keys to enter numbers.
NOTE: Letters can not be entered in this mode.
•Entering Symbols
Go to Options→Input method→Insert symbol, then use
Navigation keys to select desired symbol. You can also
press the Silent key to switch to the symbol mode.
NOTE: The Silent key is in the last row of the keyboard
which printed characters with “Sym”.
ADDING CONTACTS TO THE PHONEBOOK
There are some numbers that you may want to call again and
again, so it makes sense to add these numbers to your
Phonebook. You can then access these numbers quickly and
easily.
1. Go to Menu→Phonebook→Add new contact.
2. Select SIM or cellphone to store the contact.
3. Edit the information and save it.
8
•You can also save a number right after you’ve made or
received a phone call or a message from someone who
is not yet in your Phonebook list.
•To delete someone from your Phonebook list, first select
the name, then select Options→Delete.
MAKING AND RECEIVING CALLS
•Basic way to make a call
In idle screen, press numeric keys to input the number
and press Send key to dial.
•Dial from the Phonebook
Go to Menu→Phonebook. Find the name of the person
you want to call, and press Send key.
•Make an emergency call
You can make emergency calls without the SIM card
inserted so long as you are in an area with network
coverage.
•Answer a call
Press Send key.
•End a call
Press End key.
Make sure that you are in an area with sufficient coverage
to make calls. The strength of the network signal is
indicated on the Status Bar of the screen.
9
Table des matières
