Burkert GENERIC 8400 Manuel utilisateur

INTERNAL

USE ONLY

Introduction

The generic 8400 controller is delivered without a temperature measuring device. It is up to you:

- to mount the desired 2-wire Pt100 onto the controller

- to calibrate the controller once the Pt100 has been mounted.

Technical data:

- connection interface for the Pt100: G1/2’’, external thread.

- connection wires of the Pt100: 26 AWG multi-conductor, PTFE jacket

- connector between the Pt100 wires and the electronic board: Molex® 90327-3304

- Pt100 : 2 wires; max. cable length = 1 m.

Mounting the sensor onto the controller

L = 14,5 mm

G 1/2'' external thread

MOUNTING INSTRUCTIONS

GENERIC 8400

3 4

Unscrew to lift the cover

- Molex®90327-3304 connector

(order code 448850) (not

delivered);

Use the Molex®69008-0910

hand tool for the crimping (not

delivered)

- or Molex®connector mounted

on cable (order code 440258)

(not delivered) ; In this case, only

connect conductors N°1 and 3 to

the two wires of the Pt100 sensor.

A: Pass the connector and cable

through the G1/2’’ connection

B: Screw the sensor on the 8400

Connect the Molex®connector

to the 4-pin connector of the

electronic board

Place the cover back and screw the 4

screws in an alternating pattern at a torque

rating of 0.4 Nm to ensure the tightness

Gasket

Generic 8400

Calibrate the controller

Once the Pt100 has been mounted onto the 8400 controller:

- plunge the Pt100 into a vessel filled with water: read out the temperature indicated by the

display of the controller.

- measure the real temperature of the water inside the vessel using a thermometer and note it

down.

- Enter the Calibration mode of the controller.

- Select the T°-menu, validate and enter the difference between the real temperature and the

temperature measured by the 8400, i.e. 24.4 - 24.2 = 0.2 in the example above.

- Measure again the temperature of the water inside the vessel using the 8400 and check it

displays 24.4 °C

Available accessory

END

ENTER

0......9

T°

000.2

°C

ENTER

0......9

ENTER

> 5s

Water

Readout = 24.2 ˚C

Real temperature = 24.4 ˚C

448849-Ind*1/Feb02

Subject to technical change without notice

* To enter a negative value, select the character at

the left hand side of the display and press

until the minus sign appears.

0......9

Designation Order code

Bag with 20 Molex®connectors 448850

Bag with 20 Molex®connectors mounted on cable 440258

Autres manuels pour GENERIC 8400

Table des matières

Autres manuels Burkert Accessoires

Burkert

Burkert 8741 Manuel utilisateur

Burkert

Burkert 2509 Manuel utilisateur

Burkert

Burkert MS05 Manuel utilisateur

Burkert

Burkert 8045 Manuel utilisateur

Burkert

Burkert 8007 Manuel utilisateur

Burkert

Burkert 2510 Manuel utilisateur

Burkert

Burkert MS09 Manuel utilisateur

Burkert

Burkert 8020 Manuel utilisateur

Burkert

Burkert 8694 Manuel utilisateur

Burkert

Burkert S030 Manuel utilisateur

Burkert

Burkert 8030 HT Manuel utilisateur

Burkert

Burkert 8030 Manuel utilisateur

Burkert

Burkert S070 Manuel utilisateur

Burkert

Burkert 8798 Manuel utilisateur

Burkert

Burkert 8223 Manuel utilisateur

Burkert

Burkert 8020 Manuel utilisateur

Burkert

Burkert Type MS01 Manuel utilisateur

Burkert

Burkert 8020 Low Power Instructions d'installation et d'utilisation

Burkert

Burkert 8170 Manuel utilisateur

Burkert

Burkert 8220 Manuel utilisateur

Burkert

Burkert FULLBORE S056 Manuel utilisateur

Burkert

Burkert SE30 Ex Namur Manuel utilisateur

Burkert

Burkert GENERIC 8400 Manuel utilisateur

Burkert

Burkert 8020 Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur