INSTALLATION INSTRUCTIONS
• This appliance is designed to be free standing only, and should not be
recessed or built-in.
• Place your unit on a oor that is strong enough to support the unit when
it is fully loaded. To level your unit, adjust the levelling legs at the bot-
tom of the unit.
• This appliance is NOT designed to be installed inside of a cabinet where
the front is covered by any type of door.
• Allow 10cm of space between the top, back and sides of the unit, which
allows the proper air circulation to cool the compressor and condenser
• Locate the unit away from direct sunlight and source of heat (stove,
heater, radiator etc.)
• Direct sunlight may affect the acrylic coating and heat sources may in-
crease electrical consumption. Extreme cold ambient temperatures may
also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed-grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power and/or grounding
should be directed toward a certied electrician or an authorised Avanti
Products service centre.
• After plugging the appliance into a wall outlet, allow the unit to cool
down for 2-3 hours before placing food in the appliance compartment.
Please remember to keep some water in the cabinet to keep the humidity.
Disposal:
To prevent possible harm to the environment or human health from uncon-
trolled waste disposal, recycle it responsibly to promote the sustainable re-
use of material resources. Disposal should only be done through public col-
lection points.
4
