IMPORTANT SAFETY INSTRUCTIONS
3
13. OUTDOOR ANTENNA GROUNDING: If an outside antenna or cable system is connected to the unit, be
sure the antenna or cable system is grounded so as to provide protection against voltage surges and built-up
static charges. Article 810 of the National Electrical Code, NSI/NFPA 70, provides information regarding
proper grounding of the mast and supporting structure, grounding of the lead-in wire to an Antenna-
discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding electrode.
14. LIGHTNING: For added protection for the unit during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system.
This will prevent damage to the unit due to lightning and power line surges.
15. POWER LINES: An outside antenna system should not be located in the vicinity of overhead power lines
or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing
an outside antenna system, take extreme care to keep from touching such power lines or circuits as contact
with them might be fatal.
16. OVERLOADING: Do not overload wall outlets, extension cords, or integral convenience receptacles as
this can result in a risk of fire or electric shock.
17. OBJECT AND LIQUID ENTRY: Never push objects of any kind into the unit through openings as they
may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill
liquid of any kind on the unit.
18. SERVICING: Do not attempt to service the unit yourself as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer all servicing to qualified service personnel.
19. REPLACEMENT PARTS: When replacement parts are required, be sure the service technician has used
replacement parts specified by the manufacturer or have the same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other hazards.
20. SAFETY CHECK: Upon completion of any service or repairs to the unit, ask the service technician to
perform safety checks to determine that the unit is in proper operating condition.
21. WALL OR CEILING MOUNTING: The unit should be mounted to a wall or ceiling only as
recommended by the manufacturer.
22. HEAT: The unit should be situated away from heat sources such as radiators, heat registers, stoves, or other
units (including amplifiers) that produce heat.
23. IMPORTANT SAFETY NOTE: Before connecting a new component to your audio or home theater
system it is always good practice to make certain that all components are turned off, and preferably
unplugged from their AC power source. Many modern electronics products feature automatic turn-on
circuits that may be activated during an installation, causing the potential for damage to electronic
components and/or speakers. Such damage is not covered by product warranties and Cary Audio specifically
disclaims responsibility for any such damage.
Power Cord: The removable power cord that is shipped with the player is specifically designed to be used
with this product. Other AC cords may be used, so consult your dealer for advice on AC power cords and
high quality wire in your system.
AC Fuse: The fuse is located inside the chassis and is not user serviceable. If power does
not come on, contact your authorized service representative.
Wiring: Cables that run inside of walls should have the appropriate markings to indicate compliance with,
and listing by the UL, CSA or other standards required by the UL, CSA, NEC or your local building code.
Questions about cables inside of walls should be referred to a qualified custom installer, or a licensed
electrician or low-voltage contractor.
