CBT Supply Brig Manuel utilisateur
Side Mounted
Brig™
CPU Holder
Use for
Brig™ and Li’l Brig™ models
Parts
CPU Security Tabs &
Self-tapping Screws
8 Machine Screws & Beta Clip
10 Euro Screws 8 One Way Screws
4 Carbon Steel Bars
Bottom Pan
4 bar extensions
Top Plate
Bottom Plate
Attachment Tabs
Side Mount Bracket
ASSEMBLY & INSTALLATION
©2009 CBT Supply, Inc. All rights reserved.
1. Install Bars in
Bottom Pan
Place CPU on bottom pan and determine
locations for bar installation. Choose the
closest clearance between bars and CPU
case.
Using 4 of the 8 black
machine screws, install the
4 carbon steel bars. Check
to see if the extensions are
required. If the CPU case is
taller than the bars, use the
extensions.
After making this determination, remove
the two bars on the right side as you view
the unit from the front.
Install the Bottom Plate Attachment
Tabs to the bottom plate on the right
side. These will provide a way to secure
the unit to the side of the desk panel.
ONE WAY SCREWS may be used if a
deterrent to theft is required. Install the
screws lose so you can remove them
using your ngers. Tighten them when
you know everything ts your CPU case.
©2009 CBT Supply, Inc. All rights reserved.
3. Install Bars in Top Pan
With bars and security anges installed, place CPU on bottom pan.
Front of CPU should be oriented with curved anges as shown. If CPU
is taller than the bars, screw in bar extensions. Use 4 remaining black
machine screws to install top pan onto bars.
ONE WAY SCREWS may be used if a deterrent to theft is required.
Install the screws lose so you can remove them using your ngers.
Tighten them when you know everything ts your CPU case.
2. Install Security Tabs
Use self-tapping metals screws to install security tabs into holes
provided in the top and bottom pans at the back edge. This opera-
tion requires slow, steady force. Once installed, screws are dicult
to remove. Several sets of holes are provided so you can avoid cable
routing conicts. When the top is installed, the CPU is trapped inside
©2009 CBT Supply, Inc. All rights reserved.
CBT Supply, Inc.
800 770 7042
Products for the Net Generation
4. Install Side Mount Bracket
Use 8 Euro Screws to install using a
Phillips #2 drive.
5. Hang Brig & CPU
Slip the side mount bracket tabs through
the slots in the top of the Brig’s top plate.
5. Secure Brig to the
desk panel
Use one Euro Screw, each, for two
tabs located on bottom of Brig into
pilot holes provided.
Finished Installation
©2009 CBT Supply, Inc. All rights reserved.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels CBT Supply Accessoires informatiques
