CACHFIRES Premium Burner 24 cm Manuel utilisateur

ENGLISH 3
DEUTSCH 8
DANSK 13
SVENSKA 18
NORSK 23
NEDERLANDS 28
ESPAÑOL 33
FRANÇAIS 38
SUOMI 43
ITALIANO 48
Languages

3
Safety First!
Recommended building materials
Important
A bioethanol replace creates a solution for situations where the ambience of a real re is desired but no chimney is
available or possible to install.
All our manual bioethanol burners are equipped with a ceramic cotton lling that absorbs liquid and makes sure that
any lled bioethanol can not be spilt out of the burner again if tipped over.
When burning bioethanol CO2 (Carbon dioxide) is created. In large quantities, CO2 can be a health risk and you
should therefore pay attention to the minimum room size requirements for the different burners. See more about this
on the following pages.
When building your surroundings for a bioethanol replace, we recommend using the following building materials or
similar heat- and re-resistant materials for any part of the construction that is in direct contact with the burner or is
exposed to the ames:
• Promafour© plates
• Promatect© plates
• Super-isol© plates
• Promaglaf© insulation
• Insulfrax© insulation
• SkamoEnclosure© boards
• HardieBacker© boards
• WonderBoard© boards
Products that are reported as passing ASTME E 136, Standard Test Method for Behavior of Materials in a Vertical
Tube Furnace at 750C shall also be considered non-combustible materials.
Read and understand the manual provided with your bioethanol burner for safe use!
We reserve the right
Products and sizes mentioned in this manual may have been changed or updated subsequently and may therefore
differ from the actual product. In addition, products may be discontinued or unavailable.
ENGLISH

4
Burner specications
Item number Model Capacity
Litre
Width
(mm)
Debth
(mm)
Height
(mm)
Width*
(mm)
Debth*
(mm)
Min. room size
(Cubic metre)
BIO402 Premium Burner 24 cm 1.5 L 240 155 73 223 135 45
BIO399 Premium Burner 26 cm 2.0 L 260 155 73 243 135 50
BIO316 Superior Burner 45 cm 2.5 L 450 160 80 425 135 60
BIO324 Superior Burner 60 cm 3.5 L 600 160 80 575 135 70
BIO317 Superior Burner 80 cm 4.0 L 800 160 80 775 135 80
BIO339 Superior Burner 90 cm 4.5 L 900 160 80 875 135 85
BIO322 Superior Burner 100 cm 5.0 L 1000 160 80 975 135 90
BIO323 Superior Burner 120 cm 6.0 L 1200 160 80 1170 135 100
BIO374 Slimline Burner 40 cm 2.0 L 400 80 103 370 70 50
BIO375 Slimline Burner 60 cm 3.0 L 600 80 103 570 70 60
BIO376 Slimline Burner 80 cm 4.0 L 800 80 103 770 70 75
BIO388 Slimline Burner 100 cm 5.0 L 1000 80 103 970 70 85
BIO398 Slimline Burner 120 cm 6.0 L 1200 80 103 1170 70 110
*Cutout dimensions
Drawing can deviate from the actual burner design.
W2
W1
D2
D1
H
3 mm

5
Cutout instructions
The burners are equipped with a lip around the top of the replace. When the burner is installed in your replace this
lip is used to keep the burner in place and not fall through the cutout.
The cutout dimensions you need to make in the bottom of your surround needs to be larger than the cutout
dimensions - but smaller than the lip size.
For the burner to sit completely ush with the bottom of the replace you can choose to mill out a small recess
matching the size of the lip.
Instruction for building in a bioethanol burner
• The recess and surroundings should be made of a re-resistant material.
• Keep a safety distance of 1000mm (1 meter) to ammable materials around the ame.
• Keep an open space above the burner of minimum 400 mm – recommended 500 mm (Size A in the illustra-
tions).
• If a television is placed directly above the burner, please follow the instructions in the following illustrations.
• Always ask your TV supplier whether your TV is suitable for hanging above a replace.
TV installation option 1
Installation of the bioethanol
burner underneath a TV with a
small shelf to protect the TV
from any direct heat.
C
B
A
B
C
0-50 mm Min 1110 mm
51-100 mm Min 1000 mm
≥101mm Min 900 mm
A
Minimum 400 mm
Recommended 500 mm
How to use the table
“If B is x, then C should be”

