Cadet FW051 Manuel utilisateur

1'(.#61%(75('9,6+$0;/1'(.+($6(4

Any of the following models may be replaced using the FW conversion kit:

FW051, RW051, FW052, RW052, FW071, RW071, FW751, RW071, FW752, RW752

FW072, RW072, FW101, RW101, FW102, RW102, FW121, RW121, FW122, RW122

FW151, RW151, FW152, RW152, FW202, RW202, FW252, RW252, FW302, RW302

*The above models may be controlled by either a built-in thermostat or a wall mount thermostat.

(0(4$.$)(6;0)14/$6,10

 !

3 crews

2 pring Nuts

2 Lead Wires

1 Replacement Grill Label

2 Mounting crews

1 Conversion Plate

3 Lock Tooth Washers

1 Instruction Guide

!

Phillips crewdriver

traight crewdriver

#

7406+((.(&64,&$.219(41))$66+(

(.(&64,&$. 2$0(. %1$4' &,4&7,6

%4($-(4 14 )75( %1: $0' .1&- 14

6$* 6+( 2$0(. %1$4' '114 61

24(8(0651/(10()41/6740,0*10

219(4 9+,.( ;17 $4( 914-,0* 10

6+(+($6(4 $,.74(61'151&17.'

4(57.6 ,0 5(4,175 (.(&64,&$. 5+1&-

%7405142155,%.('($6+

 #

,5-1)),4(142412(46;'$/$*(

< replace your heater with a higher wattage assembly.

Replace your heater with the same voltage and wattage that

was originally installed. Replacing it with a higher wattage

heater could result in an overloaded electrical circuit in your

home, which could result in a fire and serious property damage.

Replacing with a lower wattage heater may cause insufficient

heat and result in increased energy costs.

 All electrical work and materials must comply with the National

Electric Code (NEC), the Occupational afety and Health Act

(O HA), and all state and local codes.

 When installing the heater conversion kit, be certain the FW

heater being replaced was wired correctly to all electrical codes

and the supply wiring is the correct size and in good condition.

If not, it must be replaced before proceeding.

 If you need to install a new circuit or need additional wiring

information, consult a qualified electrician.

 Protect electrical supply from kinks, sharp objects, oil, grease,

hot surfaces or chemicals.

($674(5<<(0(),65

•Converts discontinued FW eries wall can

to newer Com-Pak or Com-Pak Max

•UL Listed for installation of Com-Pak

model into FW wall can

•No sheetrock construction necessary -

saves time and money

•Vertical or horizontal installation

);17$4(70&1/)146$%.(914-,0*9,6+(.(&64,&$.$22.,$0&(570$%.(61)1..196+(5(*7,'(.,0(5

14'1016+$8(6+(0(&(55$4;(37,2/(06&1057.6$.,&(05('(.(&64,&,$0

vertical installation shown

"  ! 

cadetheat.com Tel: 360-693-2505 P.O. Box 1675 Vanco ver, WA 98668-1675

FWAP Conversion Kit

Installation Instructions

http://www.cadetheat.com/products/wall-heaters/com-pak

pring Nut

(/18,0*.'#($6(4

1. Pull off thermostat knob (if applicable) and remove top and bottom grill

screws to remove grill.

2. Remove screw on bottom center of heater assembly.

3. Unscrew insulated wire connectors and separate supply wires from

heater wires.

4. Remove the heater assembly by pushing up in the direction of the fan

and pulling unit out of wall can.

056$..,0*108(45,10,6

1. crew top and bottom screws and washers about halfway into the wall

can with the half-moon tabs facing out ( ee Figure 1).

2. Push plate down into position.

3. Tighten the screws. NOTE: tar washers MU T be located between

the screw head and painted surface of the conversion plate.

4. Install one spring nut at the top and one at the bottom ( ee Figure 2).

056$..,0*(9($6(455(/%.;

16( If FW heater was wired with the supply circuit entering the wall can

from the top, it may be necessary to add 8 inches of lead wire to each of

the supply lines before proceeding with installation of new heater.

