Bunker Hill Security 56330 Instructions de montage
Visit our website at: http://www.harborfreight.com
Email our technical support at: [email protected]
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference. 19f
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright© 2019 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product
described herein. Tools required for assembly and service may not be included.
Read this material before using this
product. Failure to do so can result in
serious injury. SAVE THIS MANUAL.
Page 2 For technical questions, please call 1-888-866-5797. Item 56330 56252
Table of Contents
Important Safety Information ...................... 2
Specifications ............................................. 4
Setup .......................................................... 4
Operation .................................................... 5
Maintenance and Servicing ........................ 6
Warranty ..................................................... 8
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that
follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
1. Keep installation area clean.
Cluttered areas invite accidents.
2. Observe installation area conditions.
Keep work area well lit during installation.
3. Check for damaged parts.
Before using any product, any part that appears
damaged should be carefully checked to determine
that it will operate properly and perform its intended
function. Check for any broken or damaged
parts and any other conditions that may affect its
operation. Replace or repair damaged or worn
parts immediately. Do not use the Security Light
if any switch does not turn on and off properly.
4. Replacement parts and accessories.
When servicing, use only identical replacement
parts.
Use of any other parts will void the warranty.
5. Check hardware and assembled parts
after assembling. All connections should
be tight and hardware tightened.
6. Keep children away. Mount the
Light out of children’s reach.
SAFETY OPERATION MAINTENANCESETUP
Page 3For technical questions, please call 1-888-866-5797.Item 56330 56252
7. Dress properly. Protective, electrically
non-conductive clothes and nonskid
footwear are recommended when working
with the Solar Powered Security Light.
Wear restrictive hair covering to contain long hair.
8. Use eye protection. Wear ANSI-approved impact
safety goggles when setting up this product.
9. Maintain products with care. Keep the
Solar Powered Security Light clean for
better and safer performance. Inspect
the Light periodically. If damaged, have
it repaired by a qualified technician.
10. Do not overreach. Keep proper footing and
balance at all times. If a ladder is to be used during
installation, it should be supported by an assistant.
11. Do not set up the Solar Powered Security Light
if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your
judgement or reflexes are impaired while taking
drugs. If there is any doubt, do not set up the Light.
12. Have your product serviced by a qualified
repair person using only identical
replacement parts. This will ensure that
the safety of the product is maintained.
13. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
14. Contains Li-Ion battery. Battery must be
recycled or disposed of properly. Do not open,
crush, heat above 140°F or incinerate.
SAVE THESE INSTRUCTIONS.
SAFETYOPERATIONMAINTENANCE SETUP
Page 4 For technical questions, please call 1-888-866-5797. Item 56330 56252
Specifications
Battery Rating 3.7V / 1200mAh
Battery Type Li-ion
Delay Time 30 Seconds
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 4.
Installation
1. Decide where you want to mount the Light.
Set the Light in a location that receives full,
direct sunlight, a minimum of eight hours a day.
2. Peel sticker off the back of the Light and place
on a solid surface capable of supporting the
unit and secure enough so that it will not
move when exposed to vibrations or wind.
Note: The Light must be high enough to allow
for motion detection and light distribution.
Initial Battery Charging
Before the Security Light can operate properly, the
battery needs to be fully charged. To charge the battery:
1. Turn OFF the Power Switch.
The battery will recharge without turning on
the light while the Power Switch is off.
2. Allow the battery to charge for
3 days of full sunlight.
Functions
Adhesive
Strip
Solar
Panel
Motion
Sensor
LED
Lamps
Power Switch
(not shown)
SAFETY OPERATION MAINTENANCESETUP
Page 5For technical questions, please call 1-888-866-5797.Item 56330 56252
Operation
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
1. Turn ON the Power Switch to activate
the Solar Security Light.
2. Test the Light by walking or driving
into the protected area.
3. The Light should brighten at full power for 30
seconds when motion is detected and then
stay lit at low power after 30 seconds.
4. If the Light does not brighten, relocation, aiming
adjustment, or more charging time will be required.