6
TV installation option 2
Installation of the bioethanol
burner underneath a TV with a
recess into the wall to protect
the TV from any direct heat.
C
B
A
B
C
0-50 mm Min 1110 mm
51-100 mm Min 1000 mm
≥101mm Min 900 mm
A
Minimum 400 mm
Recommended 500 mm
B
A
A
Minimum 400 mm
Recommended 500 mm
B
Minimum 1100 mm
TV installation option 3
Installation of the bioethanol
burner underneath a television
without any protection of
the TV but with extra safety
distance.
This solution is usually not
recommended to use without
consulting the manufacturer of
the TV.
How to use the table
“If B is x, then C should be”

7
TV installation option 4
Installation of the bioethanol
burner directly underneath the
TV without anything to deect
the heat from rising up into the
TV is never recommended.
Please don’t do this. High
risk of doing damage to the
T V.
Using a built-in prole
For some burner models, we offer a built-in prole that can be used when installing the burner on a ammable
surface. The built-in prole is made of a 3 mm thick steel plate and makes sure that there is no direct contact
between the bioethanol burner and the surrounding.
The built-in prole is available for the following burners:
• BIO316 - Superior Manual Burner 45 cm
• BIO324 - Superior Manual Burner 60 cm
• BIO317 - Superior Manual Burner 80 cm
• BIO322 - Superior Manual Burner 100 cm
The opening underneath the built-in prole needs to be a minimum of 5 mm smaller than the size of the prole plate.
Ideally, the built-in prole is to be milled into the top panel of your design to make a seamless and ush nish. If
desired, this can be glued with heat-resistant adhesive.
Remember to keep enough distance around the built-in prole to avoid that heat from the burner will damage any
surroundings.
For a more detailed built-in prole installation instruction please check the installation guide included with the built-in
proles.
Drawing can deviate from the actual built-in prole

8
DEUTSCH
Sicherheit zuerst!
Empfohlene Baumaterialien
Wichtig
Ein Bioethanol Kamin kann die Lösung sein, wenn Sie die gemütliche Atmosphäre eines echten Feuers wünschen,
aber keine Möglichkeit haben, einen Schornstein zu bauen oder anzuschließen.
Bei der Verbrennung von Bioethanol entsteht CO2 (Kohlendioxid). In großen Mengen kann CO2 gesundheitss-
chädlich sein, daher sollten Sie die Anforderungen an die Mindestraumgröße für die verschiedenen Brenner
beachten. Mehr dazu auf den folgenden Seiten.
Alle unsere manuellen Bioethanol Brenner sind mit einem Keramikschwamm ausgestattet, der die Flüssigkeit aufn-
immt und dafür sorgt, dass das Bioethanol bei einem Umkippen im Brenner verbleibt.
Beim Bau Ihrer Umgebung für Ihren Bioethanol Kamin empfehlen wir die Verwendung der folgenden Baumaterialien
oder ähnlicher hitze- und feuerbeständiger Materialien für alle Teile der Konstruktion, die in direktem Kontakt mit
dem Brenner stehen oder den Flammen ausgesetzt sind:
• Promafour© Platten
• Promatect© Platten
• Superisol© Platten
• Promaglaf© Isolierung
• Insulfrax©-Isolierung
• SkamoEnclosure© Platten
• HardieBacker© Platten
• WonderBoard © Platten
Materialien, die getestet wurden und ASTME E 136 bestanden haben, was ein Standardtestverfahren für das Verh-
alten von Materialien in einem vertikalen Röhrenofen bei 750 Grad ist, können als feuerfest betrachtet werden und
können als Alternativen zu den oben genannten empfohlen werden.
Lesen und verstehen Sie die Bedienungsanleitung, die mit Ihrem Brenner geliefert wird, um eine sichere und korrekte
Verwendung zu gewährleisten!
Wir behalten uns das Recht vor
In diesem Handbuch erwähnte Produkte und Größen können später geändert oder aktualisiert worden sein und
können daher vom tatsächlichen Produkt abweichen. Darüber hinaus können es sich um ausgelaufene Produkte
handelt oder Produkte können nicht verfügbar sein.

