Calimet CM9-603 Manuel utilisateur
Loop Detector Instruction Manual
CM9-603
Wiring Diagram
Add the Loop Detector to the Harness
The harness contains a reverse loop, phantom loop, and exit loop. You will need a separate loop
detector for each loop.
Loop wires go into the left side of the block terminal. The terminal accepts loop wires for Exit Loops,
Phantom Loops, and Reverse Loops.
Loop Wire
PHANTOM
SAFETY
EXIT LOOP
24V-COM
24-VDC
Gate Operator Circuit
Board Wiring
Adjust the sensitivity from 0-7. The sensitivity is the blue potentiometer on the side of the
loop detector. We generally recommend setting the sensitivity to 5 or 6.
When finished, use screws to mount the harness underneath the gate operator chassis,
on the back of the power compartment. You will see 4 transparent holes that you can
use to drill in 4 screws (not included).
Mount Loop Detector
Harness Here
Move the cable from the loop detector harness up into the circuit board
compartment, there will be a small circular hole large enough for the cable to go
through. Connect the wires based on the wiring diagram in the previous page.
Reverse Loop
Reverse Loop
(Phantom)
Exit Loop
Gate
Operator
Gate
Wall
Outside Property
Inside Property
4 FT
4 FT
4-8 FT
Wall
4 FT
4 FT
4 FT
8 FT
An exit loop is a device that opens the gate automatically when a car approaches the gate.
A reverse loop is a loop that reverses the direction of a closing gate if a car drives over it. It will also
hold a gate open if a vehicle stops over the loop. If the gate is fully closed and a vehicle drives over
it, the gate will not open. A phantom loop is a reverse loop located inside the property.
8 FT
8 FT
Exit Loops
Exit Loops
Loop wires are installed 1.5" underground by cutting the concrete with a circular saw.
The typical size loop is 8x4'. Common loop wires are size 16 or 18 AWG stranded copper
XLPE (cross-linked polyethylene) electrical wire. 3 layers of turns are required for a typical
4x8' loop. For different size loops, use 4 turns for 10-20ft in perimeter, 3 turns for 20-32ft in
perimeter, and 2 turns for 32-98ft in perimeter. Place a plastic foam or backer rods above
the loop wire turns to hold it in place. Backer rods ensure that the wires are in place
and do not vibrate. Any vibration of wire movement will cause a false detection. The wire
ends must be twisted back into the gate operator with a minimum of 6 twists
per foot. The twisted ends must be placed inside a PVC conduit. Use sealant to
close the ground once finished.
Use a circular saw to create a saw cut on the ground.
Depth: 1.5"
Width: 0.2 - 0.3"
Make sure the edges are at a 45° angle.
45°
Foam Backer Rods 1" spaced 1 feet apart on the top layer
Continuous (no splices) loop wire
with 3 turns placed directly on top
of each other
PVC Conduit
Twisted Lead-
in Wires
leading into
gate operator
loop detector
4"
8"
Exit Loops
Loop wire
3 Turns
Sealant
Above Ground
Backer Rod
Loop Size
(Sq ft)
Number
of Turns
6' to 12' 6
61' to 240'3
2
5
21' to 60'4
0.2" 241'+
1.5" 13' to 20'
Table des matières
Autres manuels Calimet Capteur de sécurité
