Page 5of 13
7. To avoid condensation after operating the power supply in a cold room, wrap the unit in a
plastic bag and allow at least 2 hours for the unit to equilibrate to room temperature before
removing the bag and operating the unit.
8. Prior to applying any cleaning or decontamination methods other than manufacturer’s
recommendation, users should check with the manufacturer’s instruction to see if the proposed
method will damage the equipment.
Equipment Operation
Follow the guidelines below to ensure safe operation of the unit:
1. NEVER access dangerous chemicals or other materials to prevent possible hazard of explosion
and damage.
2. Do not operate the unit without lids or covers to prevent possible hazards.
3. A temporary conductivity caused by condensation might occur even though this series is rated
Pollution Degree 2 in accordance with IEC 664.
Symbol
Symbols used on the power supply are explained below.
Indicates an area where a potential shock hazard may exist.
Consult the manual to avoid possible personal injury or instrument damage.
Indicates disposal instruction.
DO NOT throw this unit into a municipal trash bin when this unit has reached the end of its
lifetime. To ensure utmost protection of the global environment and minimize pollution,
please recycle this unit.
Max. current: 400 mA
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010-1,
second edition, including Amendment 1, or a later version of the same standard
incorporating the same level of testing requirements
THIS LIMITED WARRANTY SHALL NOT APPLY IF THE DEFECT WAS CAUSED THROUGH ANY OF THE
FOLLOWING
1. The Product serial number or the accessory date code has been removed, erased, defaced,
altered or is illegible; or
2. The defect is resulting from the use of the product in a manner other than their normal and
customary manner, e.g., in excess of their minimum specification or operating instructions, or
malfunction or failure resulting from use of incorrect voltages; or
3. Deterioration of the Product due to normal wear and tear. All plastic surfaces and other natural
wear of externally exposed parts of the product are scratched or damaged under normal usage
(including casing, key pad, display and accessories, etc.); or
4. The defect is arising from improper installation, unauthorized repair, alteration or modification
to this product by third parties other than MS or its designee; or