1. +(1/$-4(37,4(5$6+(4/156$66112(4$6( Please follow

wiring instructions supplied with either your built-in thermostat kit

or wall mount thermostat and your new heater. If new heater has

a built-in thermostat, the two mounting screws must be removed

and reattached to the bottom of the FWAP.

2. Once wiring is complete, slide heater assembly into half-moon tabs

located on bottom of conversion plate. Use screw supplied with heater

assembly and star washer supplied with kit to attach heater to

conversion plate.

3. If using original grill, turn the grill upside down ( ee Figure 3) and

install using two new #10 screws. If there is a built-in thermostat,

be sure it is at the bottom.

4. Affix new label (provided) on inverted grill. It is not necessary to

remove the old label. If using a built-in thermostat, cut thermostat

shaft hole out of new label.

2(4$6,1005647&6,105

1. Once installation is complete and power has been restored, turn the

thermostat knob fully clockwise.

2. When the room reaches your comfort level, turn the thermostat knob

counterclockwise until the heater turns off. The heater will

auto mat ically cycle around this preset temperature.

3. To reduce the room temperature, turn the knob counterclockwise.

To increase the room tempera ture, turn the knob clockwise.

#05647&6,105$&-,'(

pring Nut

+$.)

/110

6$%5

,*74(

,*74(

,*74(

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Cadet Chauffage

Cadet

Cadet CEH-003M Manuel utilisateur

Cadet

Cadet BRF12 Manuel utilisateur

Cadet

Cadet RBF Series Manuel utilisateur

Cadet

Cadet The Com-Pak Plus Manuel utilisateur

Cadet

Cadet Apex72 HW162 Manuel utilisateur

Cadet

Cadet Hot One Manuel utilisateur

Cadet

Cadet SL101T Manuel utilisateur

Cadet

Cadet FP052TB Manuel utilisateur

Cadet

Cadet Com-Pak CBC132TW Manuel utilisateur

Cadet

Cadet CEH005P Manuel utilisateur

Cadet

Cadet RBF Series Manuel utilisateur

Cadet

Cadet RM108 Manuel utilisateur

Cadet

Cadet CM162 Manuel utilisateur

Cadet

Cadet The Register Plus RM151 Manuel utilisateur

Cadet

Cadet The Com-Pak Plus C072 reset Manuel utilisateur

Cadet

Cadet Hot One Manuel utilisateur

Cadet

Cadet CE083T Manuel utilisateur

Cadet

Cadet CGH402 Manuel utilisateur

Cadet

Cadet Apex72 Manuel utilisateur

Cadet

Cadet The Perfectoe UC072 Manuel utilisateur

Cadet

Cadet Energy Plus CE083T Manuel utilisateur

Cadet

Cadet CST252 Manuel utilisateur

Cadet

Cadet COM-PAK MAX CM192 Manuel utilisateur

Cadet

Cadet The Hot One RCP402S Manuel utilisateur

Manuels Chauffage populaires d'autres marques

oventrop

oventrop Regucor Series Manuel utilisateur

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manuel utilisateur

ELMEKO

ELMEKO ML 150 Manuel utilisateur

BN Thermic

BN Thermic 830T Manuel utilisateur

KING

KING K Series Mode d’emploi

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guide de démarrage rapide

Well Straler

Well Straler RC-16B Manuel utilisateur

EUROM

EUROM 333299 Manuel utilisateur

Heylo

Heylo K 170 Manuel utilisateur

Eterna

Eterna TR70W Manuel utilisateur

Clarke

Clarke GRH15 Mode d’emploi

IRSAP

IRSAP The Radiator Company Ovali Manuel utilisateur

Empire Heating Systems

Empire Heating Systems WCC65 Manuel utilisateur

Wetekom

Wetekom 92 86 43 Manuel utilisateur

Desa

Desa SPC170-F Manuel utilisateur

Watlow

Watlow Watrod Electric Tubular Heaters Manuel utilisateur

Haverland

Haverland ECO-DRY GPS Series Manuel de la liste des pièces

Stelpro

Stelpro ASILVC2060 Series Manuel utilisateur