SAFETYOPERATIONMAINTENANCE SETUP
Page 6 For technical questions, please call 1-888-866-5797. Item 56330 56252
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Battery Removal and Disposal
1. The battery is located inside the Light assembly.
2. Turn the Light off and remove the
four screws on the back.
3. Disconnect the battery and remove it from the Light.
4. Contains Li-Ion battery. Battery must be
recycled or disposed of properly. Do not open,
crush, heat above 140°F or incinerate.
SAFETY OPERATION MAINTENANCESETUP
Page 7For technical questions, please call 1-888-866-5797.Item 56330 56252
Troubleshooting
Problem Possible Causes Likely Solutions
Light won’t
turn on.
1. Power is not on.
2. Battery not fully charged.
1. Check that Power Switch is set to ON.
2. Keep solar panel clean. Allow to charge in full
sunlight for 3 days with the Power Switch OFF.
Light turns on
during day.
Light is positioned in
a dark location.
Move light to a location that is lit during the day.
Light flashes
on and off with
clicking sounds.
Low battery. With Switch set to “OFF”, allow to charge in full
sunlight for 3 days before further use.
Light stays
bright.
Frequent changes in
heat being detected.
Check sensing area for possible heat sources
such as air vents, vehicles or objects in wind.
Reposition the Motion Detector Light if needed.
Light brightens
and darkens
continuously.
1. Changes in heat are being
detected from a fixed heat
source or moving object.
2. Sudden temperature change
due to storms or high winds.
1. Check sensing area for possible heat sources
such as air vents, vehicles or objects in wind.
Reposition the Motion Detector Light.
2. Turn Power Switch “OFF” until storm
passes. Mount in a sheltered location.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually
as replacement parts. Parts may not be interchangeable. Specify item number when ordering.
SAFETYOPERATIONMAINTENANCE SETUP
26541 Agoura Road • Calabasas, CA 91302 • 1-888-866-5797
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality
and durability standards, and warrants to the original purchaser that this product is free from
defects in materials and workmanship for the period of 90 days from the date of purchase. This
warranty does not apply to damage due directly or indirectly, to misuse, abuse, negligence or
accidents, repairs or alterations outside our facilities, criminal activity, improper installation,
normal wear and tear, or to lack of maintenance. We shall in no event be liable for death,
injuries to persons or property, or for incidental, contingent, special or consequential damages
arising from the use of our product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation of exclusion may not apply to
you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with
transportation charges prepaid. Proof of purchase date and an explanation of the complaint
must accompany the merchandise. If our inspection verifies the defect, we will either repair or
replace the product at our election or we may elect to refund the purchase price if we cannot
readily and quickly provide you with a replacement. We will return repaired products at our
expense, but if we determine there is no defect, or that the defect resulted from causes not
within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also
have other rights which vary from state to state.
Autres manuels pour 56330
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Bunker Hill Security Projecteur
Bunker Hill Security
Bunker Hill Security 64759 Instructions de montage
Bunker Hill Security
Bunker Hill Security 98085 Manuel de la liste des pièces
Bunker Hill Security
Bunker Hill Security LED-SOLAR Instructions de montage
Bunker Hill Security
Bunker Hill Security 94747 Manuel d'installation
Bunker Hill Security
Bunker Hill Security Bunker Hill Security 69644 Instructions de montage
Bunker Hill Security
Bunker Hill Security 64910 Instructions de montage
Bunker Hill Security
Bunker Hill Security 69643 Manuel utilisateur
Manuels Projecteur populaires d'autres marques
VIZULO
VIZULO Micro Martin Guide de l'utilisateur
EuroLite
EuroLite LED IP FL-100 SMD Manuel utilisateur
Cooper Wheelock
Cooper Wheelock XB12 Manuel utilisateur
Allen + Roth
Allen + Roth 17624-000 Manuel utilisateur
ADJ
ADJ 4 STAGE PAK Manuel utilisateur
Cooper Lighting
Cooper Lighting EGL91SW233 Manuel utilisateur
