Caberg JUST SPEAK EVO Manuel utilisateur
1.
2.
3.
4.
Remove the cheekpads as
indicated in the communicator’s
instruction manual.
Placetherightspeaker(R)inits
seatafterapplyingthe adhesive
round shapedVelcroincluded
inthepackage.
Repeat the operations performed
for the right (R) speaker for
positioning the left (L).
Pass the flat cable of the remote
control between the neckroll’s pp
plate and the shell. The remote
control must remain accessible
outside the helmet.
ASSEMBLY
INSTRUCTION
7.
8.
6.
5.
Position the microphone
underneath the chinstrap by
housing the boom in its seat.
Adjust the microphone’s position
by deforming its boom.
WARNING: check that the triangle
on the microphone is facing the
mouth.
House the cable that connects the
right speaker to the left between
the rear cushion and the neckroll.
Assemble the cheekpads. Place
the USB socket between the
cheekpad and the neckroll.
ASSEMBLY
INSTRUCTION
9.
Stick the remote control on the
side of the shell verifying the
correct adhesion.
ASSEMBLY
INSTRUCTION
Autres manuels pour JUST SPEAK EVO
8
Table des matières
Autres manuels Caberg casque
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
Caberg
Caberg JUST SPEAK EVO Manuel utilisateur