9
Brenner Spezikationen
Artikelnummer Modell Kapazität
(Liter)
Länge
(mm)
Tiefe
(mm)
Höhe
(mm)
Länge*
(mm)
Tiefe*
(mm)
Mindestraum-
größe (Kubik-
meter)
BIO402 Premium Brenner 24 cm 1.5 L 240 155 73 223 135 45
BIO399 Premium Brenner 26 cm 2.0 L 260 155 73 243 135 50
BIO316 Superior Brenner 45 cm 2.5 L 450 160 80 425 135 60
BIO324 Superior Brenner 60 cm 3.5 L 600 160 80 575 135 70
BIO317 Superior Brenner 80 cm 4.0 L 800 160 80 775 135 80
BIO339 Superior Brenner 90 cm 4.5 L 900 160 80 875 135 85
BIO322 Superior Brenner 100 cm 5.0 L 1000 160 80 975 135 90
BIO323 Superior Brenner 120 cm 6.0 L 1200 160 80 1170 135 100
BIO374 Slimline Brenner 40 cm 2.0 L 400 80 103 370 70 50
BIO375 Slimline Brenner 60 cm 3.0 L 600 80 103 570 70 60
BIO376 Slimline Brenner 80 cm 4.0 L 800 80 103 770 70 75
BIO388 Slimline Brenner 100 cm 5.0 L 1000 80 103 970 70 85
BIO398 Slimline Brenner 120 cm 6.0 L 1200 80 103 1170 70 110
*Cutout dimensions
Die Zeichnung kann vom tatsächlichen Brennerdesign abweichen
W2
W1
D2
D1
H
3 mm

10
Schnitzanleitung
Die Brenner sind oben am Brenner mit einem Rand ausgestattet. Sobald der Brenner in Ihrem Kamin installiert ist,
wird dieser Rand verwendet, um sicherzustellen, dass der Brenner nicht durch den Ausschnitt fällt.
Die Ausschnittmaße, die Sie an der Boden Ihres Kaminrahmens ausschnitten müssen, müssen größer als die
Loch-Maße sein - aber kleiner als die Rand-Maße sein.
Wenn Sie möchten, dass der Brenner auf der gleichen Höhe wie der Boden des Kamins ist, können Sie vorteilhafter-
weise einen kleinen Ausschnitt fräsen, die der Größe und Dicke des Randes entspricht.
Anleitung zum Einbau von Brennern
• Loch und Umgebung (der Kaminrahmen) sollten aus feuerfesten Materialien bestehen.
• Halten Sie einen Sicherheitsabstand von 1000 mm (1 Meter) zu brennbaren Materialien ein.
• Halten Sie über dem Brenner einen Bereich von mindestens 400 mm frei - empfohlen 500 mm. (Größe A in den
Abbildungen)
• Wenn sich über dem Kamin ein Fernseher bendet, befolgen Sie bitte die Anweisungen in den folgenden
Abbildungen.
• Fragen Sie immer Ihren TV-Anbieter, ob Ihr Fernseher zum Aufhängen über einem Kamin geeignet ist.
TV-Installation #1
Installation eines Bioethanol
Brenners unter einem Fern-
seher mit einem kleinen Regal,
das den Fernseher vor direkter
Hitze schützt.
C
B
A
B
C
0-50 mm Min 1110 mm
51-100 mm Min 1000 mm
≥101mm Min 900 mm
A
Minimum 400 mm
Empfohlen 500 mm
So lesen Sie die Tabelle
“Wenn B x ist, dann muss C x sein”
Ce manuel convient aux modèles suivants
25
Table des matières
Langues :


















